③In the 10 minutes or 1 hour movement tracking mode, the GPS tracker
will regularly update the location on the APP Map page and History when
there is a continual vibration & movement
④The device supports GPS tracking (Outdoor), WIFI tracking (Outdoor and
indoor), LBS tracking (Outdoor and indoor). The primary difference between
GPS and Wi-Fi locating technologies is in the method of gathering location
data. GPS uses satellites that orbit around the Earth to triangulate a user's
location, whereas Wi-Fi locating technology uses relative network signal
strength gathered at network access points. GPS tracking is available in out-
door but mostly not available for indoor. When the GPS tracker doesn’t find
GPS signal, it will use Wi-Fi or LBS tracking, Wi-Fi tracking is better for
indoor comparing with LBS tracking.
8.2. Calling:
1. Phone Book:
①Add a contact: Click APP More Settings Phone Book - Click the
Add icon Insert name and number (can be set up to 15
numbers), and finally click OK to save.
②Edit Contact: Click APP More Settings Phonebook - drag to
select the number you want to edit Click the edit icon Click OK to
save.
③Delete Contact: Set the phone book as blank.
2. SOS Numbers:
Click APP More Settings SOS Numbers - Enter SOS phone
numbers, click save.
3. Call:
①Use phonebook to call: Click the address book icon in the GPS watch
to view the contact list, slide up and down to select a contact to Call.
②One Button SOS: in case of emergency, press the power button for
3 seconds to trigger the emergency call SOS. At this time, the GPS
watch will call the 3 preset emergency numbers circularly.
Note: Do not input special characters in phonebook, such as "-", "()" etc.
8.3. Historical Location Playback
In the main page of the APP, click the history button in the bottom, you can
check the location history playback within the last three months.
8.4. Geo-fence (safe zone):
This feature defines a Geo-fence (safe zone) perimeter and sends the
user a push notification if the tracker has left or entered the safe zone.
The user can still manually locate the tracker when the safe zone is turned
on/off. Click ‘More’ ‘Geofence’ click the "+" icon in the bottom input
the zone name Click and drag the map to set the center point click
on the "+" "-" icon or drag to set the coordinates regional context click
OK in the upper right corner to save the setting.
Note:
