1Ashtray. The ashtray is placed below the combustion
chamber. Attention! Be careful when you empty ashes
from the stove. There may be embers left for up to 24
hours after the stove was last used.
2 Handle for shaking grate. The stove is equipped with a
shaking grate. When you activate the grate handle, the
ashes from the combustion chamber are emptied into the
ashtray.
3 Regulation for primary air. Push the button sideways.
Left position is closed and right position is open. The pri-
mary air is used when lighting and refuelling the stove. It
should always be closed during continuous firing.
4 Regulation for combustion air. Push the button side-
ways. Left position is closed and right position is open.
The air is used for combustion and regulates the output
of the stove.
Clean combustion
The SCAN 60 uses the "CB technique" (Clean-Burn) to
ensure an optimally clean combustion. The extra combu-
stion air is preheated and led into the combustion chamber
close to the ceramic smoke deflector.
Ceramic smoke deflectors
Lift up the lower ceramic smoke deflector, pull out the
pins in the lateral combustion chamber plates and
remove the deflector. The upper deflector is removed in
the same way.
You have chosen a product from one of Europe's leading
manufacturers of wood-burning stoves. We are convinced
that your stove will be to your full satisfaction and give you
many hours of pleasure if you follow the advice and instruc-
tions of this manual.
Please read this manual as well as the General Instructions
for Installation before beginning the installation.
Congratulations on your new SCAN stove!
2
4
3
1
SCAN 60
The ashtray, shaking grate, and primary air should always
be closed during continuous firing.
