Software Version: 2.3.3 Date: 8 August, 2012 Page 2/46
TABLE OF CONTENTS
1. INSTALLATION 5
1.1 INTRODUCTION 5
1.2 ANALYZER INSTALLATION 5
1.2.1 SPLIT TYPE INSTALLATION 5
1.2.2 WEATHER PROOF HOUSING INSTALLATION 7
1.3 SENSOR INSTALLATION 8
1.4 INSTALLING THE CABLES 8
2. CONFIGURATION. 11
2.1 INTRODUCTION 11
2.1.1 TOUCH SCREEN FUNCTIONS 11
2.1.2 PREPARATIONS 11
2.2 ANALOG OUTPUT CONFIGURATION 12
2.2.1 PROCEDURE 12
2.2.2 OUTPUT SOURCE 12
2.2.3 OUTPUT SCALING 13
2.2.4 ERROR COMMUNICATION THROUGH ANALOG OUTPUTS 13
2.2.5 DECAY TIME 14
2.3 DISPLAY CONFIGURATION 14
2.3.1 SELECTING THE RESULTS 14
2.3.2 SETTING THE DISPLAY RESOLUTION 15
2.3.3 DISPLAY SMOOTHING 15
2.3.4 GRAPH SCALING 15
2.3.5 BACKLIGHT TURN OFF TIME 16
2.4 SENSOR PARAMETERS 16
2.4.1 INTRODUCTION 16
2.4.2 PROCEDURE 16
2.4.3 INSTRUCTIONS: 16
2.4.4 AUTO DEAD TIME 17
2.5 ALARM CONFIGURATION. 18
2.5.1 INTRODUCTION 18
2.5.2 PREPARATION. 18
2.5.3 PROCEDURE 18
2.6 TROUBLE SHOOTING 19
2.6.1 PREPARATION. 19
2.6.2 MEMORY STICK LOGGING 19
2.6.3 PROCEDURE TO STOP LOGGING ON USB MEMORY STICK 19
2.6.4 VERIFYING THE ULTRASONIC SIGNAL WAVEFORM 22
2.6.5 FACTORY DIAGNOSTICS TO USB 24
2.6.6 HARD COPYING SCREENS 25
3. LIQUID SELECTION AND EDITING 26
3.1 LIQUID (PRODUCT)SELECTION 26
3.1.1 PURPOSE: 26
3.1.2 PROCEDURE (MANUAL SELECTION): 26
3.1.3 PROCEDURE (REMOTE SELECTION): 26
3.2 EDITING LIQUIDS (POLYNOMIAL CALIBRATIONS) 26
