Sangoma IMG 1010 Guía

IMG 1010 - Rack Mounting

The IMG 1010 is shipped with the tray and docking station mated together for easy mounting. When mounting the chassis, follow these

guidelines:

Do not obstruct air flow to the front or the side vent holes towards the rear of the unit.

Allow approximately 76 cm (2.5 ft.) to slide the field-replaceable tray out.

19" Front and Mid mount Bracket Positioning

The IMG 1010 ships with brackets for a 19" inch rack. They are installed in the front mount position as shown below.

Front Mount (factory default)

The brackets can be rotated as shown below. By rotating and repositioning the brackets, the IMG can be used in a mid-mount installation. The

two mid-mounting options are displayed in diagrams below.

Mounting Ears on bracket facing rear:

Mounting Ears on bracket facing forward:

19" Rear Mount Bracket Kit (SLM-BRK-1000)

For extra support, a rear mount bracket assembly is also available. This bracket assembly is needed to make the system NEBS Level 3

Compliant. If only the front or mid mount brackets are used when installing an IMG in a rack system, the IMG 1010 will not be NEBS Level 3

Compliant. The rear mount brackets are attached to the IMG 1010 by inserting a 6-32" screw located towards the rear of the IMG into the

mounting hole of each bracket (one on either side of IMG 1010). Contact your sales representative to order the bracket.

23" Front and Rear Mount Bracket Kit (SLM-BRK-1001)

The bracket assembly for use with a 23" rack includes front and rear mounting options for added stability. When installing IMG into a 23" rack, the

front and rear brackets are required. As explained above, for the IMG 1010 to be NEBS Level 3 compliant in a 23" rack, both the front and rear

bracket assemblies must be used. See diagram Below

Installation

Remove existing 19" brackets from front mounting position.

Replace with 23" brackets, re-using existing screws.

Attach Rear Bracket Mounts to chassis as shown in figure.

Attach 23" brackets to the Bracket Mounts using screws provided.

Tabla de contenidos

Otros manuales de Puerta de Sangoma

Sangoma

Sangoma Vega 60G Manual de usuario

Sangoma

Sangoma Vega 100G Manual

Sangoma

Sangoma Vega 3050G Manual de usuario

Sangoma

Sangoma Netborder SS7 Manual de usuario

Sangoma

Sangoma VEGA400G Instrucciones de funcionamiento y mantenimiento

Sangoma

Sangoma Vega 60G Manual de usuario

Sangoma

Sangoma IMG 2020 Manual de usuario

Sangoma

Sangoma Vega 100G Manual de usuario

Sangoma

Sangoma Vega 5000 Manual de usuario

Sangoma

Sangoma Vega 4x4 Manual de usuario

Sangoma

Sangoma Netborder SS7 Manual de usuario

Sangoma

Sangoma Vega 100G Manual de usuario

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario