Schlage B250PD Manual de usuario

*P513-174*

P513-174

B-Series Single Cylinder

Lock

Parts Included

• (2) Keys

• (1) Cylinder

• (1) M\zn”(11 mm) ring &

hardened steel insert

• (1) Z\,”(3 mm) ring &

hardened steel insert

• (1) Driver bar

• (1) Latch

• (2) Mounting screws,

cylinders

• (1) Strike

• (1) Strike dust box

• (1) Strike reinforcer

• (2) 3” (76 mm) mounting

screws, reinforcer

• (4) Mounting screws, latch

and strike

• (1) Thumbturn

Depending on size ordered, may include (2) Z\,”(3 mm) rings and

hardened steel inserts.

NOTE:

Hollow metal doors must be properly reinforced for latch

support. If door reinforcement is not furnished, contact door

manufacturer, or use Schlage reinforcer #37-001 (specify door

thickness)

1 Select rings and inserts.

Use chart to choose rings and inserts for door thickness

adjustment.

Door Thickness 5 Pin Cylinder 6 Pin Cylinder

1C\,”(35 mm) B and A B and (2) A

1C\v”(44 mm) BB and A

A B 5 Pin 6 Pin

Ring Insert Ring Insert 1C\zn”(30 mm) 1B\zn”(33 mm)

5 Pin 6 Pin

1C\,”(35 mm)

door

1C\v”(44 mm)

door

1C\,”(35 mm)

door

1C\v”(44 mm)

door

2 Prepare the door.

2a Mark centerline on door face and edge.

2b Place template on door and drill a 1Z\x”(38 mm)

hole through the door face (from both sides to avoid

damaging wood).

Drill a 1” (25 mm) hole in door edge. Drill C\,” (10 mm) deeper

as illustrated.

C\,”(10 mm) deeper

1” (25 mm) Hole

1Z\x”(38 mm) Hole

3 Install latch.

3a Rotate to adjust latch so that bolt faces door jamb.

3b Insert latch into hole. Line up and trace around

faceplate.

Use chisel to remove wood until the faceplate ts ush when latch

is fully inserted.

Installation InstructionsModel B250PD

Printed in U.S.A.

P513-174 Rev. 01/14-e

3c Install latch with provided screws.

4 Prepare door jamb.

4a Locate exact centerline of latch and mark centerline on

door jamb.

Mark drill points Z\v”(6 mm) above and below horizontal

centerline. Drill two (2) overlapping M\,”(22 mm) holes, ZZ\zn”

(17 mm) deep.

Clean out holes for strike box. Use strike as pattern for

cutout. Use chisel to remove wood Z\v”(6 mm) deep.

4b Mark and drill C\zn”(4 mm) pilot holes for 3” wood

screws.

Install reinforcer, dust box, and strike with provided screws.

5 Install cylinder.

5a Insert driver bar into cylinder.

5b With key removed, insert cylinder into rings (See Step

1) and guide driver bar into slot in latch.

Screw mounting screws from thumbturn through the inside

cylinder and tighten evenly.

Z\v”(6 mm) deep

M\,”(22 mm) Hole

ZZ\zn”(17 mm) deep

Z\v”(6 mm)

Customer Service

1-877-671-7011 www.allegion.com/us

Otros manuales de Cerrar de Schlage

Schlage

Schlage J Series Manual de usuario

Schlage

Schlage J Series Hoja de especificaciones

Schlage

Schlage L9000 Series Manual de usuario

Schlage

Schlage D-Series Manual de usuario

Schlage

Schlage Everest 29 Manual de usuario

Schlage

Schlage CO-100 Manual de usuario

Schlage

Schlage Dexter 605 Manual de usuario

Schlage

Schlage ND Series Manual de usuario

Schlage

Schlage CM5500-IBO Manual de usuario

Schlage

Schlage Door Locks Manual de usuario

Schlage

Schlage AD-201 Manual de usuario

Schlage

Schlage S-7100 Manual de usuario

Schlage

Schlage BE365 Manual de usuario

Schlage

Schlage HDB Manual de usuario

Schlage

Schlage L9000 Series Manual de usuario

Schlage

Schlage AD-200-CY Manual de usuario

Schlage

Schlage ND Series Manual de usuario

Schlage

Schlage CO-MS Manual de usuario

Schlage

Schlage B571 Manual de usuario

Schlage

Schlage M390RFK Manual de usuario

Schlage

Schlage SENSE Manual de usuario

Schlage

Schlage VandalGuard Manual de usuario

Schlage

Schlage AD-402 Manual de usuario

Schlage

Schlage AD-200 Manual de usuario

Manuales populares de Cerrar de otras marcas

Magic

Magic 105 Manual de usuario

Gantner

Gantner GAT NET.Lock 7020 System Guía rápida

Wittkopp

Wittkopp Insys 7202 Manual de usuario

Dorma

Dorma Studio Classic Manual de usuario

Securam

Securam ECSL-601 Manual de usuario

Sudhaus

Sudhaus 3003 Manual de usuario

Safety 1st

Safety 1st 48517 Manual de usuario

Pado

Pado FDS-10 Manual de usuario

Esco

Esco systeQ Series Manual de usuario

COMPX

COMPX National D8951 Manual de usuario

secureo

secureo Key Box Manual de usuario

Stock Loks

Stock Loks C8713 Manual de usuario

COMPX

COMPX 1T-058 Manual del propietario

Auslock

Auslock T11 Manual de usuario

ELCOM

ELCOM 7205 Manual de usuario

Stealth SAFES

Stealth SAFES ShadowVault Manual de usuario

Knox

Knox KeySecure 5 Manual de usuario

Kwikset

Kwikset 48334/01 Manual de usuario