Qtx LED DERBY III Manual de usuario

LED DERBY III

RGBW Light Effect

Item ref: 151.577UK

User Manual

151.577UK User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

Thank you for choosing the QTX LED DERBY III quad colour multi-point effect as part of your lighting rig.

Please read these instructions in full to gain the best results from this item and avoid damage to the unit.

Unpacking

Your LED DERBY III should reach you in good condition and be supplied with appropriate mains lead(s)

and mounting bracket. If there are any signs of damage or items missing from the packaging, contact

your dealer immediately.

Warning

To prevent risk of fire or electric shock, do not expose any components to rain or moisture.

If liquids are spilled on the housing, disconnect mains and allow unit to dry out & have checked by

qualified personnel before further use. Avoid any impact or extreme pressure to the housing.

No user serviceable parts inside –Do not open the case –refer all servicing to qualified service personnel.

Safety

Check for correct voltage and condition of IEC lead before connecting to power outlet

Placement

Mount the unit to a lighting stand or ceiling using the adjustable bracket included

If the unit is mounted at height, a drop cable should be attached for safety

If free-standing, ensure that the unit is sited on a stable, non-slip surface

Ensure adequate access to controls and connections

Cleaning

Use a soft dry or slightly damp to clean the cabinet. Do not use strong solvents for cleaning the unit

For best results, clean the front optics periodically with a dry, lint-free cloth

151.577UK User Manual

Setting up

Install the LED DERBY III so that the front panel is facing the area to be lighted.

Experiment with positioning to get the best coverage from the multi-beam array.

Connect mains using an appropriate IEC lead to the mains inlet

Operation

The LED DERBY III operates as a stand-alone unit in either auto or sound-activated modes.

Settings are accessible via the 10 dip switches situated on the rear panel.

Sound activated mode is governed by a rotary sensitivity control on the rear panel.

Turning this control clockwise increases the sensitivity of the rear panel mounted microphone

Rear Panel

DIP Switch settings

DIP switche(s) on

Effect

Auto colour jump with slow rotation

10 + 5

Auto colour fade + jump with slow rotation

10 + 4

Fast auto colour jump with slow rotation

10 + 2 + 1

Auto colour jump with fast rotation

9 + 10

Sound-activated with slow rotation when no sound detected

Number 1 to 10 dip switches

Power on/off switch

Sound-activation microphone

Rotary Mic. Sensitivity control

Mains inlet (IEC) & Fuse holder

151.577UK User Manual

Specifications

Power supply

240Vac 50Hz (IEC)

Power consumption

40W

Operating modes

Auto, Sound activated

LED sources

8 x 3W LED (2 x Red, 2 x green, 2 x blue, 2 x white)

Controls

Power on/off, Mic. Sensitivity, dip switches 1-10

Dimensions

295 x 160 x 275mm (inc. bracket)

Weight

3.85kg

Troubleshooting

No power

Check mains voltage is correct and outlet is switched on

Check IEC lead and mains fuse (if fuse continually blows, refer to your dealer)

No light output

Check rear panel dip switch settings (8 on its own gives no LED output)

No sound activation

Check that dip switch 9 is switched to “on”

Check rotary control for microphone sound sensitivity is not fully down (left)

Light output is dim

Make sure front panel optics are clean and clear of debris

Overheating/cutting

out

Ensure that the unit is not too close to a heat source

Ensure that the cooling vent on the rear panel is clear and not covered

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines

Errors and omissions excepted.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Qtx

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario