Visit www.securviewcctv.com for support
Must Read Information for Installers
1.3.5
First time GPS positioning - Tricks to make positioning quicker
GPS positioning for the first time takes a bit longer time when the device is installed. It may take about 5-10 minutes. Follow
the steps below to initialize the GPS for quicker positioning:
1) Switch ON the engine.
2) Wait until the Red, Green and Blue LEDs on the device all stays on steadily (no flashing), that’s mean the GPS and
mobile signal are ready.
3) Turn OFF the engine and wait for 5 seconds.
4) Switch ON the engine again.
5) The new position should be updated when all LEDs are all on steadily.
Note: If the power of the device is disconnected and the device is moved to another new location when the device is off,
always do the initialization steps above.
1.3.6
Choosing the right mobile phone card
1) Must use Micro SIM or Nano SIM with Micro SIM adaptor.
2) Must use 4G SIM cards (4G+3G). Don’t use 3G SIM cards (3G+2G).
3) Must have data, voice, and SMS capabilities.
4) Must be able to monitor the usage, check the balance and recharge remotely by App or web site.
1.3.7
Car status update
All driving data and car status are uploaded to the web server, there is some delay between the car status on the web
server and real situation. For example, when the car switches its engine ON/OFF, its on/off status will be updated on the
web server within 3 minutes.
1.3.8
Vibration sensor sensitive
Vibration is inevitable during driving. For example, poor road conditions, humps and unintended shock on the device itself...
If the Vibration Alert triggers frequently, you may adjust the sensitivity of the vibration sensor on the App. If this features is
not need, you can also turn it off.
To enable/disable vibration alert, select “Vibration Alert” in Setting menu.
To adjust vibration sensitivity:
Click the Device List and
select the vehicle to set.
Then click “Setting”.
Select “Vibration Albert”
Slide the slide bar to adjust
and click “Save” when finish.
1.3.9
SOS button
SOS button will activate only if the button is pressed and held down for more than 3 seconds. Must enable SOS in
“Setting” menu.
