secondary node, and the maximum distance should not exceed
20 meters.
◼Keep away from interference sources such as microwave ovens,
induction cookers, refrigerators, etc.
◼Higher from the ground and less obstructions around.
②When the power is turned on, the LED indicator is solid red.
After about 80 seconds, the system starts up and the LED indicator
is flashing green.
③Continue to observe the LED indicator until it changes from
flashing green to solid green.
④If the LED indicator is not solid green. Please re-select a
suitable placement position to obtain the best connection quality.
◼Wired device Internet access: please connect to the
WAN/LAN ports of all nodes
◼Wireless device Internet access: Please connect to the
wireless network marked on the sticker at the bottom of all
nodes. By default, the wireless name/password of all nodes
are the same.
LED Indicator status description
After the power is turned on, the LED indicator will be solid red
(about 80 seconds), indicating that the node's system is starting.
After the start is complete, the description of LED indicator’s status
is as follows
Successfully connected to the
Internet
Connecting to the Internet
Connecting to the secondary
node
Successfully connected to
primary node and signal
quality is good
Connecting to primary node
Failed connected to primary
node
Successfully connected to
primary node but signal
quality is bad
FAQ
Q1：The device connected to node cannot access the Internet?
A1：First, observe whether the LED indicator of the primary node is
solid green. If not, please check whether the node's Internet access
mode is set correctly. If it is correct, please contact your network
operator to check whether the home network is normal.
Secondly, observe whether the secondary node is solid green.
If it is not, please change to a more suitable place.
Q2: How to add new node?
A2: Push Primary or Secondary node’s Mesh button, then push the
new node’s Mesh button. If add success, the LED indicators of the
two nodes change from flashing green to solid green.
Q3：How to restore the factory settings of the node?
A3：When the nodes are running, press and hold the reset button of
the primary node with a pointed object for about 5 seconds, and
release it until the LED indicator goes out.
