Radio Shack 21-533 Manual de usuario

Cat. No. 21-533

OWNER’S MANUAL

Please read before using this equipment.

CB/Ham Field-Strength

SWR Meter

21-533.fm Page 1 Thursday, August 5, 1999 3:47 PM

RadioShack is a registered trademark used by Tandy Corporation.

INTRODUCTION

Your RadioShack CB/Ham Field-Strength SWR Meter helps

you tune your CB or amateur radio system for the best per-

formance.

CB and amateur radio systems work best when the antenna

system’s impedance matches the transmitter’s output im-

pedance as closely as possible. The meter’s standing wave

ratio (SWR) function helps you trim your antenna to the pre-

cise length you need for the maximum transmitted power.

The meter’s field strength function helps you position your

antenna for the best coverage and determine the effective-

ness of changes you make to your antenna, antenna cable,

and transmitter.

Carefully read all of these instructions to get the best use

from this meter.

Warning: You can use this meter to make measurements

on equipment that uses high voltages. Carefully observe all

safety precautions provided with the equipment you are test-

ing.

Note: You need a separate 50-ohm coaxial cable (such as

RG-58U) with a PL-259 connector connected to both ends

(such as Cat. No. 278-968, not supplied), long enough to

reach from your radio’s antenna jack to the back of the

meter.

21-533.fm Page 2 Thursday, August 5, 1999 3:47 PM

CONTENTS

Measuring SWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Connecting the Meter . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Calibrating the Meter/Measuring SWR . . . . . . . . . . . . . 5

Interpreting SWR Readings . . . . . . . . . . . . . . . . . . . 8

Improving SWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Measuring Field Strength . . . . . . . . . . . . . . . . . . . . . . . . 10

Preparing the Antenna Site . . . . . . . . . . . . . . . . . . . . 11

Calibrating the Meter/Measuring Field Strength . . . . . 13

Using Field Strength Readings to Tune Your Radio

and Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . 19

Schematic Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22

21-533.fm Page 3 Thursday, August 5, 1999 3:47 PM

MEASURING SWR

Measuring SWR shows you how muchof your radio’stransmit

power is reflected from the antenna back into the antenna ca-

ble, generating heat and wasting power.With this information,

you can adjust the length of your antenna or antenna cable so

your antenna and radio combination can produce the maxi-

mum power they are capable of producing.

For more information about measuring SWR, see the

ARRL

Handbook

, available at your local library.

CONNECTING THE METER

To connect this meter to your CB or amateur radio and your

antenna, you need RG-58U coaxial cable (not supplied) with

a PL-259 connector on both ends (such as RadioShack Cat.

No. 278-968). The cable must reach from the back of the

meter to your radio’s antenna jack.

Follow these steps to connect the meter to your radio and an-

tenna.

21-533.fm Page 4 Thursday, August 5, 1999 3:47 PM

1. Turn off your radio. Then disconnect the antenna from

the radio and plug it into ANTENNA on the back of the

meter.

2. Plug the coaxial cable into the radio’s antenna jack and

into TRANSMITTER on the back of the meter.

CALIBRATING THE METER/

MEASURING SWR

1. Set CALIBRATION/FS/SWR on the front of the meter to

CALIBRATION/FS.

2. Turn on your radio. Then select a channel or frequency

on your transmitter and hold down its transmit key. Do

not

speak into the microphone.

Notes:

• An SWR reading will be different for different frequen-

cies (channels). If you transmit on one channel more

often than any other, select that channel. If you trans-

21-533.fm Page 5 Thursday, August 5, 1999 3:47 PM

mit on several channels, choose a frequency in the

middle of the range of channels you use. (For example,

if you transmit on all 40 CB channels, choose Channel

20, because it is midway between Channel 1 and

Channel 40.)

• If you use a CB that has sideband modes (SSB), do not

select any of these modes. (Use only AM for SWR

measurements).

• If you have an amateur radio, select the continuous

wave (CW) or tuning mode to check the SWR.

3. While you hold down the transmit key, rotate the meter’s

knob until the needle points to CAL.

4. Release the transmit key, then set CALIBRATION/FS/SWR

to SWR.

21-533.fm Page 6 Thursday, August 5, 1999 3:47 PM

5. Press the transmit key again, then read the SWR by not-

ing the needle’s position on the upper SWR scale. A

meter reading of 1 on the upper scale is ideal.

The figure shown between the upper and lower scales on

the meter (% REF POWER) indicates the percentage of

power that is wasted through reflection of the signal from

the antenna back into the antenna cable. For example,

an SWR reading of 1.5 also means that 4% of your signal

power is lost. However, 96% of the radio power is more

than enough for almost all applications.

6. Repeat Steps 1–5 for each channel or frequency you

want to get an SWR reading for.

SWR Scales

21-533.fm Page 7 Thursday, August 5, 1999 3:47 PM

Interpreting SWR Readings

An ideal SWR reading is 1.0, but this reading is usually possi-

ble only under laboratory conditions orwith a dummy load.Ac-

tual antenna installations have higher readings. The in-

formation below will help you interpret the readings you get.

SWR Efficiency Interpretation

1.0 to 1.5 Excellent The antenna cable and the

antenna length match the

transmitter’s output require-

ments almost perfectly.

1.5 to 2.0 Very good The antenna, the cable, and

the transmitter operate very

efficiently.

2.0 to 3.0 Acceptable The antenna, the cable, and

the transmitter operate with

some loss. If possible, adjust

your antenna or antenna

mounting system to improve.

Above 3.0 Inefficient Adjust your antenna or

antenna mounting system to

improve efficiency.

21-533.fm Page 8 Thursday, August 5, 1999 3:47 PM

IMPROVING SWR

There are several ways to improve the SWR of your radio/an-

tenna combination. Try these first.

• Be sure you are using the type of cable recommended for

your equipment. If the manufacturer recommends a 50-

ohm cable, do not substitute another type that has a dif-

ferent impedance.

• Confirm that you mounted your antenna according to the

manufacturer’s instructions. The angle and the base

arrangement can affect the SWR reading.

• Adjust the length of your antenna according to the

instructions provided by the manufacturer. A change of

as little as 1/8inch can make a measurable difference.

• See your radio’s and antenna’s owner’s manuals.

21-533.fm Page 9 Thursday, August 5, 1999 3:47 PM

MEASURING FIELD STRENGTH

Your metercan measure the low levels of radio frequency (RF)

generated by a radio transmitter. You can use these measure-

ments to map the transmitting direction and coverage pattern

of your antenna, or to compare your radio and antenna’s effi-

ciencybefore and afteran adjustment. You donot needto con-

nect the meter to the antenna or the radio to measure field

strength.

It takes two people to measure field strength. For an accurate

measurement, you willneed to map the site around your anten-

na. Then, while someone presses the radio’s transmit key, you

will need to walk around the site around your antenna with the

meter, marking the readings you see.

Hints:

• In addition to the meter, we recommend you use the fol-

lowing items to help you measure field strength:

— Several photocopies of the template on Page 11

— 36 objects such as rocks or weighted pieces of paper

— 25 feet of rope or strong cord

— Calculator

— Pencil

— Compass

•Make sure there is at least 25 feet of open space in all

directions around your antenna.

21-533.fm Page 10 Thursday, August 5, 1999 3:47 PM

Tabla de contenidos

Otros manuales de Instrumento de medición de Radio Shack

Radio Shack

Radio Shack TRS-80 Manual de usuario

Radio Shack

Radio Shack 33-2055A Manual de usuario

Radio Shack

Radio Shack Sound Level Meter Manual de usuario

Radio Shack

Radio Shack 22-601 Manual de usuario

Radio Shack

Radio Shack 22-811 Manual de usuario

Radio Shack

Radio Shack Sound Level Meter Manual de usuario

Radio Shack

Radio Shack 33-2055 Manual de usuario

Radio Shack

Radio Shack 21-534 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario