It is necessary to engage the control knob
in the correct position on the flow valve
spindle before the front cover is located.
1. Ensure the 2 x backplate fixing screws are
fully tightened (fig.B).
2. Before replacing the front cover, check that
the flow valve spindle and the control knob
are rotated fully clockwise (fig.G).
3. Refit the front cover with the 3 x fixing screws
DO NOT switch on the power to the handwash
unit until the commissioning procedure has been
carried out.
IMPORTANT: Turn the control knob fully
anti-clockwise until the valve is fully open.
This will ensure a fast fill up of the
handwash.
Let the water flow through the handwash unit to
release any air which may be in the system and
fill the handwash with water.
IMPORTANT: When a steady water flow is
evident, turn the control knob fully
clockwise to the off position.
IMPORTANT: The handwash unit must be
full of water before the power is switched
on.
1. Make sure that the electrical supply has been
isolated at the isolating switch.
2. Ensure the water supply is fully on at the
mains and the isolating service valve (if fitted)
is fully open, check that water is not leaking
from the bottom of the case.
3. Turn the control knob anti-clockwise to the full
cold position.
4. Check that the water flows freely from the
handwash within a few seconds.
The water from the patented ‘Vortex’
sprayhead will be at full force and at a cool
temperature.
5. Rotate the control knob slowly clockwise.
This will gradually reduce the water flow with
the water temperature remaining cool.
6. Rotate the control knob fully anti-clockwise to
return to maximum water flow.
7. Switch on the mains electrical supply at the
isolating switch.
The ‘Power’ neon indicator will illuminate.
8. Turn the control knob clockwise and check
that the water gets warmer,
Turn anti-clockwise and check the water
gets cooler.
Wait a few moments for the temperature
of the water to stabilise.
NOTE: When the water temperature is
changed the flow rate alters.
9. Turn the control knob fully clockwise to stop
the water flow.
1. The mains electricity and water supply should
normally be left on.
The flow of the water is controlled by a tap,
which is incorporated inside the unit.
2. Turn the knob anti-clockwise 180° (fig.H).
This will, in the majority of cases, provide a
suitable temperature for washing hands.
However, in extreme conditions,
i.e. mid-winter or mid-summer, the
temperature of the water can be adjusted to
suit.
3a. If the water is too hot,
then increase the water flow by,
Turning the control knob anti-clockwise
Wait a few moments for the temperature
of the water to stabilise (fig.H).
Repeat turning anti-clockwise if necessary
until you get the water temperature of your
liking.
