Rigol DS1000C Manual de usuario

User’s Guide RIGOL

Publication number DS1-071026

October 2007

DS1000 Series Digital Oscilloscopes

DS1000CD, DS1000C, DS1000MD, DS1000M

RIGOL

User’s Guide for DS1000 Series

zRIGOL products are protected by patent law in and outside of P.R. China.

zInformation in this publication replaces that in all previously corresponding

material.

zRIGOL Technologies, Inc. reserves the right to modify or change pat of or all

the specifications and pricing policies at company’s sole decision.

NOTE:

RIGOL

is registered trademark of

RIGOL

TECHNOLOGIES, INC.

RIGOL

II © Copyright RIGOL Technologies, Inc. 2007.

User’s Guide for DS1000 Series

Safety Notices

Review the following safety precautions carefully before operate the instrument to

avoid any personal injury or to damage the instrument and any products connected

to it.

To avoid potential hazards use the instrument in a manner only as specified by this

user’s guide.

The instrument should be serviced by qualified personnel only.

To Avoid Fire or Personal Injury

Use proper power cord Use only the power cord designed for your oscilloscope

and authorized in your country.

Connect and Disconnect accessories properly. Do not connect or disconnect

probes or test leads while they are connected to a voltage source

Ground the instrument This oscilloscope is grounded through the protective

earthing conductor of the power cord. To avoid electric shock the grounding

conductor must be connected to earth ground. Before making connections to the

input or output terminals of the oscilloscope ensure that the instrument is properly

grounded.

Connect the probe properly. The probes’ ground terminals are at the same

voltage level with earth terminal of the instrument. Do not connect the ground

terminals to a high voltage.

Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings

and marks on the instrument. Follow the user’s guide for further ratings information

before making connections to the instrument.

Do not operate without Covers. Do not operate your oscilloscope with covers or

panels removed.

RIGOL

User’s Guide for DS1000 Series

Use Proper Fuse. Use only the fuse type and rating specified for this product.

Avoid Circuit or Wire Exposure. Do not touch exposed connections and

components when power is on.

Do not operate with suspected failures. If you suspect damage with this

product, have it inspected by qualified service personnel before further operations.

Provide Proper Ventilation. Refer to the manual’s installation instructions for

details as to the oscilloscope has proper ventilation.

UL/cUL or cCSAus certified probes must be used with the oscilloscope.

Do not operate in wet/damp conditions

Do not operate in an explosive atmosphere

Keep product surfaces clean and dry

RIGOL

IV © Copyright RIGOL Technologies, Inc. 2007.

User’s Guide for DS1000 Series

Safety Terms and Symbols

Terms in This Guide. These terms may appear in this guide:

WARNING: Warning statements identify conditions or practices that could

result in injury or loss of life.

CAUTION: Caution statements identify conditions or practices that could

result in damage to this product or other property.

Terms on the Product: These terms may appear on the product:

DANGER indicates an injury hazard may be immediately accessible.

WARNING indicates an injury hazard may be not immediately accessible.

CAUTION indicates that a potential damage to the instrument or other property

might occur.

Symbols on the Product: These symbols may appear on the Instrument:

Hazardous

Voltage Refer to

Instructions Protective

earth terminal Test

Grounding

Terminal

Grounding

Terminal

of Chassis

RIGOL

User’s Guide for DS1000 Series

General-Purpose Oscilloscopes

RIGOL DS1000-Series Digital Oscilloscopes offer exceptional waveform viewing

and measurements in a compact, lightweight package. The DS1000 series are ideal

for production test, field service, research and design and all of the applications

involving analog/digital circuits test and troubleshooting, as well as education and

training.

Each of these oscilloscopes gives you:

zDual Channel, Bandwidth:

100MHz (DS1102CD, DS1102C, DS1102MD, DS1102M)

60MHz (DS1062CD, DS1062C, DS1062MD, DS1062M)

40MHz (DS1042CD, DS1042C, DS1042MD, DS1042M)

25MHz (DS1022CD, DS1022C, DS1022MD, DS1022M)

zOptional 16 digital channels (Mixed signal oscilloscope), each channel can be

turned on or off independently, or in a 8 bit group

zMono/Color TFT LCD Displays at 320*234 resolution

zUSB storage and printing supports, firmware upgradeable via USB connectivity

zAdjustable waveform intensity, more effective waveform viewing

zOne-touch automatic setup for ease of use (AUTO)

zSaves 10 Waveforms, 10 setups, supports CSV and bitmap format

zNewly designed Delayed Scan Function, easy to give attention to both details

and overview of a waveform

z20 Automatic measurements

zAutomatic cursor tracking measurements

zWaveform recorder, record and replay dynamic waveforms

zUser selectable fast offset calibration

zBuilt-in FFT function, Frequency Counter

zDigital filters, includes LPF, HPF, BPF, BRF

zPass/Fail Function, optically isolated Pass/Fail output

zAdd, Subtract and Multiply Mathematic Functions

zAdvanced trigger types include: Edge, Video, Pulse width, Slope, Alternative,

Pattern and Duration (Mixed signal oscilloscope)

zAdjustable trigger sensitivity

RIGOL

VI © Copyright RIGOL Technologies, Inc. 2007.

User’s Guide for DS1000 Series

zMultiple Language User Interface

zPop-up menu makes it easy to read and easy to use

zBuilt-in Chinese and English help system

zEasy-to-use file system supports Chinese & English characters key-in

DS1000 Series Digital Oscilloscope accessories:

zTwo 1.5 meter, 1:1 10: 1 switchable probes

zDigital test set (Mixed Signal Oscilloscope only, DS1xxxxD), include

A data line (Model: FC1868)

An active logic head (Model: LH1116)

Twenty test wire (Model: LC1150)

Twenty logic clips (Model: TC1100)

zPower cord for country of destination

zUser’s Guide

zWarranty Card

zA Ultrascope for WIN98/2000/XP software

RIGOL

User’s Guide for DS1000 Series

Content

Safety Notices ..................................................................................................II

General-Purpose Oscilloscopes .......................................................................... V

CHAPTER 1: GETTING STARTED..................................................................... 1-1

The Front Panel and the User Interface ....................................................... 1-2

To Inspect the Instrument .......................................................................... 1-6

To Perform a Functional Check.................................................................... 1-7

To Compensate Probes............................................................................... 1-9

To Use Digital Leads (Mixed Signal Oscilloscope) ........................................ 1-10

To Display a Signal Automatically .............................................................. 1-12

To Set Up the Vertical Window.................................................................. 1-13

To Set Up the Horizontal System ............................................................... 1-15

To Trigger the Oscilloscope....................................................................... 1-17

CHAPTER 2: OPERATING YOUR OSCILLOSCOPE .............................................. 2-1

Understand the vertical system ................................................................... 2-2

Understand the Horizontal System............................................................. 2-30

Understand the Trigger System................................................................. 2-36

To Set Up the Sampling System ................................................................ 2-59

To Set Up the Display System ................................................................... 2-63

To Store and Recall Waveforms or Setups.................................................. 2-65

To Set Up the Utility ................................................................................. 2-73

To Measure Automatically......................................................................... 2-91

To measure with cursors........................................................................... 2-98

To use run control buttons.......................................................................2-105

CHAPTER 3: APPLICATION & EXAMPLES ......................................................... 3-1

Example 1: Taking Simple Measurements..................................................... 3-1

Example 2: View a signal delay caused by a circuit ....................................... 3-2

Example 3: Capture a Single-Shot Signal...................................................... 3-3

Example 4: To reduce the random noise on a signal...................................... 3-4

Example 5: Making Cursor Measurements .................................................... 3-6

Example 6: The application of the X-Y operation........................................... 3-8

Example 7: Triggering on a Video Signal .................................................... 3-10

Example 8: FFT Cursor measurement ........................................................ 3-12

RIGOL

VIII © Copyright RIGOL Technologies, Inc. 2007.

User’s Guide for DS1000 Series

Example 9: Pass/Fail Test .......................................................................... 3-13

Example 10: Triggering on a Digital Signal…………………………………………….….3-14

CHAPTER 4: PROMPT MESSAGES & TROUBLESHOOTING .................................4-1

Prompting Message ....................................................................................4-1

Troubleshooting..........................................................................................4-3

CHAPTER 5: SUPPORT & SERVICE ..................................................................5-1

CHAPTER 6: APPENDIX ..................................................................................6-1

Appendix A: Specifications ..........................................................................6-1

Apendix B: DS1000-Series Accessories .........................................................6-7

Appendix C: General Care and Cleaning .......................................................6-8

Index.............................................................................................................6-i

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de prueba de Rigol

Rigol

Rigol DS1000Z-E Series Manual de usuario

Rigol

Rigol DS2000 Series Guía de inicio rápido

Rigol

Rigol MSO1000Z series Instrucciones de funcionamiento

Rigol

Rigol MS05000-4CH Manual de usuario

Rigol

Rigol DS4024E Manual de usuario

Rigol

Rigol DHO1000 Series Manual de usuario

Rigol

Rigol HDO1000 Series Manual de usuario

Rigol

Rigol DS8000-R Series Manual de usuario

Rigol

Rigol MSO8064 Manual de usuario

Rigol

Rigol DG2000 Series Manual de instalación y operación

Rigol

Rigol MSO1000Z series Manual de usuario

Rigol

Rigol DS1104Z-S Plus Manual de usuario

Rigol

Rigol DS4000E Series Manual de usuario

Rigol

Rigol MSO1000Z series Manual de usuario

Rigol

Rigol DS1000E series Manual de usuario

Rigol

Rigol DS1000B Series Manual de usuario

Rigol

Rigol DS1000 Series Manual de usuario

Rigol

Rigol DS2000A Series Manual de usuario

Rigol

Rigol MSO4000 Series Manual de usuario

Rigol

Rigol DHO1202 Manual de usuario

Rigol

Rigol MSO4000 Series Manual de usuario

Rigol

Rigol DS6000 Series Manual de usuario

Rigol

Rigol MSO2000A Series Instrucciones de funcionamiento

Rigol

Rigol DS4000E Series Instrucciones de funcionamiento

Manuales populares de Equipo de prueba de otras marcas

SMART

SMART KANAAD SBT XTREME 3G Series Manual de usuario

Agilent Technologies

Agilent Technologies BERT Serial Manual de usuario

Agilent Technologies

Agilent Technologies N3280A Manual de usuario

Vernier

Vernier Go Direct Voltage Manual de usuario

Lifeloc

Lifeloc R.A.D.A.R. Manual de usuario

Fluke

Fluke T5-600 Instrucciones de funcionamiento e instalación

Mercury

Mercury TSL01 Manual de usuario

MAHA

MAHA MBT Series Manual de usuario

Fuji Electric

Fuji Electric P-61 Manual de usuario

ETC

ETC SealerAtor Manual de usuario

Skyfine

Skyfine ETHYWAY V2 Manual de usuario

Appion

Appion G5 Twin Manual de usuario

PCB Piezotronics

PCB Piezotronics 8159-0112A Manual de usuario

BW Technologies

BW Technologies MicroDock II Manual de usuario

Sun Nuclear

Sun Nuclear 1027 Manual de usuario

Biomark

Biomark HPR LITE READER Manual de usuario

Hioki

Hioki 3169-20 Manual de usuario

Ashcroft

Ashcroft ATE-100 Manual de usuario