PVI Industries PV 17-A Guía del usuario

PVI Industries, Incorporated Start-Up of Gas-Fired Water Heaters May 1998

PV 17-A

START-UP OF GAS-FIRED WATER HEATERS

**FOR DETAILED INFORMATION SEE INSTALLATION & MAINTENANCE MANUAL **

1. Visually inspect water heater and components for damage and proper installation.

2. Check all electrical connections for tightness and proper voltage.

3. Check water heater tank to make sure it is full of water. (Remove air through T&P valve).

4. Pull nozzle assembly from burner and check gap settings on electrodes (see I&M).

5. While nozzle is removed, look inside through burner for obstructions.

6. Check fan rotation.

7. Check air shutter setting (guideline on burner tag).

8. Drill hole in vent pipe 12” to 24” from heater flue outlet but below draft regulator

(for analysis equipment).

9. Attach voltmeter to controller to record flame signal.

10. Check inlet static gas pressure before gas train (see rating on heater decal).

11. Attach manometer to manifold to read pressure (tapping closest to burner).

12. Turn off main manual gas valve and start burner on pilot (if burner has separate pilot).

a) Set pilot to give good flame signal with just enough gas to reliably light pilot.

NOTE: If there is no pilot, set gas pressure (guideline on burner tag).

b) Slowly open main gas and set gas pressure (guideline on burner tag).

c) Check flame signal (should be in range called for by control).

13. Check inlet flow gas pressure before gas train.

NOTE: Should meet or exceed minimum rating listed on heater decal.

14. Check vent draft in stack (should be negative .02” to negative .06” W.C.).

15. Perform flue gas analysis after achieving water temperatures above 120

NOTE: Modulating burners should be checked at 25% increments.

a) Net stack temperature should be 3 00

F - 400

F (read in stack, all units).

b) O2 should be from 4% to 7% (atmospheric units tested below draft diverter).

c) CO2 should be from 8% to 10% (atmospheric units tested below draft diverter).

d) CO should not exceed 200 PPM (atmospheric units tested below draft diverter).

NOTE: A complete and proper start-up includes checking the operation of all controls and limits (i.e. airflow

switch, LWCO, thermostats, and modulating controls), and filling out the entire start-up report. All discrepancies

should be reported to the PVI Customer Service Department (800-433-5654) from the job site and detailed on

the comment section of the start-up report. Attach notes to report if needed. Also, please call if you have any

questions or need assistance.

PV 17 8/05 817-335-9531 ●800-433-5654 ●FAX 800-880-2019 ●www.pvi.com

START-UP REPORT

GAS FIRED NON-CONDENSING WATER HEATERS

Atmospheric - MAXIM

- TURBOPOWER

Warning: Startup must be performed by a qualified service installer, service agency or the gas supplier.

Model Number: Serial Number: __

Job Name:

Address:

GENERAL INFORMATION

Restart? Yes No Installation is: New Replacement/Renovation Indoor Outdoor

Primary operating voltage: VAC Voltage from neutral to earth ground: (should be zero)

Thermostat Setting: °F Thermostat Setting: °F Hi-Limit Setting °F

T & P Relief Valve(s) plumbed to a suitable drain? Yes No

WATER HEATER INSTALLATIONS

Type of piping connected to heater: Copper Brass Galvanized

Is there a check valve in the supply water piping? Yes No

Is there a water softener on the cold water supply? Yes No Operational? Yes No

Is there a mixing valve on the hot water supply? If yes; temperature setting: °F No

Is there expansion relief in the cold water supply? If yes, what type: tank valve No

Is there a recirculation loop? Yes Circulating pump horsepower: No

Is there a floor drain in the room? Yes No

VENTING and COMBUSTION AIR

Vent Material: Vent Type: Through-the-roof Through Sidewall

Vent Diameter: inches; Vent Length: feet Does vent have elbows? Yes; Qty No

Does vent have condensate drain? Yes No

Does vent contain any of these devices? Power Vent Draft Inducer Draft Regulator Flue Damper

Combustion air louvers or openings? Yes; Qty: Size: No Interlocked? Yes No

Have direct-ducted combustion air? Yes; duct diameter inches, Duct length feet. No

Duct Material: Does duct have elbows? Yes; Qty No

Page 1 of 2

PV 17 8/05 817-335-9531 ●800-433-5654 ●FAX 800-880-2019 ●www.pvi.com

Model Number: Serial Number:

GAS SUPPLY

Type of gas: Natural LP Gas Supply Pipe Size: inches

Inlet Static Gas Pressure: “W.C. (14” W.C. maximum)

Inlet Flow Gas Pressure: “W.C. (see data label)

Combination Gas Pressure Switch Setting: High / Low “W.C.

COMBUSTION ANALYSIS

BURNER MODEL NO.: BURNER SERIAL NO.:

(For fixed rate burner, use High Fire column) Low Fire Mid Fire High Fire

Pilot Gas Pressure

Manifold Gas Pressure

Carbon Dioxide CO

(8-9%)

Oxygen O

(5-7%)

Carbon Monoxide CO (less than 200 ppm)

Nitrogen Oxide NO

(if available)

Vent Pressure (-.02” to -.06” W.C.)

Gross Vent Temperature °F

less Room Temperature °F

= Net Vent Temperature °F

Important: You must submit the original copy of the completed form to your PVI representative before the

warranty will become effective on this product. Contact Customer Service for assistance at 1-800-433-5654.

Comments:

Service Company Name: Phone:

Service Company Address:

Start-up Performed By: Date:

Customer Representative: Date:

Page 2 of 2

Tabla de contenidos

Otros manuales de Calentador de agua de PVI Industries

PVI Industries

PVI Industries 1000N400A-TPO Manual de usuario

PVI Industries

PVI Industries PV 6114 6/03 1 Manual de usuario

PVI Industries

PVI Industries 1000P600A-TPGO Manual de usuario

PVI Industries

PVI Industries PV 6113b Manual de usuario

PVI Industries

PVI Industries MAXIM 20 N 119A-MXS Manual de usuario

PVI Industries

PVI Industries QuickDraw Manual de instrucciones

PVI Industries

PVI Industries TURBOPOWER 1000 N 225A-TPO Manual de usuario

PVI Industries

PVI Industries 50 L 130 A-GCML Manual de instrucciones

PVI Industries

PVI Industries TURBOPOWER 500 N 750A-TPL Manual de usuario

PVI Industries

PVI Industries TURBOPOWER 1000 N 600A-TPL Manual de usuario

PVI Industries

PVI Industries 1000N600A-TPO Manual de usuario

PVI Industries

PVI Industries PV 6454 3/04 1 Manual de usuario

PVI Industries

PVI Industries PV 19A Guía del usuario

PVI Industries

PVI Industries 800-N-Z5DA-PV Manual de usuario

PVI Industries

PVI Industries MAXIM Manual de usuario

PVI Industries

PVI Industries MAXIM 20 N 125A-MXS Manual de usuario

PVI Industries

PVI Industries 1000PHE125A-TPO Manual de usuario

PVI Industries

PVI Industries 250P225A-TPL Manual de usuario

PVI Industries

PVI Industries TURBOPOWER 99 Manual de usuario

PVI Industries

PVI Industries Water Heater Manual de usuario

PVI Industries

PVI Industries 40L125A-MXIF Manual de instrucciones

PVI Industries

PVI Industries 45N300A-E Manual de usuario

PVI Industries

PVI Industries 1000P125A-TPGO Manual de usuario

PVI Industries

PVI Industries 1100N300A-E Manual de usuario

Manuales populares de Calentador de agua de otras marcas

Kenmore

Kenmore 153.582400 Manual de usuario

Applimo

Applimo Edel AIR Manual de usuario

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manual de usuario

clage

clage E-Mini Series Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-180 Manual de usuario

Bradford White

Bradford White EF Series Manual de usuario

Eccotemp

Eccotemp 40-H Manual de usuario

Dimplex

Dimplex ECSd125-580 Guía

Dux

Dux 32FCR6N Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guía de solución de problemas

Noritz

Noritz N-132M Manual de instrucciones

TESY

TESY GCV7/4S 10047 Hoja de especificaciones

A.O. Smith

A.O. Smith Gphe 50 Manual de usuario

Koryo

Koryo KWHZF15Y Manual de usuario

Pentair

Pentair PSC-14-4-02 Manual de usuario

GE 40M06AAG Instrucciones de montaje

Thermor

Thermor AEROMAX SPLIT 2 Manual de usuario

American Hometec

American Hometec AHQ-B03X Manual de usuario