Samsung RF22K9381 Guía de instalación
June 2019
Technical Service Assistance: 1.844.312.7158
Asuriontechline@asurion.com
Technical Assistance Specialist –Major Appliance
Tips: From Your Technical Assistance Specialist
Product: Samsung Refrigerators
Topic: French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Applies to models produced between 2014 - 2018
RF22K9381*,RF22K95*,RF22KRED,RF22M95*,RF22NP**,RF23J9011,RF23M8070,RF23M8090
RF23M8960,RF23M8570,RF23M8590,RF23HCED,RF23HTED,RF24FSED,RF25HMED,RF26J7500
RF28HDED,RF28HFED,RF28HMED,RF28JBED,RF28K9070,RF28K9380,RF28K9580,RF28M9580
RF28N9780,RF28HDEDP,RF28HFEDT,RF28NHED,RF263BEAEB,RF263TEAES,RF265BEAE,RF30KMEDB
NOTE: Samsung does not have an upgraded IM SVC KIT for all models. If your specific model is not
included in this bulletin, there are no kits available at this time. Do NOT make any substitutions.
Providers should follow the normal steaming, de-icing and drying process. Apply the silicon and
install the Y clips, update icemaker, auger and drain, Zip Tie and Main PCB. Confirm the dispenser is
closing and water pressure delivers no more than 16 ounces in 20 seconds. The IM SVC Kit come
For additional information on this process contact Asurion Technical Assistance 1-844-312-7158
************ All STEPS AND PARTS MUST BE FOLLOWED AND INSTALLED**************
Failure to properly follow these steps can result in a failed repair and return visit to the consumer. Please
complete all steps as they are written and do not skip or modify the repair procedure. If a part has
previously been replaced prior to installing this kit, replace it with the part included in the kit.
May 2019
1. Place the unit into Self Diagnostic mode to retrieve any existing fault codes.cal Assistance
Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 1
Asuriontechline@Asurion.com
Service Preparation:
2. Place the unit into a forced defrost mode. This will loosen the ice and warm up the cooling loop
in preparation for removing the ice maker. While the unit is in forced defrost mode, continue
with the next steps.
3. Remove the ice bucket. If the ice bucket cannot be removed use your steamer to loosen
the ice bucket.
NOTE: If the ice bucket is stuck, use a steamer to melt
the ice until you can the remove the bucket. Place a
towel under the ice bucket to catch water as it drips.
****** Do Not Use A Heat Gun Or Hair To Defrost The Ice Room ******
This may cause the plastic liner to melt creating unrepairable damage.
Do Not instruct the customer to unplug the refrigerator for 24 hours to
remove the ice. This will not remove all the ice from the ice room resulting
in a return visit or call back.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 2
Asuriontechline@Asurion.com
1. Service Steps
a. Remove the ice bucket from the Ice Room.
b. Check for cracks or fractures in the ice bucket.
c. Check the gasket around the edge of the bucket making sure it is not ripped, cracked,
rolled or has become too rigid, preventing a proper seal or air leak.
All Service Steps Must Be Followed
2. Inspect the ice chute flapper and assembly for a tight seal
Inspect the ice chute flapper. Ensure the rubber is still soft and pliable, has no teas or rips and that
the flapper is in the fully closed position when out. Also inspect the ice dispensing opening make
sure the seal is clean and clear of any hard water minerals before reassembly.
May 2019
****** You Must Remove All Ice From The Ice Room And Auger Area Using A Steamer ******
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 3
Asuriontechline@Asurion.com
3. Remove the unit from the Forced Defrost mode and then unplug the unit. This will prevent the
cooling loop from frosting up during service and prepare the unit for additional service steps.
4. Disassemble The Ice Maker
a. Remove the left screw, and then open the harness cover.
b. Disconnect the ice maker cable.
c. Locate the duct left hook (C1). Unlock the drain duct by removing the upper right screw (C2)
d. Unlock the left hook, and then open the drain duct
e. Unlock the upper hook, and then pull out the ice maker from the opening of the drain duct.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 4
Asuriontechline@Asurion.com
5. Check For Icing Symptoms In The Ice Room
a. Check for traces of water spry in the upper ice room area.
b. Check for ice in the air flow path (L Duct).
c. Check for ice in the drain pipe of the auger motor.
d. Check for ice on the ice room bottom.
Continue steaming the unit to remove all traces of ice and frost to allow for the safe
removal of the auger motor assembly. Failure to remove all traces of ice
will result in a possible repeat visit or call back.
6. Disassemble Of The Auger Motor
a. Disconnect the cable of the auger motor.
b. Push the bottom hook.
c. Remove the auger motor.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 5
Asuriontechline@Asurion.com
7. Inspect the air channel above the auger assembly and remove all traces of ice from this area.
Failure to do so will create new ice build up there and on the floor, side walls and rear.
NOTE: It is very important to completely
remove all remnants of accumulated ice in the
ice room and auger. Failure to remove all the
ice can result in a return visit.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 6
Asuriontechline@Asurion.com
8. With the auger motor assembly removed, inspect the drain of the ice room. Place your
finger into the drain are to feel for any foam remnants or ice blockage. Remove any
and all found material.
If ice is found, use a steamer to remove and ensure you have flow from the ice room to the drip
pan in the rear. Drains must always remain open.
NOTE: Once you have confirmed all the ice has been removed from the entire ice
room area, towel the whole ice Room dry including the cooling loop, side walls,
floor, and ceiling of the ice room.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 7
Asuriontechline@Asurion.com
9. Disassemble the auger drain (DA97-19898A) and replace it with the drain component
from your IM SVC Kit.
NOTE: Do not order an entire auger assembly unless you find a defect such as a
damaged fan, motor or physical damage
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 8
Asuriontechline@Asurion.com
10. Check for any particles in the fill tube using a mirror. Remove all particles.
Check the gap between the water line outlet and the fill tube to prevent water spray. If the gap
between the water line outlet and the fill tube is less than 10 mm, adjust the insertion length
of the water line in the cabinet rear (back of the refrigerator).
NOTE: If the gap between the water line limit marking and cabinet rear wall is below 15mm
(within 10mm), adjust it to be about 15mm to 20mm
11. Sealing the ice room with RTV sealant. Seal any gaps that you find in the ice room sides and floor.
RTV Sealant Part Number
DA81-05595A
Trim the tip of the applicator at a 45°
angle, then apply the sealant along the
gaps identified by the red line. This will
help provide an air tight sealed ice room.
May 2019
Technical Assistance Specialist –Major Appliance
SAMSUNG - French Door Direct Cool Ice Maker No Ice, Frozen, Frost, Ice Bucket Stuck
Technical Assistance 1-844-312-7158 9
Asuriontechline@Asurion.com
12. Re-install the auger motor assembly ensuring it is installed fully to the rear and locked into place
with the locking tab. Reconnect the auger motor wire harness to the connection point on the
left wall making sure to route the wiring properly.
13. Remove the white plastic retainer around the cooling loop, install the new retainer, and then attach
the Y-Clip (DA82-02367A) to the bottom of the cooling loop Ensure there is no gap between the clip
and the rear wall retainer clip. The Y-Clip and retainer are included with your IM SVC Kit.
Install the Y-Clips pointing straight down. They must not be crooker or sideways.
If they are, water will pool up on the surface and freeze
Otros manuales para RF22K9381
1
Este manual sirve para los siguientes modelos
31
Otros manuales de Piezas y accesorios para refrigeradores de Samsung
Manuales populares de Piezas y accesorios para refrigeradores de otras marcas
BEST BUY essentials
BEST BUY essentials BE-SSHQ531 Manual de usuario
Carrier TRANSICOLD
Carrier TRANSICOLD 69NT40-531 Series Manual de usuario
Manitowoc
Manitowoc K00221 Manual de usuario
GEA
GEA 402 UVR Manual de usuario
Pentair
Pentair Condensate Neutralization kit Manual de usuario
Silver King
Silver King SKRS28-ESUS10 Guía de inicio rápido
