Racing RAC3000EB-A Manual de usuario
ORIGINAL INSTRUCTIONS
Electric Blower Vacuum Shredder 3000W
RAC3000EB-A
INSTRUCTION MANUAL
WARNING: Read this manual carefully before use it.
BUILDER SAS
32, rue Aristide Bergès - ZI 31270 Cugnaux – France
MADE IN PRC 2020
2
FIG. 1
3
1 APPLICATION
This vacuum blower is intended to be used for the vacuuming and the blowing of leaves,
dust, and similar little materials. It must not to be used for vacuuming and blowing water,
chemical products, flammable material, metal or wood and others dangerous objects.
• This product is intended for private domestic use only. It must be used outdoors.
• This product is not intended to be used in a closed room or in places where exhausted gas
and flames can be present.
• The use of this product in case of rain or humid environment is prohibited.
• Use this vacuum blower only as described in this manual and only for the intended use as
described above.
• Any other use might lead to damage of the appliance, property or personal injury.
• No liability will be accepted for damage resulting from improper use or non-compliance
with this manual.
WARNING! For your own safety, read this manual and the general
safety instructions carefully before using the appliance. Your power tool
should only be given to other users together with these instructions.
2 DESCRIPTION (FIG. 1)
1. Wheel support
2 Front blow/suction tube
3. Rear blow/suction tube
4. Lever selector
5. Body of the tool
6. Speed adjustment dial
7. ON/OFF switch
8. Collection bag support
9. Collection bag
10. Shoulder strap
11. Power cable
3 PACKAGE CONTENT LIST
- Remove all packaging materials.
- Remove remaining packaging and packing inserts (if included).
- Check that the package contents are complete.
- Check the appliance, the power cord, the power plug and all accessories
for transportation damage.
- Keep the packaging materials as far as possible until the end of the
warranty period. Then take it to your local waste disposal system.
WARNING Packaging materials are not toys! Children must not play
with plastic bags! There is a danger of suffocation!
1 x Electric Blower Vacuum
1 x Collection bag
1 x Collection bag support
1 x Front blow/suction tube
1 x Rear blow/suction tube
1 x Shoulder strap
2 x Screws
1 x Wheel assembly
1 x Manual
1 x Warranty card
4
4 SYMBOLS
Read operator’s manual
SWITCH OFF: Remove plug from mains before cleaning or maintenance
Do not expose to rain
Wear eye protection
Keep bystanders away
Disconnect the mains plug if the cord becomes damaged or entangled
Guarantee sound power level
5
5 GENERAL POWER TOOL SAFETY WARNINGS
Read all safety warnings and instructions. Failure to heed
warnings and follow instructions may result in electric
shock, fire and/or serious injury. Keep safety warnings
and instructions for future reference. The term "power
tool" in the safety warnings refers to your mains-operated
(corded) power tool or battery- operated (cordless) power
tool.
IMPORTANT
READ CAREFULLY BEFORE USE.
KEEP FOR FUTURE REFERENCE.
Safe operating practices for hand-held
mains-operated electrical garden vacuums, and
garden blower/vacuums with or without shredding
means and garden blowers
Training
a) Read the instructions carefully. Be familiar with the
controls and the correct use of the machine.
b) Never allow children or people unfamiliar with these
instructions to use the machine. Local regulations can
restrict the age of the operator.
c) Keep in mind, that the operator or user is responsible
for accidents or hazards occurring to other people or their
property.
6
Preparation
a) Obtain ear protection and safety glasses. Wear them
at all times while operating the machine.
b) While operating the machine always wear substantial
footwear and long trousers. Do not operate the machine
when barefoot or wearing open sandals. Avoid wearing
clothing that is loose fitting or that has hanging cords or
ties.
c) Do not wear loose clothing or jewellery that can be
drawn into the air inlet. Keep long hair away from the air
inlets.
d) Operate the machine in a recommended position and
only on a firm, level surface.
e) Do not operate the machine on a paved or gravel
surface where ejected material could cause injury.
f) Before using, always visually inspect to see, that the
shredding means,shredding means bolts and other
fasteners are secure, the housing is undamaged and that
guards and screens are in place. Replace worn or
damaged components in sets to preserve balance.
Replace damaged or unreadable labels.
g) Before use, check the supply and extension cord for
signs of damage or ageing. If the cord becomes damaged
during use, disconnect the cord from the supply
immediately. DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY. Do not use the
machine if the cord is damaged or worn.
h) Never operate the machine while people, especially
children, or pets are nearby.
7
Operation
a) Before starting the machine, make certain that the
feeding chamber is empty.
b) Keep your face and body away from the feed intake
opening.
c) Do not allow hands or any other part of the body or
clothing inside the feeding chamber, discharge chute, or
near any moving part.
d) Keep proper balance and footing at all times. Do not
overreach. Never stand at a higher level than the base of
the machine when feeding material into it.
e) Always stand clear of the discharge zone when
operating this machine.
f) When feeding material into the machine be extremely
careful that pieces of metal, rocks, bottles, cans or other
foreign objects are not included.
g) If the cutting mechanism strikes any foreign objects or
if the machine should start making any unusual noise or
vibration, immediately shut off the power source and
allow the machine to stop. Disconnect the machine from
the supply and take the following steps before restarting
and operating the machine:
i) Inspect for damage;
ii) Replace or repair any damaged parts;
iii) Check for and tighten any loose parts.
h) Do not allow processed material to build up in the
discharge zone; this may prevent proper discharge and
can result in kickback of material through the intake
opening.
8
i) If the machine becomes clogged, shut-off the power
source and disconnect the machine from supply before
cleaning debris.
j) Never operate the machine with defective guards or
shields, or without safety devices, for example debris
collector in place.
k) Keep the power source clean of debris and other
accumulations to prevent damage to the power source or
possible fire.
l) Do not transport this machine while the power source is
running.
m) Stop the machine, and remove plug from the socket.
Make sure that all moving parts have come to a complete
stop:
- Whenever you leave the machine,
- Before clearing blockages or unclogging chute,
- Before checking, cleaning or working on the machine.
n) Do not tilt the machine while the power source is
running.
Maintenance and storage
a) When the machine is stopped for servicing, inspection,
or storage, or to change an accessory, shut off the power
source, disconnect the machine from the supply and
make sure that all moving parts are come to a complete
stop. Allow the machine to cool before making any
inspections, adjustments, etc. Maintain the machine with
care and keep it clean.
b) Store the machine in a dry place out of the reach of
children.
9
c) Always allow the machine to cool before storing.
d) When servicing the shredding means be aware that,
even though the power source is switched off due to the
interlock feature of the guard, the shredding means can
still be moved.
e) Replace worn or damaged parts for safety. Use only
genuine replacement parts and accessorises.
f) Never attempt to override the interlocked feature of the
guard.
Additional safety instructions for units with bagging
attachments
Switch-off the machine before attaching or removing the
bag.
Recommendation
The machine should be supplied via a residual current
device (RCD) with a tripping current of not more than 30
mA.
Additional instructions
-This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
-Children should be supervised to ensure that they do
not play with the appliance.
10
-Warning - never allow children, persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge or people unfamiliar with
these instructions to use the machine, local regulations
may restrict the age of the operator.
-Warning - never operate the machine while people,
especially children, or pets are nearby.
-If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent.
-Before connecting the machine, check if the tool and
cable are not damaged. If anything is damaged, do not
use the machine and return it to your dealer for
inspection and repair.
-Do not use accessories other than those
recommended by the manufacturer; Accessories not
recommended may damage the unit and / or cause
injury.
-Do not disassemble the tool yourself. Any disassembly,
repair or inspection must be performed by qualified
personnel only.
-Use the tool fully assembled and secure. Before use,
check that the guards and safety devices are in place.
-When operating the machine, always wear protective
equipment including: face shield, visor or goggles, ear
protection, helmet, gloves, non-slip shoes and
protective clothing.
-Always carry the machine by its handle. Never use the
cord or any other part of the machine.
Tabla de contenidos
Otros manuales de Soplador de Racing
