SCION xD 2012 - TVIP V5
Preparation SCION SECURITY
Page 1 of 23 pages
Issue: A 10/18/11
Part Number: PT398-52122
Conflicts
Do not install into vehicles without RKE, or with
Factory Alarm System.
Recommended Sequence of Application
Item # Accessory
1 Navigation
2 V4
3 V5
Kit Contents
Item # Quantity Description
1 1 Wire Harness
Hardware Bag Contents
Item # Quantity Description
1 1 GBS ECU
2 1 V5 ECU
3 1 Status Monitor w/Microphone
4 4 Foam Tape
5 35 Wire Ties
6 2 Window Warning Label
7 1 Owner’s Manual
8 1 Warranty Card
9 8 Butyl
10 2 Large Foam Tape (1= 2 pieces)
Additional Items Required For Installation
Item # Quantity Description
Recommended Tools
Personal & Vehicle
Protection Notes
Safety Glasses
Safety Gloves (Optional)
Vehicle Protection Blankets, Parts Boxes
Special Tools Notes
Striker Tool CAD-E IADS ALL 02-016-01
Installation Tools Notes
Phillips Screwdriver #2 screwdriver or tip
Flat Blade Screwdriver Jeweler’s screwdriver
Nylon Panel Removal
Tool e.g. Panel Pry Tool #1 Toyota
SST # 00002-06001-01
Side Cutters
Torque Wrench 36 in•lbf (4.07 N•m)
Utility Knife
Tape Clear
Socket 10mm, Extension
Special Chemicals Notes
Cleaner VDC Approved Cleaner
Glass Cleaner Household Glass Cleaner
Legend
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:
• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.)
• Safety (eye protection, rechecking torque procedure, etc.)
• Vehicle Disassembly/Reassembly (panel removal, part storage, etc.)
• Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.)
Please see your Scion dealer for a copy of this document
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safet
.
