Roadmaster 1209-118 Manual de usuario
85-3774 rev. 04 02-19
ROADMASTER, Inc. • 6110 NE 127th Ave. • Vancouver, WA 98682 • 800-669-9690 • www.roadmasterinc.com
part #1209-118
1-3/8” diameter
Rear Anti-Sway Bar Kit
for Sprinter Van 3500
INTRODUCTION
Thank you for purchasing this anti-sway bar kit. This kit is designed to improve the handling characteristics of your Sprinter 3500
by reducing the body roll and balancing the weight transfer during cornering. The anti-sway bar kit is engineered for long life
and trouble-free performance. For maximum suspension control, use this kit along with our front anti-sway bar kit.
All the hardware needed for installation is included in this kit. Refer to the PARTS LIST in these instructions to identify the parts.
SUGGESTED TOOLS
The following tools are suggested to complete the installation procedures:
• General hand tools • Die grinder
Installation Instructions
Thank you for purchasing this anti-
sway bar kit. Please read through
these instructions before installation.
•If raising the vehicle to install the anti-sway bar, always support
the vehicle with jack stands at both frame rails or at the rear axle
before working underneath. Ensure that the jack stands are securely
positioned, and are rated at or above the weight of the vehicle.
•The installer must read the instructions and use all bolts and parts
supplied. Use only the parts supplied by ROADMASTER to install
this kit.
•Minor modifications are sometimes necessary due to slight vehicle
variations, even for the same year, make and model.
•Regardless of year, make and model, a wide range of options for
specific applications may or may not interfere with the installation.
It is the installer’s responsibility to make certain that equipment is
not damaged once the suspension solution travels through the full
range of motion. Failure to ensure adequate clearance could result
in non-warranty property damage, personal injury or even death.
Failure to follow these instructions
can result in property damage, per-
sonal injury or even death.
WARNING
•If running changes were made by the manufacturer after this kit
was designed, there may be weldments, braces, gussets, or other
structural items which interfere with the installation. It is the in-
staller’s responsibility to allow for these running changes without
sacrificing the structural integrity of the anti-sway bar. Failure to
securely fasten the anti-sway bar could result in property damage,
personal injury or even death.
•ROADMASTER will not be responsible for any damage or injury
resulting from any modification or alteration.
•Check ALL the fasteners for tightness before and after road testing
the vehicle.
•Do not use this document for custom fabrication, as it may not
show all parts or structural components.
•Do not use an air impact wrench when re-installing bolts, as stripped
threads may result.
•This anti-sway bar is only warranteed for the original installation.
Installing a used anti-sway bar on another vehicle is not recom-
mended and will void the warranty.
PARTS LIST
2 • Sprinter Van 3500 Rear Anti-Sway Bar Kit 800-669-9690
5
4
2
1
3
Part #1209-118
Part # Description Qty
1 B140 Bracket 2
2 205219-10 Bushing 2
3 205227-00 Bushing 4
4 205507-00 Sleeve 2
5 400011-30 Grease Aqualube 1
6 580037-00 Anti-sway bar 1
7* 200544-00 Loc Tite 1
*not pictured
6
The following instructions must be followed in the order listed to ensure a proper installation
and to preserve the ROADMASTER warranty.
INSTALLATION
800-669-9690 Sprinter Van 3500 Rear Anti-Sway Bar Kit • 3
1. Remove the factory anti-sway bar from the axle.
Do not disconnect the endlinks from the frame (Figure 1). Retain all
hardware, you will be using it later.
2. Install the new anti-sway bar.
Install the endlinks to the anti-sway bar. With the ends of the bar fac-
ing straight up, insert the bolts and hand tighten (Figure 2).
3. Install the poly bushings with grease on the bar.
Rotate the bar into position and with the bushing clamp (B140) posi-
tioned off the bushing, start the bolts (Figure 3). Note: use Loc tite on
the bolts.
Note: when reinstalling the brake line locators, they may need to be
trimmed (Figure 4).
Figure 1
Figure 2
WARNING
The anti-sway bar is heavy, and may cause property damage or per-
sonal injury if it falls on equipment, engine components or any part of
your body. Ensure that the anti-sway bar is supported and that you are
out of the way when removing the brackets.
Failure to follow these instructions may cause property damage,
personal injury or even death.
Figure 3
The following instructions must be followed in the order listed to ensure a proper installation
and to preserve the ROADMASTER warranty.
INSTALLATION
Note: when reinstalling the brake line locators, they may need to be
trimmed (Figure 4).
4. Once the bolts are started on both sides, tighten them
to the factory torque specifications. Then, tighten the
endlink bolts.
5. Test drive and re-check all the hardware.
Do not tow or hoist the vehicle using the anti-sway bar or its
mounting brackets as attachment points. The anti-sway bar is not
designed to carry the weight of the vehicle and may collapse, which
will damage the anti-sway bar components, the suspension, or other
components. The vehicle will detach or fall, which may cause severe
personal injury.
Failure to follow these instructions may result in property damage,
personal injury or even death.
The anti-sway bar is not a load-bearing component
WARNING
4 • Sprinter Van 3500 Rear Anti-Sway Bar Kit 800-669-9690
Figure 4
Otros manuales de Accesorios para automóviles de Roadmaster
Roadmaster
Roadmaster 52285-1 Manual de usuario
Roadmaster
Roadmaster 2120 Guía de inicio rápido
Roadmaster
Roadmaster StowMaster 910003-10 Guía
Roadmaster
Roadmaster 751428 Manual de usuario
Roadmaster
Roadmaster BrakeMaster 9000 Manual de usuario
Roadmaster
Roadmaster Sterling Manual de usuario
Roadmaster
Roadmaster 156-25 Manual de usuario
Roadmaster
Roadmaster FuseMaster 76511 Manual de usuario
Roadmaster
Roadmaster Falcon 2 Instrucciones originales
Roadmaster
Roadmaster BASEPLATE KIT Manual de usuario
Roadmaster
Roadmaster Invisibrake 8700 Manual de usuario
Roadmaster
Roadmaster FuseMaster 76512 Manual de usuario
Roadmaster
Roadmaster 917-3 Manual de usuario
Roadmaster
Roadmaster Hands-Free Bluetooth Car Kit VRBT330W Manual del propietario
Roadmaster
Roadmaster StowMaster ALL TERRAIN Manual de usuario
Roadmaster
Roadmaster 9300 Instrucciones de funcionamiento
Roadmaster
Roadmaster Sterling Instrucciones de funcionamiento
Roadmaster
Roadmaster 9700 Manual de usuario
Roadmaster
Roadmaster Sterling All Terrain Manual de usuario
Roadmaster
Roadmaster RLPF200 Manual de usuario
