Rekon FPV Rekon3 Manual de usuario
1
rekonfpv.com
Rekon3 FPV Racing Drone
Manual
2
Rekonfpv.com
Product Specifications.............................................................................................................................1
Interface Description...............................................................................................................................2
Check the flight control drive................................................................................................................3
Calibration accelerometer......................................................................................................................4
UART serial port use.................................................................................................................................5
WIFI function instruciton.......................................................................................................................6
Select aircraft model.................................................................................................................................7
Choose ESC protocol..................................................................................................................................8
Voltage parameters setting.....................................................................................................................9
Setting up the receiver..............................................................................................................................10
VTX serial port use....................................................................................................................................11
Check receiver signal................................................................................................................................12
Select flight mode startup mode...........................................................................................................13
OSD settings.................................................................................................................................................14
LED settings.................................................................................................................................................15
Troubleshooting.........................................................................................................................................16
.......................................................................................
Package IncIuded
HGLRC Rekon3 FPV Racing Drone*1
Accessory Package*1
3
Rekonfpv.com
1.Product Specifications
Product parameters
Model
Rekon3 VTX FPV Racing Drone
Frame Kit
Rekon3 Frame Kit
Flight Controller
Zeus5 AIO Flight Controller
VTX
Zeus nano 350mW
Motor
1202.5 Motor
1S KV11600
Support Neceiver
SBUS .DSMX.CRSF
Input Voltage
1S Lipo
Weight
62.5g
4
Rekonfpv.com
2.Interface Description
5
Rekonfpv.com
3.Check the flight control drive
1. Long Press BOOT buttons.connect USB.The system automatically
install the driver
2.Driver cannot be installed, please download ImpulseRC_Driver_Fixer
3.Double-click on the run(Plug in the flight controller to automatically
install the driver)
4.open betaflight configurator ，enter DFU mode
6
Rekonfpv.com
5.Click Select firmware version
6.Click Load firmware.Waiting for
completion It will be prompted upon
completion.
7. open betaflight configurator .Controller plugged into the
computer. Betaflight Automatically assigned port，click “Connect” Enter
setup interface（Different computer COM）
7
Rekonfpv.com
4. Calibration accelerometer
1. Put the aircraft horizontal and click“Reset Z axis”
Click again
5.UART serial port use
1.UART1 uses WIFI
Open WIFI CLI command:
‘’resource PINIO 1 B10
serial 0 1 115200 57600 0 115200
set pinio_config = 129,1,1,1
set pinio_box = 0,255,255,255
SAVE‘’
8
Rekonfpv.com
2. UART2 uses receiver
S5 is a soft serial port, dedicated to video transmission (VTX) FM
CLI command of soft serial port:
‘’resource MOTOR 5 none
resource SERIAL_TX 11 B03
SAVE‘’
6.WIFI function instruciton
1.Click Select Ports
2.Install Speedy Bee on your mobile phone. Connect to WIFI name
Started with HermesXXXX.
3.Then click connect to adjust the parameters normally.
4.If the WIFI module light is solid, it means the WIFI is connected to the
mobile phone.。
5.If the WIFI module light is solid, but conection is abnormal. Please
check your wifi / Speedy Bee settings.
Note: Flight Controller must be powered by battery to connect to WIFI
9
Rekonfpv.com
7.Select aircraft model
1.Click Select model
2.Click Click “I understand the risks”Push Master to check motor
steering“Master”Steering can be changed at BLHeliSuite
10
Rekonfpv.com
8.Choose ESC protocol
9.Voltage and current
parameters setting
1.Click Setting parameters
Tabla de contenidos
