Seagull Models Decathlon 60-85cc-3D Manual de usuario

Specications:

Wingspan--------------- 122.0 in (310.0 cm).

Wing area--------------- 2487.8 sq.ins (160.5 sq.dm).

Weight------------------- 26.4-27.4 lbs (12.5-13.0kg).

Length------------------- 84.6 in (215.0 cm).

Engine/Motor size----- 60-85cc gasoline.

Radio--------------------- 7 channels with 9 servos.

ASSEMBLY MANUAL

Code : SEA 314

DECATHLON 60-85cc-3D Instruction Manual.

ank you for choosing the DECATHLON 60-85cc-3D ARTF by SG MODELS . e

DECATHLON 60-85cc-3D was designed with the intermediate/advanced sport y-

er in mind. It is a semi scale airplane which is easy to y and quick to assemble. e air-

frame is conventionally built using balsa, plywood to make it stronger than the av-

erage ARTF, yet the design allows the aeroplane to be kept light. You will nd that

most of the work has been done for you already. e motor mount has been tted and

the hinges are pre-installed. Flying the DECATHLON 60-85cc-3D is simply a joy.

is instruction manual is designed to help you build a great ying aeroplane. Please read

this manual throughly before starting assembly of your DECATHLON 60-85cc-3D Use the

parts listing below to indentify all parts.

Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is ca-

pable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU

ASSUME ALL RISK & REPONSIBILITY.

If you are inexperienced with basic R/C ight we strongly recommend you contact your R/C

supplier and join your local R/C model Flying Club. R/C Model Flying Clubs oer a variety

of training procedures designed to help the new pilot on his way to successful R/C ight.

ey will also be able to advise on any insurance and safety regulations that may apply.

INTRODUCTION

WARNING

KIT CONTENTS

SEA314 DECATHLON 60-85cc-3D

1. Fuselage

2. Wing set (2)

3. Tail set (2)

4. Canopy

5. Cowling

6. Wing tube

7. Pilot

8. landing gear

9. Fuel tank

10. Tail wheel

11. Pushrod set

12. Ep Motor box

ADDITIONAL ITEMS REQUIRED

TOOLS & SUPPLIES NEEDED

in cyanoacrylate glue.

Medium cyanoacrylate glue.

30 minute epoxy.

5 minute epoxy.

Hand or electric drill.

Assorted drill bits.

Modelling knife.

Straight edge ruler.

2mm ball driver.

Phillips head screwdriver.

220 grit sandpaper.

90° square or builder’s triangle.

Wire cutters.

Masking tape & T-pins.

read-lock.

Paper towels.

�60-85cc gasoline engine.

�Computer radio 7 channel with 9

servos.

�Glow plug to suit engine.

�Propeller to suit engine.

�Protective foam rubber for radio

system.

WINGTIP BULBS

Please see below pictures.

Two white lights for cowling and rud-

der, the green light for right wing tip, and

the red light for le wing tip. ey are

designed to operate on voltages 12 volts.

Connect four lights into switch circuit so

that optional the dierent ashes mode.

DECATHLON 60-85cc-3D Instruction Manual.

10.

11.

12.

13.

14.

15.

17.

16.

18.

19.

DECATHLON 60-85cc-3D Instruction Manual.

20.

21.

22.

23.

INSTALL THE AILERONS

CONTROL HORN

Fiberglass control horn

Epoxy.

24.

Because the size of servos dier, you

may need to adjust the size of the precut

opening in the mount. e notch in the

sides of the mount allow the servo lead to

pass through.

Place the servo between the mounting

blocks and space it from the hatch. Use

a pencil to mark the mounting hole loca-

tions on the blocks.

INSTALLING THE AILERON SERVOS

Use drill bit in a pin vise to drill the mout-

ing holes in the blocks.

Apply 2-3 drops of thin C/A to each of

the mounting holes. Allow the C/A to

cure without using accelerator.

1.5mm

Minimum servo spec.

Torque : 250 oz-in (18 kg-cm) @ 4.8V;

333 oz-in (24 kg-cm) @ 6.0V

Ailerons control horn

Epoxy.

40mm

C/A glue

DECATHLON 60-85cc-3D Instruction Manual.

Apply 1-2 drops of thin C/A to each of

the mounting tabs. Allow the C/A to cure

without using accelerator.

Remove the string from the wing at the

servo location and use the tape to attach

it to the servo extension lead. Pull the lead

through the wing and remove the string.

C/A glue

10.

11.

Set the aileron hatch in place and use a

Phillips screw driver to install it with four

wood screws.

12.

13.

Secure the servo to the aileron hatch us-

ing Phillips screwdriver and the screws

provided with the servo.

Use dental oss or heatshrunk tube to

secure the connection so they cannot be-

come unplugged.

3x10mm

14.

AILERON PUSHROD INSTALLATION

INSTALLING THE FLAP PUSHROD

15.

Attach the ap servo to the ap servo

cover. Center the ap servo (or set the

values to 0 for both up and down) and in-

stall the servo arm perpendicular to the

servo centerline. e clevis will attach to

the arm 13/16 inches (21mm) from the

center of the arm.

150mm.

130mm.

DECATHLON 60-85cc-3D Instruction Manual.

Use a pin vise and 3/32-inch (2mm) drill

bit to clear the paint from the ap control

horn.

Attach the ap linkage to the control

horn. Slide the clevis retainer over the

forks of the clevis.

Route the servo lead for the ap servo out

at the root of the wing. Connect the ap

servo to the radio system. With the radio

system on, place the ap servo into posi-

tion.

Attach the clevis to the ap servo arm.

Adjust the linkage so the ap is in the

mid-ap position. It may take a few tries

to properly adjust the linkage.

Once adjusted, make sure all clevis re-

tainers are in position. Apply a drop of

threadlock near the clevis, then tighten

the nut against the clevis to keep the link-

age from changing length inside the wing.

Tabla de contenidos

Otros manuales de Juguete de Seagull Models

Seagull Models

Seagull Models Super Decathlon ARF 120 Manual de usuario

Seagull Models

Seagull Models ZERO FIGHTER Manual de usuario

Seagull Models

Seagull Models SEA 358 Manual de usuario

Seagull Models

Seagull Models CESSNA 188 AGWAGON Manual de usuario

Seagull Models

Seagull Models T-34C MENTOR Manual de usuario

Seagull Models

Seagull Models Magic Star 3D EP Manual de usuario

Seagull Models

Seagull Models Van's RV-8 Manual de usuario

Seagull Models

Seagull Models EDGE 540 EP Manual de usuario

Seagull Models

Seagull Models Mini Sparrowhawk EP Manual de usuario

Seagull Models

Seagull Models SPACE WALKER II Manual de usuario

Seagull Models

Seagull Models SEA230B Manual de usuario

Seagull Models

Seagull Models Sparrow Hawk SEA-93 Manual de usuario

Seagull Models

Seagull Models DUAL ACE Manual de usuario

Seagull Models

Seagull Models GEEBEE ARTF Manual de usuario

Seagull Models

Seagull Models JUNKERS CL1 G-BUYU Manual de usuario

Seagull Models

Seagull Models Swift 40 Manual de usuario

Seagull Models

Seagull Models A6M Zero Fighter 67 Manual de usuario

Seagull Models

Seagull Models FOCKE-WULF FW190 Manual de usuario

Seagull Models

Seagull Models SEA238 Manual de usuario

Seagull Models

Seagull Models MAXI LIFT 33cc Manual de usuario

Seagull Models

Seagull Models Pilatus PC-6 Porter Manual de usuario

Seagull Models

Seagull Models De Havilland DH-60M Moth 72" wingspan... Manual de usuario

Seagull Models

Seagull Models Super chipmunk Size 55 Manual de usuario

Seagull Models

Seagull Models HARRIER 3D Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario