6
ϪϪϪʳ
ILLUSTRATION OF 2-WAY CONTROLLER
ʳ ϪϪϪʳ
LEARNING TRANSMITTER CODES:
Step 1
: In disarmed mode, turn the ignition switch ON/OFF five times (each time must be
finished within 1 second, or alarm system will skip it) and keep the ignition switch to "ON"
position, siren will echo 4 chirps.
Step 2:
Within 10 seconds, press button
҇ʹʳ
Ζ
ʳ
of new transmitter for learning. When the
first transmitter code is learned, all other previous codes will be erased, which is protecting
your alarm system from all other codes entering without your knowledge.
ITEM TRANSMITTER SYSTEM CONFIRMATION
1. The1
st
transmitter One siren burst and one siren chirp.
2. The2
nd
transmitter One siren burst and two siren chirps.
Step 3
:Turn off the ignition switch or 10 seconds of no transmitter activity, alarm system
will skip automatically the code-learning program and siren will chirp once.
THE OTHER FUNCTIONS OF 2-WAY CONTROLLER:
1.
Power saving function: press button
҈
+
Ζ
at the same time.
1. Short beep Power saving function is ON
2. Long sound Power saving function is OFF (Factory default)
When disarming the system and the power saving function is on, 70 seconds later, the
2-way controller will shut off the power automatically.
NOTE
ˍ
ʳ˧˻˸ʳ˅ˀ˴ʳ˶˿˿˸ʳ˶˴ʳ˼ʳ˻˸ʳ˸
’
ʳ˴ʳ˼ʳ˻˸ʳ˿˴ʳ˷ʳ˴˼˺ʳ˷˸ʳ
˻˸ʳ˻˸ʳ˸ʳ˴˼˺ʳ˹˶˼ʳ˼ʳˁ
2.
Silent function (Vibration function): press button
҉
+
Ζ
at the same time.
The LCD screen will appear ,and all confirmation sound will turn off except the
sound for alarm.
3.
Turn on backlight of LCD: press button
҇ʳ ʹʳ Ζ
at the same time.
The backlight will turn on for 3 seconds if no other button is pressed.
4.
Timer indicator: There are three types of timer as follows:
(1) Timer of arming: When the system enters arming mode or silent arming mode, the
timer will initialize. The maximum interval for timer is 19 hours and 59 minutes.
(2) Timer of engine warm-up: When the engine starts successfully by remote, the timer
will initialize.
(3) Turbo timer: Please refer to page 4.
5.
Low voltage indicator:
When battery becomes exhausted, the icon of on the LCD screen will disappear. For
some battery, it will only have the low sound confirmation. Please change the battery for
the controller at this moment.
6.
How to change battery:
First of all, unlock the cover and slide it off, it will beep once and all icons will turn on
for a while after putting on the new battery. If there is no beep after changing the battery,
please take out the battery and reinstall it after 30 seconds. If you want to retain the data
of timer, put on the battery within 30 seconds.
ϡ
After changing of battery, make sure the cover is properly closed and lock it.
ϡ
ALKALINE battery is recommended.
