5
Warranty
Your ROAD ANGEL Professional is guaranteed for one year from the date of purchase
from all manufacturing defects that occur with normal use. If your unit fails to perform as
specified in these instructions, please visit: http://www.roadangelgroup.com/warranty
You can also purchase theft-loss insurance. Visit http://www.roadangelgroup.com/ for
details.
Battery Power and Recharging
ROAD ANGEL Professional is a cable-free device; it can operate independently using
power from its internal rechargeable battery for up to 8 hours. You can also power ROAD
ANGEL Professional directly from the cigar socket in your vehicle.
The unit’s battery level is indicated by a five-bar meter on the right side of the display
(see page 5). The number of blocks shown indicates the current battery strength. You
can charge the battery using either the in-car cigar lighter adapter or the mains charger.
There is no need to wait until the battery is completely flat, unlike some rechargeable
devices. During the last 30minutes of battery life (approximation only) you will receive 3
separate warnings that the battery is low. The last will be heard moments before the
battery is completely flat. These will stop when the unit is being charged again.
IMPORTANT: Before you start to use your new ROAD ANGEL Professional, we
recommend that you fully charge it to preserve battery life and performance. For
optimised charging, use the mains charger and ensure that the unit is switched
off. It will take longer to recharge the battery if the unit is in use. In addition, the in-
car cigar lighter adapter provides a less efficient ‘trickle’ charge. It may take 24 hrs
to fully charge a unit in this way compared with only 6 hours on a mains charge.
To conserve battery power, the unit automatically switches off if it has been stationary for
5 minutes (you can disable or adjust this – see page 24). If the device has turned itself
off, a built-in motion sensor will switch the unit back on after a few seconds of motion.
You can put the unit into a ‘sleep’ mode by pressing the Standby button on the remote.
To switch the unit off completely, press the On/Off button on the top of the unit (for
approximately 2 seconds).
