Salus FT100 Manual de usuario
Instruction Manual
Model No FT100
Electronic Frost Thermostat
2
Salus FT100 Manual 001:89 29/11/10 22:57 Page 1
FT100 INSTRUCTION MANUAL
2
PRODUCT COMPLIANCE
This product complies with the essential requirements of the following EC
Directives:
•Electro-Magnetic Compatibility directive 2004/108/EC
•Low Voltage Directive 2006/95/EEC
•EC Marking directive 93/68/EEC
SAFETY INFORMATION
These instructions are applicable to the Salus Controls model stated on the
front cover of this manual only, and must not be used with any other make or
model.
These instructions are intended to apply in the United Kingdom only, and
should be followed along with any other statutory obligations.
This accessory must be fitted by a Competent person, and installation must
comply with the guidance provided in the current editions of BS7671 (IEE
Wiring Regulations) and Part ‘P’ of the Building Regulations. Failure to
comply with the requirements of these publications could lead to
prosecution.
Always isolate the AC Mains supply before carrying out any work on the
FT100 thermostat.
Please leave these instructions with the end user where they should be kept
in a safe place for future reference.
Salus FT100 Manual 001:89 29/11/10 22:57 Page 2
FT100 INSTRUCTION MANUAL 3
INTRODUCTION
A frost thermostat is used to protect your
property from damage by freezing. It works by
turning on your heating system if the
temperature drops below the temperature you
have set on the frost thermostat, allowing the
user peace of mind.
The FT100 from Salus Controls is a stylish
mains voltage thermostat that can switch a
pump, zone valve or boiler to provide localised
protection from freezing, regardless of the
heating controller settings. Fitted with a
protective cover to prevent tampering, this
thermostat has been specifically designed to
be used for 230V AC heating applications.
Features
•Simple to use
•Large dial
•Tamper proof cover
•LED heat call indicator
•Temperature range between -10 ºC and 20 ºC
•Stylish Casing
Salus FT100 Manual 001:89 29/11/10 22:57 Page 3
INSTALLATION
Please read the important safety information at the start of this manual before you
begin to install the device.
The Frost Thermostat should be located in the coldest part of the building, but where
it can respond to a rise in temperature when the boiler switches on. The ideal position
to locate the FT100 frost thermostat is about 1.5m above floor level, in a location
where the thermostat is accessible, reasonably lit and free from extremes of
temperature and draughts. Do not mount the thermostat on an outside wall, above a
radiator or in a location where it may be subjected to direct sunlight.
The electrical connections to the FT100 are made to the supplied industry standard
backplate. This simplifies installation, as no connections are made to the controller
itself. Connection details are shown below - no Earth connection is required for the
correct and safe operation of the FT100, but a parking terminal is provided to connect
an Earth wire if one is present.
FT100 INSTRUCTION MANUAL
4
Backplate Connections
Terminal Description Backplate
N Mains Neutral
L Mains Live
SL Switched Live
(Normally Open Contact)
Earth Parking (no electrical
connection)
After installing the backplate in a suitable location, wiring connections can be made
as shown above. The following criteria apply to the installation:
• The incoming AC mains supply should be 230V AC and fused at 5 amps.
• Optimum cable size for installation is 1.5 mm2; wiring colours should be in
accordance with the current requirements of the IEE Wiring Regulations.
• Cable entry should be from the rear of the backplate.
• All wiring connections should be securely made, and be firmly gripped
beneath the square brass washer on each terminal.
Salus FT100 Manual 001:89 29/11/10 22:57 Page 4
FT100 INSTRUCTION MANUAL 5
Do not restore the mains supply to the system until all associated items are fully installed.
NOTE: All electrical installation work should be carried out by a suitably qualified Electrician
or other competent person. If you are not sure how to install this thermostat consult either
with a qualified electrician, heating engineer or your boiler / heating system supplier for
advice on how to continue.
Do not remove or refit the FT100 onto the backplate
without the mains supply to the system being isolated.
OPERATION
The FT100 is adjusted very easily by turning the rotary dial on the front of the
thermostat to the required frost protection temperature.
To adjust the set temperature, unclip the protective cover and turn the rotary dial to
the left to set a lower temperature, or to the right to set a higher temperature. Refit
the protective cover after you have finished adjusting the set temperature.
The Light Emitting Diode (LED) on the front panel will light when the temperature is
below the set value, showing that the thermostat is calling for heat from the boiler.
Once the room reaches the set temperature, the LED will turn off and the FT100 will
stop calling for heat from the boiler.
MAINTENANCE
The FT100 frost thermostat requires no special maintenance. Periodically, the outer
casing can be wiped clean using a dry cloth (please DO NOT use solvents, polishes,
detergents or abrasive cleaners, as these can damage the thermostat).
There are no user serviceable parts within the unit; any servicing or repairs should
only be carried out by Salus Controls or their appointed agents.
Should the FT100 frost thermostat fail to function correctly, check:
• The FT100 temperature has been set correctly.
• Heating system time switch or programmer is switched on.
Salus FT100 Manual 001:89 29/11/10 22:57 Page 5
PRODUCT SPECIFICATION
Model: FT100
Type: Surface mounted electronic frost
thermostat designed for 230V AC
heating applications.
Switching
Switching Voltage: 230V AC / 50Hz
Switching Current: 8A resistive, 3A inductive
Contact Type: Single Pole Single Throw (SPST)
Temperature
Range: - 10 ºC to + 20 ºC
Accuracy: ± 1 ºC at 25 ºC
Environment
Operating Temperature: 0 ºC to + 50 ºC
Storage Temperature: - 20 ºC to + 55 ºC
FT100 INSTRUCTION MANUAL
6
Salus FT100 Manual 001:89 29/11/10 22:57 Page 6
Salus Controls warrants that this product will be free from any defect in materials or
workmanship, and shall perform in accordance with its specification, for a period of
two years from the date of purchase. Salus Controls sole liability for breach of this
warranty will be (at its option) to repair or replace the defective product.
FT100 Warranty
Customer Name: ..............................................................
Customer Address: ...........................................................
.........................................................................................
Post Code: ......................... Tel No: ..................................
Email: ...............................................................................
Engineers Company: ........................................................
Tel No: .............................................................................
Email: ...............................................................................
Intallation Date: ...............................................................
Engineers Name: ..............................................................
Engineers Signature: ........................................................
FT100 INSTRUCTION MANUAL 7
Salus FT100 Manual 001:89 29/11/10 22:57 Page 7
Sales
:
Technical
:
Salus Controls plc, Salus House, Dodworth Business Park South,
Whinby Road, Dodworth, Barnsley S75 3SP
salus-tech.
Salus FT100 Manual 001:89 29/11/10 22:57 Page 8
Tabla de contenidos
Otros manuales de Termostato de Salus
Salus
Salus VS35W Manual de usuario
Salus
Salus ERT20RF Manual de usuario
Salus
Salus STP1 Manual de usuario
Salus
Salus TH-3 Manual de usuario
Salus
Salus ERT20RF Manual de usuario
Salus
Salus HTRS230 Guía del usuario
Salus
Salus RT310TX Manual de usuario
Salus
Salus Quantum WQ610 Manual de usuario
Salus
Salus VS05 Manual de usuario
Salus
Salus ERT50T Triac Manual de usuario
Salus
Salus EP101 Manual de usuario
Salus
Salus DT300 Manual de usuario
Salus
Salus RT500ROF Manual de usuario
Salus
Salus RT200 Manual de usuario
Salus
Salus HTR-RF(20) Manual de usuario
Salus
Salus WBRT520TX Manual de usuario
Salus
Salus RT510WBC Manual de usuario
Salus
Salus ERT30 Manual de usuario
Salus
Salus 091FLRF Manual de usuario
Salus
Salus VS20 Manual de usuario
Manuales populares de Termostato de otras marcas
EWELLY
EWELLY EW-181 Manual de usuario
Prolon
Prolon T1100 Instrucciones de instalación
Computherm
Computherm Q20 Manual de usuario
Heatmiser
Heatmiser neoStat Manual de usuario
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario
