Qlight S100E Manual de usuario
S100E / S100E-FT / S125E / S125E-FT
Thank you for purchasing Q.Light product.
Please read this manual carefully before installing this system
for safe and long use of the product.
▪ Low priced economical product with high efficiency in radiating
signal light.
▪ Volume(Buzzer Built-in Type) : 85dB(1m)
▪ RPM : 120-140/Min.(Controllable)
▪ Material : Lens-AS, Body-ABS, Reflector-Heat Resisting ABS
▪ Protection Class : IP23
1)
S100E / S100E-FT
▪ General Specification
Model Rated
Voltage Current Bulb Weight Color
DC12V 0.720A 12V10W T16x35 15S
9
DC24V 0.390A 24V10W T16x35 15S
10
0.35Kg
AC110V 0.087A 12V10W T16x35 15S
9
S100E
S100E
-FT
AC220V 0.045A 12V10W T16x35 15S
9
0.63Kg
Red-R
Amber-A
Green-G
Blue-B
▪ External View Drawing
S100E S100E-FT
2)
S125E/ S125E-FT
▪ General Specification
Model Rated
Voltage Current Bulb Weight Color
DC12V 0.720A 12V10W T16x35 15S
9
DC24V 0.390A 24V10W T16x35 15S
10
0.42Kg
AC110V 0.087A 12V10W T16x35 15S
9
S125E
S125E
-FT
AC220V 0.045A 12V10W T16x35 15S
9
0.68Kg
Red-R
Amber-A
Green-G
Blue-B
▪ External View Drawing
S125E S125E-FT
Power line UL1015-NO.16(1.25sq) x 2C 400mm comes out from
the product.
▪ In case of product using AC voltage, connect the line without
polarity(wire color).
▪ In case of product using DC voltage, black line is negative(-).
Indoor Outdoor
▪ This product was manufactured with the structure for indoor use.
Installing in any direction is okay for indoor use.
▪ Outdoor use is limited at a place where no water or very little
water percolates. Mouning also should be done only with vertical
standing shape.
▪ Mount at the place where exists low vibration, low impact, low
moisture and low dust as long as possible.
▪ Refer to following information and drill necessary mounting holes
on proper part of the product.
(Make sure PCD from external view drawing.)
OPERATING MANUAL
Bulb Revolving Warning Light
▪ S100E/S125E Type : Fix the product by using nuts(100E:M4-3EA,
125E:M5-3EA) originally equipped on mounting bolt on bottom
of the product.
▪ S100E-FT/S125E-FT Type : Fix the product by using nuts(M6-
2EA) originally equipped on mounting bolt on bottom of the
product.
This product has a volume on assembling board for controlling
revolving speed. Refer to following drawing and explanation for
right operating.
2) Lens Removal
Remove lens by turning it counterclockwise and make sure
bulb and bulb socket on assembling board.
2) Revolving Speed Control
▪ The volume for revolving speed control(1) is built-in this
product. Turn it clockwise for increasing revolving speed and
turn it counterclockwise for decreasing revolving speed.
▪ Treating with strong power can break the volume.
Please be careful.
3) Bulb Change
※ Warning ! Turn off Power
Must turn off power supply and change the bulb after at least
1 minute.
▪ Make sure the rated voltage and wattage of new bulb. If the
voltage of new bulb is higher than that of original bulb, the
self-life of product can be reduced and can cause damage on
lens and reflector. Therefore,please use same bulb as original
one which has same rated voltage and wattage or lower one.
▪ Bulb Removal : Press slightly the bulb downward and turn it
counterclockwise for removing.
▪ Bulb Fitting : Fit new bulb into the socket by pressing it
clockwise.
▪ If using voltage is seriously higher or lower than rated voltage, it
can reduce the self-life of the product or can cause a problem
on product operating. Make sure the using voltage does not
exceed +/- 5% of the rated voltage.
▪ If lens or body of the product is contaminated by chemicals such
as thinner,benzene, the product can be damaged, discolored
or deformed. Please be careful.
▪ Do not give strong impact to the product. It can be a reason of
wire disconnection or short circuit.
▪ Do not strongly pull the wire out from the product. It can cause a
disorder.
Bulb Removing Bulb Fitting
(S100E)
(S125E)
(S100E-FT)
(S150E-FT)
Situation Main Cause Solution
Non Lighting Wire Disconnection
with Bulb
Wire Re-connection or
Bulb Change
Short Self-Life of Bulb Supplying Voltage Higher
than Rated Voltage
Making Sure Using
Voltage
Lens Deformation Caused
by Bulb Overheating
(AC Type)
The Voltage of Bulb
is Higher than Rated
Voltage
Changing Bulb with
Rated Voltage
Non Revolving Problem with Motor Contact Q.Light or
Their Agent
Wrong Wiring Making Sure Wiring
Neither Lighting Nor
Revolving No Power Supply Making Sure Power
Supply
Low Revolving Speed Wrong Operating Revolving
Speed Control Volume
Turn the Volume
Clockwise
Q-LIGHT CO., LTD.
http://www.qlightkr.com
E-mail : [email protected]
Seoul Office (Domestic Sales & A/S)
Tel) 02-2679-6152
Ansung BD A-312, 410-13 Sindorim-Dong, Guro-Gu, Seoul
Overseas Marketing Team / Plant
Tel) 055-328-4082 Fax) 055-328-4083
Plant #1 : 178-1 Woogye-Ri, Sangdong-Myun, Kimhae-Si,
KyungNam, Korea
Plant #2 : 417-1 Geumsa-Dong, Geumjung-Gu, Busan
Este manual sirve para los siguientes modelos
3
Otros manuales de Equipo de iluminación de Qlight
Qlight
Qlight SHD Manual de usuario
Qlight
Qlight ST45L-ETN-BZ Manual de usuario
Qlight
Qlight S80AS Manual de usuario
Qlight
Qlight QWHL150 Manual de usuario
Qlight
Qlight S80S Manual de usuario
Qlight
Qlight S80RK Manual de usuario
Qlight
Qlight EMCL50U Series Manual de usuario
Qlight
Qlight QT56MCL Manual de usuario
Qlight
Qlight QTR50L Manual de usuario
Qlight
Qlight SAOL1 Manual de usuario
Qlight
Qlight SAMP Manual de usuario
Qlight
Qlight SHDL Manual de usuario
Qlight
Qlight S60LR Manual de usuario
Qlight
Qlight CPK-CAN Manual de usuario
Qlight
Qlight STNDL-N Manual de usuario
Qlight
Qlight Q125L Manual de usuario
Qlight
Qlight S60R Manual de usuario
Qlight
Qlight QMCL60 Manual de usuario
Qlight
Qlight QTG50 Series Manual de usuario
Qlight
Qlight SK Manual de usuario
Manuales populares de Equipo de iluminación de otras marcas
Qazqa
Qazqa Suplux SL 3 Black 103062 Manual de usuario
Commercial Electric
Commercial Electric 54568141 Manual de usuario
CREE LIGHTING
CREE LIGHTING 304 Series Manual de usuario
Goobay
Goobay 49867 Manual de usuario
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Manual de usuario
Alkalite
Alkalite Krypton KT-81 Manual de usuario
