Resolution Products RE310P Plus Manual de usuario
RE310P+_New_DSC-Compat_PIR_InstructionsPage 1 of 3 30-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
RE310P+ DSC-Compatible PIR Motion,
TWO 60-Pound-Do -Immune
Features
• PYROFLEX™ IR sensor and HighBar™ signal processing or superior per ormance
• Unparalleled Pet Immunity and Catch per ormance
• 44 oot range and 90 degree ield o view (45 degrees to each side)
• Mountable on Flat-wall, 45 degree corner, or swivel/gimbal (sold separately).
• Unique external contact on separate, but related, wireless ESN
• Cover tamper.
• Strong, reliable RF signal.
• 6-8 year battery li e on CR123A battery.
• Low Battery indication.
Key Instructions
• Mount at 7.5 oot height or optimum per ormance between: Catch
per ormance, Pet Immunity and False Alarm prevention.
• Motion Sensitivity:
Jumper on BOTH PINS or Normal sensitivity
Jumper on ONLY 1 PIN or High sensitivity.
• External contact activation (enabling):
Insert battery while holding Tamper switch.
Seal wire routing hole.
• Make sure bug / insulation foam is installed
• Enrolling:
Enter Wireless Enrollment Mode in DSC Panel.
PIR: Open tamper switch. ESN = 3xx xx0
External Contact: Trip contact ESN = 2xx xx1 (x’s same as PIR’s)
Con irm ESN, Enter Zone # and Zone Type on DSC panel.
• LED Walk Test: Press Tamper or 3 minute test:
LED lights when motion sensed
Sensor re-calibrates or 10 to 30 seconds a ter each LED blink.
It will not transmit during re-calibration.
So wait about 30 seconds be ore irst test, and 30 seconds between
tests.
Wireless transmissions sent or each detection, so walk test can be used
or panel operation test as well
Available or…
GE
Honeywell
DSC
Napco
2GIG
RE310P+_New_DSC-Compat_PIR_InstructionsPage 2 of 3 30-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Operation
• Motion sends wireless transmission a ter 2 or 3 (select via jumper) pulses.
• Motion stops (locks out) transmitting wireless sensor alarms for 3 minutes
after sending an alarm transmission. This is to conserve battery li e.
• Tamper, when cover is opened (only Motion reports tamper, not Ext Contact).
• Supervisories, every hour (including Ext Contact, i activated).
pecifications
Pet Immunity: Two 60 pound dogs
Mounting hardware: #4 or #6 screws
Mounting height: 7.5 t
Replacement Battery: CR123A 1550mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.5x2.4x1.7 inches
Speci ications subject to change without notice.
Use this model or ALL pet situations.
RE020 Horizontal Beam Lens also available or unique situations.
Internal Picture
Walk Test
LED
ensitivity
Jumper
7.5 ft
10 ft
20 ft
30 ft
40 ft
Battery
+
Motion ensor
Tamper &
Walk Test
witch
0
56 ft
56 ft
56 ft
40 ft
Bug
Foam
External
Contacts
RE310P+_New_DSC-Compat_PIR_InstructionsPage 3 of 3 30-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Notices
“GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell
International Inc , and Tyco Safety Products Canada LTD, respectively
Resolution Products, Inc products will function with one of either GE, DSC or Honeywell systems
However, no Resolution product is produced by, endorsed by, nor is officially associated with GE,
Honeywell or DSC Resolution recommends verifying proper enrollment and operation, per control
panel installation instructions, at installation
Warranty
Resolution Products, Inc will replace products that are defective in their first five (5) years
FCC Notice
This device complies with Part 15 of the FCC rules Operation is subject to the following two
conditions:
This device may not cause harmful interference
This device must accept any interference that may be received, including interference
that may cause undesired operation
Changes or modifications not expressly approved by the Resolution Products, Inc could void
the user's authority to operate this equipment
FCC ID: U5X-RE310
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s) Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may
cause undesired operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement
IC: 8310A-RE310
Otros manuales de Sistema de seguridad de Resolution Products
Manuales populares de Sistema de seguridad de otras marcas
EDM
EDM Solution 6+6 Wireless-AE Manual de usuario
Highway Safety Group
Highway Safety Group EA401 Manual de usuario
Siren
Siren LED GSM Manual de usuario
Detection Systems
Detection Systems 7090i Instrucciones de montaje
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manual de usuario
Siemens
Siemens FDM273 Manual de usuario