Response CWK2 Manual de usuario
Wired Colour Camera(s)
and 2 Channel Digital Video
Recorder (DVR) CCTV
CWK2/CWK3
Installation and Operating Instructions
These instructions should be retained in a safe place for future reference.
2
1INTRODUCTION 3
2KIT CONTENTS 4
3FEATURES 5
4INSTALLATION 6
4.1 System Connection 6
4.2 Camera(s) Installation 7
5PANEL INTRODUCTION 9
6OPERATION 10
6.1 Keys - Functions 10
6.2 Changing Between Real Time
Viewing and Playback Mode 11
6.3 Channel Selection 11
6.4 Manually Taking a Photo Shot
or a Video Clip 11
6.5 Menu Icons Definition 12
6.6 System Setup 12
6.6.1 Date/Time Setup 13
6.6.2 Motion Detection
and Advance Setup 13
6.7 Playing Back Recorded
Photos/Video Clips 14
6.8 Memory Overwrite Indication 15
6.9 Deleting Recorded Files 15
7SYSTEM CONFIGURATION 16
8TROUBLE SHOOTING 17
9TECHNICAL SPECIFICATION 18
10 ACCESSORIES IN
THE RANGE 20
11 DISPOSAL – RECYCLING
INSTRUCTIONS 21
12 GUARANTEE AND
CUSTOMER HELPLINE 22
Please read before you start:
Always use discretion when installing CCTV surveillance equipment especially
when there is perceived policy. Enquire regarding local regulations applicable
to the lawful installation of video recording/surveillance. Third party consent
may be required.
CONTENTS
3
INTRODUCTION Section 1
The Response 2 Channel DVR Camera(s) Kit is a monitoring system designed to capture
photos or 10 second video clips of any motion viewed by the camera(s) and store them in
memory. It allows up to 2 wired cameras to connect to it. The wired cameras are colour,
weatherproof and suitable for day/night use. They easily connect to your DVR for the
protection of your home, office, etc.
SAFETY AND INSTALLATION TIPS:
DVR
●Keep away from heat sources and high temperature places, above 40°C
●Avoid direct sunlight
●Avoid humid places
●Avoid vibration
●Install in a ventilated environment
Camera(s) and DVR
Do not attempt to open the units with the power adaptor plug connected to avoid any risk
of personal injury.
When installing CCTV camera(s), always follow manufacturer’s advice when using power
tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety goggles) when
drilling holes. Before drilling holes through walls check for hidden electricity cables and
water pipes. The use of a cable/pipe detector is advisable.
When installing any cameras with this unit, it is advisable to use cable conduit to protect any
video/power extension cables from being exposed externally and to prevent/reduce the
chances of the cables being tampered with. After drilling any hole though an external wall
for a cable, ensure the hole is sealed up around the cable using a sealant to prevent drafts.
To prevent a fire or electrical shock hazard, do not attempt to open the housing while the
unit is exposed to rain, water or wet conditions. There are no user serviceable parts
inside. Refer servicing to qualified service personnel.
NIGHT VISION:
The cameras have built-in infra-red LEDs to allow you to view at night for 24hrs
surveillance. The LEDs will automatically activate at night and the picture viewed will turn
to black and white.
4
KIT CONTENTS Section 2
CWK2:
1x2 Channel DVR unit
1xWired Colour Camera
1x10m extension cable
1xDIN to RCA adaptor lead assembly
1xVideo output to TV cable (1m)
1xPower supply adaptor for DVR unit (12V/1.2A)
1xPower supply adaptor for camera (12V/300mA)
1xSD memory card (2GB)
1xCamera fixings kit
2xWindow stickers
1xInstallation and operating manual
CWK3:
1x2 Channel DVR unit
2xWired Colour Cameras
1x10m extension cable
1x20m extension cable
1xDIN to RCA adaptor lead assembly
1xVideo output to TV cable (1m)
1xPower supply adaptor for DVR unit (12V/1.2A)
2xPower supply adaptors for cameras (12V/300mA)
1xSD memory card (2GB)
1xWindow sticker
2xCamera fixings kit
1xInstallation and operating manual
Tools Required:
Electric drill
5mm masonry drill bit
20mm masonry drill bit
No. 2 Philips screwdriver
3mm flat blade screwdriver
5
FEATURES Section 3
●2 channel video imput/1 channel video output
●SD card technology
●Photos recorded in JPG format/video recorded in AVI format
●Motion detection
●Preset NTSC/PAL system input
●Time and date stamp
●Picture in picture display (view one camera channel in another camera channel)
6
INSTALLATION Section 4
4.1 System Connection
Key to DIN plug colours:
White plug – Camera channel 1
Yellow plug – Camera channel 2
Black plug – Video output
Red plug – 12VDC power in
Note: If this DVR is used with the Wireless Camera and Receiver Kit (CWFK1) the video
output from the receiver is connected to the camera channel 1 or 2 plugs to view the
wireless camera.
DIN IN
VIDEO IN 2 VIDEO IN 2
GND VIDEO OUT
GDN POWER IN
Not used In
this model
Extension Cable(s)
DVR Power
Supply Adaptor
TV / MONITOR
Video Signal
to Input
Camera Power
Supply Adaptor
Camera Power
Supply Adaptor
CAMERAS
DVR
7
4.2 Camera(s) Installation
1. Remove the bracket from the camera by unscrewing it from the main body as shown
below:
2. Use the base of the camera’s bracket to mark out the 3 mounting holes on the chosen
surface. Mark out a hole for the cable connectors to pass through into the property
next to the camera.
Note: It is recommended to pass the cable into the property as close to the camera as
possible to reduce the chances of any exposed cables being tampered with. If you
choose to run the cable along the wall outside the property, it is recommended to use
cable conduit to hide the cable and reduce the chances of it being tampered with.
3. Drill 3 x 5mm mounting holes for the bracket’s wall plugs and 1 x 20mm hole for the
camera’s power and video connectors to pass through the wall.
4. Install the camera bracket using the supplied wall plugs and screws.
5. Feed the video/power leads through the hole in the wall, starting with the largest
connector, and then refit the camera on to the bracket and adjust the position of the
camera body as required by loosening the adjustment screw.
6. The camera is supplied fitted with a 1m cable terminated with a RCA female plug and
a female power connector.
7. Connect the male end of the power connector from the extension cable into the
camera along with the male RCA connector.
8.
Connect the RCA video end of the extension cable into video input plug of your DVR.
If only one camera is connected to the DVR, then connect this to the channel 1 plug
(white colour).
Camera body position
adjustment nut
Unscrew this washer nut to loosen Camera body
from the bracket and unscrew Camera
8
9. Insert the SD card into the DVR if not already fitted.
10. Turn ON the DVR using the power switch.
11. Tune your TV to auxiliary (AUX), A/V or video mode to view the camera.
(Note: Refer to your TV/VCR/DVR’s owner’s manual for setting this up).
12. Adjust the camera again if necessary to the desired viewing angle.
Note: If the supplied extension cable is not long enough, the extension cable for a camera
can only be extended up to 30m in total length due to power loss.
9
PANEL INTRODUCTION Section 5
6. DISP (Display) Key
7. Up Key
8. Right Key
9. ●Enter Key
10. Down Key
11. Left Key
12. SD Card
Key to controls:
1. DIN IN
(2 channel video input;
2 channel output;
12VDC/1.2A Power IN)
2. MODE Key
3. SNAP Key
(Take Photo or Record)
4. MENU Key
5. Power ON/OFF Switch
2
MODE
SNAP
MENU
DISP
POWER
STATUS
POWER
3
4
6
7
8
9
10
11
5
1
12
OPERATION Section 6
6.1 Keys - Functions
10
Reference Key Real time mode Play back mode Setup menu
to diagram (Live viewing)
2Mode Switch to play Switch to real
back mode time mode
4Menu Setup menu Delete files menu Exit setup menu
appears (for video
clips, the Menu key
only functions at the
beginning or end of
a clip)
9Enter Display full screen Confirm an item
(or OK) of a selected photo
shot or exit full screen
6Display Switch between
channel 1 and
channel 2. If in
photo mode then
view one channel
in another (picture
in picture)
3Snap Take a photo or
record a video Clip
11 Left Move to left photo/ Move to left item.
video clip Select the motion
detect area.
Move the motion
detect area to left
8Right Move to right photo/ Move to right
video clip item. Select the
motion detect
area. Move the
motion detect
area to right
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cámara de seguridad de Response
Response
Response CWK1 Manual de usuario
Response
Response CWK1 Manual de usuario
Response
Response CWFK2 Manual de usuario
Response
Response CA5 Manual de usuario
Response
Response CWK4 Manual de usuario
Response
Response CA11 Manual de usuario
Response
Response CWD2 Manual de usuario
Response
Response CA10 Manual de usuario
Response
Response CA8 Manual de usuario
