Sartorius 2405 Guía del usuario

Digital Micro Balances

2405

Instructions for installation and operation

1. UNPACKING

2. INSTALLATION OF THE BALANCE

2.1. Checking the voltage setting

2.2. Detaching the transport arrestment

2.3. Assembling the balance

2.4. Inserting the glass plates

2.5. Leveling the balance

3. DESCRIPTION OF THE OPERATING KNOBS

4. CHECKING AND ADJUSTING

4.1. Focusing the projection scale

4.2. Zero point

4.3. Sensitivity

5. WEIGHING PROCEDURES

6. SUPPLEMENT

6.1. Accuracy of the built-in set of weights

6.2. Correction of the weighing result

6.3. Determination of the air density

6.4. Conditions for installing micro balances

7. TECHNICAL DATA

1. Unpacking

1.1. Carefully remove the balance from their cartons.

1.2. Carefully unpack accessories.

2. INSTALLATION

2.0.1. IMPORTANT: see supplement 6.1. to 6.4.

2.0.2. Remove outer and inner lid.

2.1. Checking the voltage setting:

2.1.1. Place balance on the rear on to the plastic dust cover. Push the cover plate in the base plate aside

and change connecting wires, if necessary. Close the cover plate and set up the balance. Remove the

adhesive tape carefully and wipe off the arrears with alcohol.

2.2. Detaching the transport arrestment:

2.2.1. Weight application must indicate “29.99”.

2.2.2. Take off cover of the damping pot.

2.2.3. 3 Loosen knurled nuts, remove paper strips, swing aside springs and retighten nuts.

Remove cardboard strip.

2.2.4. Take out balance beam. Take off 3 plastic discs (1). Loosen 3 knurled nuts (2), swing aside springs

and retighten nuts.

2.2.5. Remove cardboard strip.

Connect balance to the mains. Press gray push button (see 3.1.).

2.2.6. Remove brackets at the ends of the locking bars of the weight application.

2.2.7. Pull out bars carefully.

2.3. Assembling the balance:

2.3.1. Check arrestment pins (1), damping (2) and bearing (3) and clean, if necessary.

2.3.2. Check knife-edges and bearing and clean, if necessary.

2.3.3. Set balance beam on to the arrestment pins (1). The knife-edge must not come into contact with the

bearing.

2.3.4. Place cover plate on to the damping pot and turn anti-clockwise until the slit the cover plate runs paral-

lel with the balance beam. Turn clamp clockwise until it locks.

2.3.5. Check stirrup plate and clean, if necessary. Set stirrup plate on to the arrestment pins.

2.3.6.2. Unscrew 2 knurled nuts and take off bow.

2.3.7. Attach stirrup and insert it.

2.3.8. Unscrew 2 knurled nuts and take down carefully the locking plate for the weights. Put back the perfo-

rated plate afterwards.

2.3.9. Attach lamp housing and plug in the cable.

2.3.10. Place the inside hood on to the balance.

2.3.11. Swing out pan lifting device. Open upper sliding door and attach pan bow.

2.4. Inserting the glass plates:

2.4.1. Place glass plate into the balance and close upper sliding door. Put the balance pan on to the holder

and swing in the pan.

2.4.2. Place glass plate into the balance and close sliding door.

2.4.3. Put locking screws for the front plate into position.

2.4.4. Fasten front plate.

2.4.5.Turn weight application to “0.00” and set micrometer to “00”.

Tabla de contenidos

Otros manuales de Escala de Sartorius

Sartorius

Sartorius talent Manual de usuario

Sartorius

Sartorius Sartorius PMA 35D-X Instrucciones de funcionamiento

Sartorius

Sartorius CB Manual de usuario

Sartorius

Sartorius PMA.Vision VIS1Y Manual de usuario

Sartorius

Sartorius PMA.Evolution Manual de usuario

Sartorius

Sartorius M3P Manual de usuario

Sartorius

Sartorius PMA.Evolution EVO1Y1 Manual de usuario

Sartorius

Sartorius IS16EDE-H Manual de usuario

Sartorius

Sartorius BL150S Manual de usuario

Sartorius

Sartorius IW2P1x-6ED-L Manual de usuario

Sartorius

Sartorius EVO1S Manual de usuario

Sartorius

Sartorius Cubis Series Manual de usuario

Sartorius

Sartorius Secura Manual de usuario

Sartorius

Sartorius 1802 Guía del usuario

Sartorius

Sartorius CP64 Manual de usuario

Sartorius

Sartorius Micro M 500 P Manual de usuario

Sartorius

Sartorius 1601 MP 8 Manual de usuario

Sartorius

Sartorius PMA.Evolution Manual de usuario

Sartorius

Sartorius 1002MP9 Manual de usuario

Sartorius

Sartorius Extend Series Manual de usuario

Sartorius

Sartorius Cubis MCA Series Manual de usuario

Sartorius

Sartorius 2406 Guía del usuario

Sartorius

Sartorius 1100 Guía del usuario

Sartorius

Sartorius EC1XS.-......-L Instrucciones originales

Manuales populares de Escala de otras marcas

AWS

AWS ZEO-50 Manual de usuario

Gima

Gima Glass Body Fat Analyzer Manual de lista de piezas

Seca

Seca 374 Manual de usuario

TEC

TEC TEC SL59 SERIES Manual de usuario

Axis

Axis B/E Series Manual de usuario

Alecto

Alecto ACW-40 Manual de usuario

Rice Lake

Rice Lake MSI-4260 IS Manual de usuario

IKA

IKA RCT basic safety control Manual de usuario

ADE

ADE M20011 Manual de usuario

Duronic

Duronic KS3000 Manual de usuario

Digi

Digi SM-720 Manual de usuario

Cardinal

Cardinal CS Series Manual de usuario

Korona

Korona Kastella Manual de usuario

A&D

A&D FC-50Ki Manual de usuario

BDA

BDA CAMARGUE Manual de usuario

Tanita

Tanita HD-357 Manual de usuario

Leifheit

Leifheit 03173 Manual de usuario

Lumme

Lumme LU-1340 Manual de usuario