Ricoh MP7320A Manual de usuario

NOTICE

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communication. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and

receiver.

● Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

● Consult the dealer or an experienced radio / TV technician

for help.

Warning as to USE

This CD-RW drive together with software is a product for

utilizing CD-R/RW recording media with rewriting, erasing and

readout capabilities, as an external computer memory device.

Except in the case where copying of CD-ROMs or the like is

especially recognized under the copyrights laws as being for

the purpose of individual use by the customer or the like, or in

the case where the customer has obtained permission to make

copies from the rightholder, reproduction of CD-ROMs and

subject to claims for damages and to penalties.

CAUTION

Rating voltage for peripherals.

1. Headphone Jack

Rating Voltage output Audio Signal Max. 2V

FCC WARNING

Changes or modification not expressly approved by the party

responsible for compliance could void the user's authority to

operate the equipment.

CAUTION

Use of controls or adjustments or performance of procedures

other than those specified herein may result in hazardous

radiation exposure.

Declaration of Conformity

"The Product complies with the requirements of the EMC

Directive 89/366/EEC and the Low Voltage Directive

73/23/EEC."

Please take notice that the manufacturer of this

equipment does not offer any warranty against data loss

due to inappropriate installation or handling, or direct or

indirect damages.

●

Please take notice that the manufacturer will bear no

responsibility for direct or indirect damages caused by

the use of this product or its malfunction.

●

Please take notice that the manufacturer will bear no

responsibility for damage to data caused by this product.

●

Please backup (copy) all important data as protection

against data loss.

●

PC DOS is a trademark of IBM Inc.● MS-DOS, Windows, Windows ® 95, Windows ® 98/98SE, Windows ® Me, Windows NT®,

Windows® 2000, Windows® XP*1 are trademarks registered in the United States and other

countries by the Microsoft Corporation.

●

The company names and product names written in this manual are trademarks or registered

trademarks.

●

*1 For information on Windows® XP supports, visit Ricoh's Web site.

This manual uses the following symbols to indicate important information relating to the drive.

Failing to comply with the information in this manual and/or incorrect handling of the drive

may result in serious personal injury or damage to the product.

Indicates restriction or precaution that should be observed.

Provides useful additional information.

This manual contains important notes and product handling information. Be sure to read the

manual before using the product. For easy reference in the future, please keep the manual

at a handy location.

Multimedia Printer series

Thank you for purchasing the Multimedia Printer series drive MP7320A (hereafter referred to as the

drive). The drive enables you to play CD-ROM media, write once and play CD-R media, or write, play,

and rewrite CD-RW media.

The following marks indicate media that can be used with the drive.

A technology called JustLinkTM incorporated

that overcomes buffer underrun problems

Buffer underrun errors that would occur when data transfer falls behind writing operation has been

inevitable for CD-RW drives. JustLinkTM, which we at Ricoh developed on our own, is a technology

that predicts possible occurrences of buffer underrun errors in advance and automatically avoids them.

The MP7320A is the industry's drive that features JustLinkTM. With this technology, the MP7320A

ensures stable writing operation even under circumstances where buffer underrun errors tend to occur

with conventional drives.

JustSpeedTM (Optimum Write Speed Control

function)

This is a function to automatically set an appropriate media write speed to match the capability of the

media used.

Obey the following cautions when handling the drive or discs.

Cautions During Installation

Install the drive in accordance with the specifications. Be careful to avoid locations

likely to cause vibration or shock.

●

Avoid locations where there is high humidity, excessive dust, or poor ventilation.●

Avoid locations in direct sunlight, with severe changes in humidity, or places where

there are extremely high or low temperature variations.

●

Don't use the drive near radio or television receivers. It may interfere with their

reception.

●

Do not disassemble the drive. Dismantling the drive to attempt repairs or for other

reasons is dangerous because the laser may radiate outside the unit.

●

Cautions During Use

Don't suddenly move the drive from a cold place to a warm place, or suddenly raise the

room temperature. Condensation may occur, causing abnormal operation.

●

Make sure to remove the disc before moving the drive. The disc may be damaged,

causing data loss.

●

Be careful to prevent foreign objects such as liquids or metal from entering the drive.

Should by chance a foreign object enter the drive, please consult the dealer where the

drive was purchased.

●

Don't use benzene or thinner to clean dirt from the drive. Don't allow chemicals such

as insecticides to contact the drive. Use a soft cloth to wipe the drive, or moisten a

cloth with neutral detergent diluted with water and use it to clean particularly dirty

areas.

●

Don't cutoff the electric power while the drive is operating.●

When connecting two E-IDE devices to the Primary or Secondary connectors, make

sure that the two devices are not both configured as Master, or both as Slave. If they

are both set the same, Windows may fail to run or recognize the drives.

●

The total length of the E-IDE cable should be less than 18 inches (about 45 cm).●

Make sure the power to the host computer is turned OFF before connecting.●

Never insert a damaged disc into the drive.●

In wintertime, don't use a disc soon after bringing in from outdoors. Use it only after it●

has reached room temperature.

Cautions Concerning Disc Cleaning

Remove the disc by pressing the eject button.●

Use compressed air to clear dust from the disc. (Spray the compressed air for about 5

seconds).

●

Check to see if there is dirt on the surface of the disc. Be careful not to touch the disc

with the fingers when doing this. (See Fig. 1)

●

After cleaning the disc with compressed air, place it on the disc tray and mount it.(See

Fig. 2)

●

We suggest using dry air cleaner as compressed air for cleaning.●

Other Cautions

When moving the equipment, make sure that the disc has been removed from the

drive.

●

When connecting connectors, make sure that the power is OFF. If the power is ON,

there is a possibility of short circuit.

●

When not using the drive for a long period, dust may adhere to the disc tray. Before

using the drive again, use dry air cleaner to remove the dust from the tray.

●

Do not use any commercially available cleaning kit, because such a kit may damage

the drive.

●

fig1

Check1. Recording surface2.

fig2

50 to 100mm1.

Back

JustLinkTM has made auto-avoidance against buffer underrun

errors possible.

●

JustSpeedTM Optimum Write Speed Control function.● An improved anti-heat design means that no cooling fan is needed.● Easy-to-use tray model.● Enhanced-IDE (ATAPI) model● Compliant with industry standard Orange Book Part II (CD-R) and Part III (CD-RW).● Can read not only CD-R and CD-RW media, but also video CDs, music CDs, photo

CDs*1, and CD-Text

●

Can read data at 40x speed (6.0MB/sec data transfer rate), write data at 32x speed

(CD-R, 4.8MB/sec data transfer rate.) and write data at 10x speed *2(High Speed

CD-RW, 1.5MB/sec data transfer rate).

●

The recorded CD-RW media can be played in a DVD player or a multi-read CD-ROM

Player, maintaining future compatibility.

●

Supports random UDF for easy writing to CD-RW media.● Offers the Optimum Write Speed Control function● UDMA-capable

*1 Bundled software does not support this writing format.

*2 The speed at which to write on the current standard CD-RW media is 4x

recording (at a data transfer rate of 600KB/second).

●

Explains the system environment required for using the drive as a CD-R/CD-RW drive.

PC IBM PC/AT compatible

Operating System Windows Me/98/98SE/95(ORS2 or later)

Windows NT Workstation Ver.4.0 (Service Pack 5) or later

Windows 2000 (Professional)

Windows XP*1

CPU Pentium 166 MHz or higher (When using JustLink)

Memory 64MB or more

Hard disk Hard disk with average access time of 19msec or less, and data transfer speed of

2,500KB/sec or greater. 1GB or more free space.

Interface Enhanced-IDE interface (as Primary Slave, Secondary Master, or Slave)

Drive bay 5.25-inch half height bay required

Power +5V/+12V power socket required

Recommendation media*3 Recommendation Tested to be compatible

CD-R Ricoh Taiyo Yuden, Mitsui Chemicals, Mitsubishi

Chemical, Maxell

CD-RW Ricoh Mitsubishi Chemical*2

High Speed CD-RW Ricoh Mitsubishi Chemical

*1 For information on Windows XP supports, visit Ricoh's Web site

*2 The media written using the CD-R/RW drive may not be readable by CD-ROM drives.

Multi-read compatible (Random UDF compatible) drives are necessary.

*3 Even if it is the recommendation disc, some of discs may have possibility to fail

writing with highest writing speed with the problem on the disc. In this case, please

try to write with lower writing speed, or please try to use another disc.

Multi-read compatible (Random UDF compatible) drives are:

Drives that can read low reflectivity discs.● Drives that support Packet Write.●

Front Panel

Rear panel

Front Panel

1. Disc tray

This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push the eject

button) and the disc will be mounted.

Caution

Don't use force to pull out or push in the disc tray. This might cause damage to the loading section

of the drive.

2. Headphone jack

This jack is for connecting headphones or mini-speakers.

3. Volume control

This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output volume for

the audio output connectors on the rear panel.

Caution

Turn the volume down before turning on the power. Sudden loud noises can damage your hearing.

Tabla de contenidos

Otros manuales de Unidad de CD/CDR de Ricoh

Manuales populares de Unidad de CD/CDR de otras marcas

Philips

Philips CDD3610 Manual de usuario

QPS

QPS Que!Fire Manual de usuario

LG GCC-4241N Manual de usuario

Plextor

Plextor 12X-3 Guía

Samsung

Samsung SN-324B Manual de usuario

Teac

Teac CD-211E Manual de usuario

SmartDisk

SmartDisk Firewire CD-R/W Manual de usuario

Axis

Axis CD-ROM SERVER Manual de usuario

LG CRD-8322B Manual de usuario

Memorex

Memorex 32023234 - 52x32x52x External USB2.0 CD... Instrucciones de instalación

Yamaha

Yamaha CD Recordable/Rewritable Drive CRW3200 Manual de usuario

Sony

Sony CRX230AE Manual de usuario

Sony

Sony CRX - 160E Manual de usuario

Panasonic

Panasonic KX-LD742 Manual de usuario

Pioneer

Pioneer BDR-S13U-X Manual de usuario

Panasonic

Panasonic LK-MC606BP Manual de usuario

Panasonic

Panasonic CF-VCW Series Manual de usuario

LG CRD-8320B Manual de usuario