Table of contents
ASD 535, Mounting and installation, T 140 333 d en 5 / 40
Table of contents
_________________________________________________________________________________________
1General information 7
1.1 Purpose 7
1.2 Safety and the environment 8
1.2.1 Notice and warning symbols 8
1.2.2 Safety information 8
1.2.3 Disposal 9
1.3 Abbreviations and terms 9
_________________________________________________________________________________________
2Mounting 11
2.1 Mounting guidelines 11
2.2 Dimensioned drawing / drilling plan for detector housing 11
2.3 Material for the sampling pipe 12
2.4 Mounting the detector housing 13
2.4.1 Opening and closing the detector housing 14
2.4.2 Mounting positions of the detector housing 15
2.4.3 Removal of the air outlet pipe plug 16
2.4.4 Turning the labelling strips 16
2.5 Mounting sampling pipe 17
2.5.1 General information 17
2.5.2 Mounting with PVC tubes and fittings 17
2.5.3 Mounting with ABS tubes and fittings 17
2.5.4 Mounting with metal pipes and fittings 18
2.5.5 Linear expansion 18
2.5.6 Mounting the sampling pipe 19
2.5.7 Mounting for equipment monitoring 20
2.5.7.1 Screw-free fastening of the sampling pipe 20
2.5.7.2 Transition to flexible tube 21
2.5.8 Making the sampling holes 22
2.5.9 Mounting maintenance and sampling hole clips 22
2.5.10 Mounting the sampling funnel 22
2.5.11 Mounting sampling stubs for the ceiling duct 23
2.5.12 Mounting filter box, filter unit, dust trap, dust separator, water separator 24
_________________________________________________________________________________________
3Installation 25
3.1 Regulations 25
3.2 Cable entry 25
3.3 Deploying smoke sensors 26
3.4 Installing expansion modules XLM 35, SLM 35, RIM 35, MCM 35, SIM 35 27
3.5 Electrical connection 28
3.5.1 Terminal assignment of AMB 35 Main Board 29
3.5.2 eXtended Line Module XLM 35 / SecuriLine module SLM 35 terminal assignment 30
3.5.3 Relay interface module RIM 35 terminal assignment 30
3.5.4 Terminal assignment of an SIM 35 serial interface module 30
3.6 Connection variants 31
3.6.1 Power supply 31
3.6.2 Reset input 31
3.6.3 Control 32
3.6.3.1 Control via supply voltage by means of auxiliary relay 32
3.6.3.2 Control via the “Reset external” input 33
3.6.4 Wiring the FACP line 34
3.6.4.1 Circuitry on zone detection via Al / St relay 34
3.6.4.2 Circuitry on selective identification or addressable loop via Al / St relay 35
3.6.4.3 Circuitry on SecuriPro / SecuriFire / Integral addressable loop from XLM 35 / SLM 35 35
3.6.5 Open collector outputs 36
