Note: Once an alarm trigger has occurred and the siren duration is completed the system will remain
armed and accept any additional triggers.
Alarm Triggers
1. If bike is bumped, the siren will sound for 5 Seconds nd the turn sign l lights will fl sh.
2. If the bike is tilted, the siren will sound for 30 seconds nd the turn sign l lights will fl sh.
3. If the ignition switch is turned “on”, the siren will sound for 30 seconds nd the turn sign l
lights will fl sh.
Manual verride Procedure
Programming Personal verride code
A person l override code will be sequence of left – right - left turn sign l fl shes th t c n
be used if the remote is lost to dis ble the l rm:
Enter progr mming Mode
1. M nu lly dis rm system.
2. Turn ignition on – off – on – off – on.
3. Press nd hold the button until the siren chirps 3 times.
Select number of fl shes for Code
The code will be combin tion of left-right-left-right turn sign l count.
1. Turn on left turn sign l to desired number of fl shes. (up to 9)
2. Turn on right turn sign l to desired number of fl shes. (up to 9)
3. Turn on left turn sign l to desired number of fl shes. (up to 9)
4. Turn on right turn sign l once to exit mode. (Will only register one fl sh)
5. The bike will fl sh the code in the s me sequence entered.
*This feature is not compati le with every motorcycle on the market.
*Some ikes are easier than others to program and operate this
feature, make sure to test the code once it is programmed.
Using code in c se of lost remote
1. Turn ignition key to on position. Let l rm go thru full cycle until the turn sign l
lights stop fl shing. (If siren is turned off, you do not need to wait for a full cycle)
2. Enter code s origin lly entered.
3. When correct code is entered the l rm will de ctiv te
8
Perimeter Sensor (SN-5)
Mounting the SN-5
The Perimeter Sensor uses high frequency microw ve technology to detect m ss density
movement round the motorcycle. The sign l c n tr nsmit through the se t, fibergl ss,
le ther nd pl stic, but not met l. It is recommended to pl ce this sensor under the se t
s close s possible to the center of the motorcycle. With the provided Velcro, you c n
mount this sensor on top of the b ttery or ny fl t surf ce, m king sure th t the top side of
the sensor is f cing upw rds.
Adjusting the Sensor
Although the sensor is pre-set from the f ctory, it m y be necess ry to djust the sensitivity
to suit your specific pplic tion.
1. St nd t le st 10’ w y from the motorcycle nd rm the system.
2. W lk tow rds the motorcycle nd try to le n over the top of it. Once the sensor
detects movement, the siren will begin to chirp slowly. If you b ck w y from the
motorcycle, the siren will stop chirping. If you continue to move closer to the
motorcycle, the siren will st rt to chirp f ster nd f ster nd then go into full l rm.
3. Sensitivity c n be djusted by removing the pl stic c p nd tuning the djustment
screw. To incre se sensitivity, turn djustment screw clockwise. To decre se sensitivity,
turn the djustment screw counter clockwise.
4.
The Perimeter sensor h s n intern l tuning control, which h s been set t the f ctory.
This tuning control should only be ch nged if the sensor c n not be properly set s
described in #3 bove, ple se c ll Aritronix’ technic l support.
9
Pl stic C p:
Remove to
