Robin SlimLine Manual de usuario
Software version 1.0.0 or higher
Manual version: 1.0.0
Date: 28-03-2022
User Manual
Robin SlimLine
Robin SlimLine ‘for Teams’
gf1
1
Manual Robin SlimLine ENG - v. 1.0.0
gf2
2
Manual Robin SlimLine ENG - v. 1.0.0
About this manual
This manual describes the installation and programming of the Robin SlimLine SIP intercom
firmware version 1.0.0). You can update the software of the Robin to the latest version. For
instructions on updating see page 51 of this manual.
This manual applies to:
Robin SlimLine SIP
Robin SlimLine SIP for MS Teams
The Robin SlimLine SIP for MS Teams is an optimized intercom for use with the CyberGate service
of CyberTwice.
If you have any questions after reading this manual, please contact us at:
website: www.robintele.com
support website: support.robintele.com
Important safety information
Take the following security measures when using a Robin:
The use of port forwarding in routers / firewalls to access the Robin door phones is strongly
discouraged. Use the Robin door phones on the local network (LAN) only
Change at first use the passwords of both the ‘admin’ and the ‘user’ (in the menu -System-
Security-), it is recommended to change them regularly
Use strong passwords (minimum 12 characters long)
Configure the used PBX / VoIP provider to only allow the Robin door phone to call its
programmed destination numbers using the white-list function in the PBX / VoIP provider
Update the Robin door phone regularly
A
About this manual
gf3
3
Manual Robin SlimLine ENG - v. 1.0.0
Table of Contents
1 Introduction 5
1.1 Robin SmartView / ProLine SIP Door Intercom 5
1.2 Robin features 5
2 Operation 8
2.1 Operating the door phone 8
2.1.1 Robin SlimLine SP 8
2.2 Answering 8
2.3 Controlling the built-in door opener 8
3 Installation 9
3.1 Package contents of the Robin SlimLine Surface mount 9
3.2 Package contents of the Robin SlimLine Flush mount 10
3.3 Surface mounting instructions 10
3.4 Flush mounting instructions 11
4 System installation 12
4.1 Requirements prior to installation 12
4.2 Power-on the Robin 12
5 Configuration 14
5.1 Logging in to the Robin 14
5.2 Configuration of the Robin 15
5.2.1 Telephony 16
5.2.1.1 Telephony / SIP 16
5.2.1.2 Telephony / Teams (Robin ‘for Teams’) 19
5.2.1.3 Telephony / Phonebook 21
5.2.1.4 Telephony / Call settings 24
5.2.1.5 Telephony / Call log 27
5.2.1.6 Telephony / Control 27
5.2.2 Audio 28
5.2.2.1 Audio / Settings 28
5.2.2.2 Audio / Detection 29
5.2.3 Video 30
5.2.3.1 Video / Live 30
5.2.3.2 Video / Settings 31
5.2.3.3 Video / Overlay 32
5.2.3.4 Video / Motion 33
5.2.4 Network 34
5.2.4.1 Network / Status 34
5.2.4.2 Network / Settings 35
5.2.4.3 Network / HTTP 36
5.2.4.4 Network / Mail 37
5.2.4.5 Network / NAT 38
5.2.4.6 Network / RTSP 40
I
Index
gf4
4
Manual Robin SlimLine ENG - v. 1.0.0
5.2.5 System 42
5.2.5.1 System / Device 42
5.2.5.2 System / Clock 43
5.2.5.3 System / Events 44
5.2.5.4 System / Security 48
5.2.5.5 System / Schedules 50
5.2.5.6 System / Software 51
5.2.5.7 System / Streams 52
5.2.5.8 System / Switch 53
5.2.5.9 System / Info 55
5.2.5.10 System / Debug 56
5.2.5.11 System / Logs 57
6 Support 58
Appendix A, Electronic lock 59
I
Index
gf5
5
Manual Robin SlimLine ENG - v. 1.0.0
1 Introduction
1.1 Robin SlinLine SIP Door Intercom
Integrated functions
The Robin SlimLine SIP has many integrated functions in one single device:
Telephone device with one button
SIP support for audio and video
High-Definition, full colour camera with a wide-angle lens
Security camera with movement- and audio detection
RTSP streaming (audio and video)
Door opener
Advanced event mechanism
Extended API (Application Programming Interface)
1.2 Robin features
Easy to install
A single module is all that has to be mounted; there are no extra modules necessary.
Simple operation
The Robin can be programmed to dial a predefined phone extension when the button is pressed.
Audio and video will be available during the call and the door opener relay of the Robin can be
activated using DTMF.
SIP communication
The Robin uses the Session Initiation Protocol (SIP). This means that the intercom can be
connected to any IP-PBX or VoIP provider that supports the SIP protocol.
Robin for MS Teams
The Robin for MS Teams is a special version of the Robin SlimLine. It is developed to communicate
with Microsoft Teams using the CyberGate service of CyberTwice and can’t be used with a SIP-PBX
or VoIP provider.
I
Introduction
gf6
6
Manual Robin SlimLine ENG - v. 1.0.0
High-quality sound reproduction
Thanks to the advanced audio DSP in the Robin, its sound quality is exceptionally good without any
echo or interference.
Microsoft Teams support
The Robin can be connect to a Microsoft Teams environment using the CyberGate service of
CyberTwice. CyberGate offers audio and video support to Microsoft Teams. A Microsoft Teams user
can communicate, see the person at the door and open the door remotely. For more information
about CyberGate, see the website: cybertwice.com
Door opener
The potential free relay switch (dry contact) embedded in the Robin is activated by typing in a key
combination at the dialled device. The key combination can be specified in the WEB interface of the
Robin. The relay can be used to open a door, a gate or a barrier.
Video support
A real-time video image of the person using the Robin is displayed on the screen of the H.264
compatible videophone, softphone or Microsoft Teams client as soon as a call is answered.
High-Definition video quality
The integrated camera of the Robin is capable of displaying the video image in High-Definition. A
maximum of three simultaneous video streams are supported.
Security camera function
The integrated camera can also be used for surveillance purposes. The Robin is able to deliver the
video stream to many Video Management Software systems (VMS) in two formats, MJPEG and
H.264 (RTSP).
Picture To Email
The Robin features Picture To Email. It can send an e-mail containing the captured picture of the
visitor to an email address of choice. The document: How-To_Picture2Email_ENG.pdf describes the
configuration of this function.
You can also download this document on our support site: http://support.robintele.com
I
Introduction
gf7
7
Manual Robin SlimLine ENG - v. 1.0.0
No separate power supply
The Robin is powered via Power over Ethernet (PoE IEEE 802.3af). This eliminates the need for a
separate power supply; connection to a PoE network switch or Midspan is all that is necessary.
Web-based configuration
The Robin can be configured on a PC or Mac via a web browser (e.g. Firefox, Chrome, Safari).
Using a web browser, modification of all the settings for the Robin is easy.
Compatible with WEBRelay
The Robin is compatible with an external IP relays, the ControlByWeb WEBRelay Quad-LS. This
external device is equipped with 4 build-in relays and can be connected to the LAN. The ‘Events’
mechanism in the Robin can control the four relays (page. 44).
I
Introduction
gf8
8
Manual Robin SlimLine ENG - v. 1.0.0
2 Operation
2.1 Operating the door phone
To ring the door phone, press on the button on the Robin. The unit will play a ringing sound and the
defined call destination will be called. It will also dim the button illumination when the button is
pressed.
2.2 Answering
You answer a call initiated by the Robin by answering the phone that is being called. In case
you use a H.264 compatible videophone, softphone or MS Teams client the video picture of the
integrated camera is displayed on the screen of the phone.
2.3 Controlling the built-in door opener
The built-in door opener is controlled with predefined keys on the telephone set that answers the
call. When you activate the door opener, the attached door, gate, barrier, etc. will open.
You can change the default DTMF code to open the door in the interface of the Robin in the menu
-System-Switch- (default code: ##).
O
Operation
gf9
9
Manual Robin SlimLine ENG - v. 1.0.0
3 Installation
There are two versions of the Robin SlimLine, one for surface mount installation and one for flush
mount installation.
For Surface mount installation, a surface mount box is nessecary (sold seperately), for a Flush
mount installation, a flush mount box is nessecary (sold seperately).
3.1 Package contents of the Robin SlimLine Surface mount
The Robin SlimLine for Surface mount
1 bottom screw
4 screws
4 wall plugs (6mm)
Engravable label
Double-sided tape for the label
Connector with cable-ends for connecting the build in relay
I
Installation
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Sistema de intercomunicación de Robin
Robin
Robin SmartView SIP Manual de usuario
Robin
Robin SmartView SIP Manual de usuario
Robin
Robin SV Series Manual de usuario
Robin
Robin SIP Manual del propietario
Robin
Robin Robin SmartView Manual de usuario
Robin
Robin Compact Manual de usuario
Robin
Robin SIP Manual del propietario
Robin
Robin Compact SIP Manual de usuario
