7
Note: After entering into the tracking mode, be sure to remember to set the exit tracking
mode after use. Otherwise, the battery will run out of power soon due to frequent upload
of data.
MT06 three-year working requirements
1、Equipment is not prohibited to use the instructions, unauthorized disassembly, collision,
charging, soaked, more than 80 degrees, man-made faults, force majeure damage, etc., or the resulting
short circuit, working hours, battery deformation, leakage, explosion and so on and Associated
losses, without warranty and compensation；
2、Equipment working time: 1095 days; upload data: 1095; upload time interval of 24 hours / strip,
working temperature: -20 degrees to 60 degrees。
3、Three years in which the device is located in the GPS blind time is not higher than 250 days;
GSM dead zone time is not higher than 50 days.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interf
erence that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compli
ance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a resident
ial installation. This equipment generates uses and can radiate radio frequency ene
rgy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determi
ned by turning the equipment off and on, the user is encouraged to try to corre
ct the interference by one or more of the following measures:
‐Reorient or relocate the receiving antenna.
‐Reorient or relocate the receiving antenna.
‐Reorient or relocate the receiving antenna.
