Puredry PD ZS-30Z Manual de usuario
INSTRUCTION MANUAL
ULTRASONIC AIR HUMIDIFIER PD ZS-30Z
CONTENTS
1. SAFETY INSTRUCTIONS .................................................................................................... 1
2. GENERAL INSTRUCTIONS ................................................................................................ 2
3. WATER FILTER INSTALLATION ........................................................................................ 2
4. PRODUCT STRUCTURE ..................................................................................................... 4
6.SYSTEM FUNCTION .......................................................................................................... 7
7.PIPE LAYOUT..................................................................................................................... 8
9.MAINTANANCE............................................................................................................... 10
10.TROUBLE SHOOTING...................................................................................................... 11
Dear customer,
Congratulations for your choice. The ultrasonic
humidifier Puredry PD ZS-30Z excels for his quiet
operation while having high performance. Please read
the instruction manual carefully and get to know your
humidifier through detailed instructions, so that you
can eradicate dryness effectively with the most clever
and economical way.
5. CONTROL PANEL.............................................................................................................. 6
8. SPRAY SYSTEM.................................................................................................................. 9
11.AFTER-SALE SERVICE ...................................................................................................... 14
1
1. SAFETY INSTRUCTIONS
SAFETY INFORMATION
ATTENTION
This humidifier shall not be used in spaces that:
- There are explosives
- There is aggresive atmosphere
- Has high concertration of solvents
- Has high levels of dust
Keep away from children: Do not let children play with or around the humidifier to avoid injury.
Make sure that the humidifier in unreachable for children.
Keep the humidifier properly grounded: Never use the humidifier with a broken power cord to
avoid electric shock. A plug with a ground pin is a basic safety feature that helps in reducing the
danger of electric shock or fire.
Protect the power cord: Never use the humidifier with a damaged power cord, this can lead to
electric shock or fire. If the power cord is damagedm it should be replaced with a same power cord
with the same type, voltage and amperage rating.
Power cord extention: Power cord extentions must have grounding and be able to provide current
to the unit without problem.
Be carefull with the product: In no circumstances dont drop the humidifier. Violent moves can
damage the product or cause malfunctions.
Place it on a steady surcface: Always use the product on a flat and steady surface for example on
the floor or a strong base so that the humidifier can not be dropped.
Keep away from water: Never use the device near water to avoid the danger of electric shock. Do
not store or use the humidifier outdoors. If the electrical wires or parts get wet, dry them carefully
before you start the device. In case of doubt, do not use the humidifier and consult a profesional
electrician or call us at 2521103265 so that you can speak to a qualified technician.
Keep the water spray outlets clear: Never block the water spray outlets. Never place the humidifer
close to curtains and walls. This can cause overheating to the unit.
Keep the electrical equipment dry: Never leave water inside the electrical components of the
humidifier. If these areas get wet, for whatever reason, dry them well before use. In case of doubt,
dont use the humidifier and consult a professional electrician or call us at 2521103265 Puredry Hellas
to speak with a qualified technician.
Make sure the user has read the instruction manual of the device.
Wiring instructions: If it is necessary to replace the power plug pay attention to the polarity of each
wire.
2. GENERAL INSTRUCTIONS
WATER FILTER INSTALLATION
2
Before using the humidifier for the first time, read carefully the instruction manual.
After receiving the product, check the humidifier for any damage caused during the
transportation. In case of damage, you must inform the seller immediately. Damages
during transportation should be declared before you start using the humidifier. Keep
the packaging of the humidifier in safe place, so that you can use it when you have to
send it back for repair.
3.
In order to keep the machine water system running smoothly, and to prevent the
water impurities flowing into machine blocking the solenoid valve and fogging system,
be sure to install a water filter less than 5m away in front of water pipe junction Make
sure the joint does not leak, every connected parts and hose required the quality and
rust proof material, and it is advisable to install the machine by a professional
plumber.
Please take a reference of Sketch(1) as follows:
3
Make sure to drain all of the pollution and impurities and then connect to the
machine pipe, the inner diameter of this equipment pipe joint isφ20, it adopts outer
thread interface, when the interface connected with each other, make sure it is water
or air tight, it is suggested to be installed by professional plumber, please take
sketch(2) for reference.
Note: When installation or running the machine, the height of water level of pipe can not
be higher than the outlet.
4
PRODUCT STRUCTURE
4.
PLEASE CHECK SKETCH 3 & 4.
Sketch 3
1. Control panel 9.Soft tube
2. Emergency switch 10 Sensor interface
3. Lock 11.Mounting bracket
4. Electricity tank 12.Fix hole
5. Power supply 13.Spary outlet
5
6. Wheels 14.Hand-dug
7. Air inlet 15.Tank cover
8. Filter 16.Fix screw
Sketch 4
Note: In order not to affect the mist
production, emergency switch would be put into use when the timer error displays fault, after
restoration the timer would continue to control the machine again.
6
CONTROL PANEL
5.
POWER SWITCH
Power switch: Press “Power” to start or stop power.
DESCRIPTION
Humidity: Press “Set” button to adjust humidity, set through “+” or “-”.
Time: Press “Set” to set time, use “+” or “-” to set time to start or stop machine.
HUMIDITY/TIME
7
SYSTEM FUNCTION
6.
When the humidity reached the set level, the machine would stop automatically. It
would automatically start machine when the humidity drops to certain level, the
humidity range is 30-90%. The machine would stop up +5% of set humidity and restart
below -5% of set humidity.
HUMIDITY CONTROL
WATER INLET
When the water in the water tank is lower than the warning level of water tank, the
system would replenishes water automatically, it would automatically stop filling when
the water level rises to the maximum height.
WATER OUTLET
The machine would outlet manual.
WATER LEVEL
It would stop running if the water level falls below the marked point: When the system
detectes the water level is lower than the warning level, the machine would stop
automatically. The system would warn if water is not refilled in 10 minutes.
FAN DELAY PROTECTION
When the machine stops, the fan will keep running for another 30 seconds to drain off
all the residue water mist and heat.
8
PIPE LAYOUT
7.
Please lay the pipeline strictly according to the requirement of manual. Seal the
interface and makes it airproof, water proof, keep the pipeline smoothly, preventing
leakage in the pipeline.
In order to prevent spray outlet having its water falling back, the spray holes should be
pointing 30 degree upward above the horizontal of the PVC cross-section. The
diameter of hole need to be 1.5cm, the distance between the holes should be
80cm~200cm and it should be with the principle of higher vapor density in near
distance and scattered in far distance, the height at the end need to be higher than the
humidifying section, please check the sketch(5), can not connect the water pipe such as
sketch(6) with rough pipe.
Note: If there is no need to lay the pipeline, you must install spray outlet pipe
and connect to a lose elbow so as to adjust the direction of spray freely, check
the sketch 6. The shortest distance of elbow should above 20cm from the
machine, otherwise, the water would drop on the any parts of the machine
and it would lead to rust, or short circuit or cause accident. It is suggested to
separate the equipment and the site, use the pipe to humidify the room.
Tabla de contenidos
Idiomas:
Otros manuales de Humidificador de Puredry
