Puredry PD 130L Manual de usuario
• USER’S MANUAL
• ΕΓΧΕΙΡΙΔΙΟ ΧΡΗΣΗΣ
ENGLISH | ΕΛΛΗΝΙΚΑ
INDUSTRIAL DEHUMIDIFIER PD 130L
LANGUAGES
ENGLISH .............................................................................................................. 3
ΕΛΛΗΝΙΚΑ .......................................................................................................... 19
3
TABLE OF CONTENTS
1. SAFETY & WARNING INSTRUCTIONS ............................................................................ 4
2. GENERAL INFORMATION ............................................................................................... 5
3. DEHUMIDIFIER FUNCTIONS........................................................................................... 5
4. STEPS BEFORE USE ......................................................................................................... 6
6.GETTING TO KNOW YOUR DEHUMIDIFIER ................................................................... 9
7.
MAINTENANCE & CLEANING....................................................................................... 13
CONTROL PANEL • INDICATORS.................................................................................. 10
9.MACHINE STORAGE.......................................................................................................14
10.FREQUENTLY ASKED QUESTIONS & TROUBLESHOOTING......................................... 15
Dear Consumer,
Congratulations on your choice! Puredry's
PD130L industrial dehumidifier is distinguished
among its class, by its excellent performance,
quite operation and double air inlets, which
guarantee efficiency regarding humidity issues.
Please refer to this manual, to obtain full eiffciency
of the dehumidiifer, through the guidelines
included in the following pages and make savings via
clever use of this device.
5. PRODUCT FEATURES...................................................................................................... 8
8.
EN
11.WARRANTY TERMS ....................................................................................................... 16
1. SAFETY & WARNING INSTRUCTIONS
4EN
SECURITY INFORMATIONS
CAUTION
This dehumidifier should not be used in areas where are:
- Explosives
- Hostile atmosphere
- With high concentration of
solvents - Extremely high dust ratio
Keep away from children: Do not let children play with or around this unit, which
could lead to injury. Be sure the unit is inaccessible to children.
Hold Unit Grounded : Always connect the appliance to a grounded socket. A
grounded plug is an essential safety feature that helps reduce the risk of electric shock or
fire.
Protect the power cord from DANGER: Never use a unit with a damaged power cord as
this may cause electric shock or fire. If the power cord is damaged, it must be replaced
with a cable of the same type and rated voltage.
Cable Extension: The walkways must be grounded and able to power the
unit without any problems.
Handle with Care: Do not drop, throw or crash the dehumidifier. Rough
treatment can damage the components or wiring and create a hazardous condition.
Fixing on a stable surface:Always use the unit on a firm,flat surface,for example,
the floor or a strong base, so that the dehumidifier can not fall and cause injury.
Keep it away from water: Never use the appliance near standing water, as this may
create a risk of injury from electric shock. Do not store or use it outdoors. If the electrical
wiring or accessories are wet, dry thoroughly before using the appliance. If any doubt, do
not use the dehumidifier and consult a qualified electrician or contact 2521103265 to
speak with an approved engineer.
Keep the air inlets Clean: Do not block or prevent the air intakes by placing the
dehumidifier very close to curtains and walls. This may cause the unit to overheat and
cause a fire or electric shock hazard.
Keep the air filter clean: Always use a clean air filter. Do not allow any material to clog
it, as this may cause overheating in the dehumidifier. Never use it without a filter. Always
check and, if necessary, clean the filter before moving the dehumidifier to the work area.
Do not allow oil, grease or other contaminants to come in contact with the dehumidifier.
Keep electrical equipment dry: Never leave water in electrical components of the
dehumidifier. If these areas are wet for any reason, dry them well before using the
dehumidifier. In case of doubt, do not use the dehumidifier and consult a qualified
electrician or call 2521103265 at day4energy.gr to speak with an approved engineer.
You should make sure that the user knows the operating instructions of
the machine.
2. GENERAL INFORMATION
Power off the dehumidiifer before removing the plug.
DEHUMIDIFIER FUNCTIONS
5
EN
Before operating the dehumidifier for the first time, the instruction manual should be
carefully studied. After receiving the unit, you should check your dehumidifier for any
damage during transport. In the event of a breakdown, you should immediately notify the
sender.
Transport damage must be declared after unpacking the equipment. You should
immediately contact your reseller or qualified reseller.
Keep the dehumidifier package in a safe place so that it can safely ship it if service is
required. To save space, you can simply cut off the adhesive tape using a knife and fold
the cardboard box.
3.
This dehumidifier is designed to reduce moisture from the air in a building or part of a
building. The purpose is to prevent damage from moisture, and to dry wet materials
such as carpet, floors, walls, furniture, contents, timber, and building materials. This
dehumidifier can prevent formation of condensation, reduce air humidity and keep the
desired relative humidity value constant.
The time it takes for the dehumidifier to dry a room and reach the desired relative
humidity depends on the environmental conditions prevailing in the room. For
example, the number of changes of air to the outside, to humidity and room
temperature sources can either accelerate or slow the process of dehumidification. The
principle of operation of the dehumidifier, according to the principle of condensation, is
achieved with heat recovery.
The fan gets the humid air from the room through a filter and leads it to the
evaporator. Here the air is cooled below the dew point, so that the air of the air of
water forms a condensate on the coils that flow into the water collection vessel. After
cooling and drying, the air is again heated by a condenser. By recycling the room air
through the dehumidifier again and again the relative humidity rate of the air is
reduced.
6EN
Drain hose
For warranty purposes, please note the
SN (seerial number). The SN is labeled on
side of the device.
Please refer to the electronic warranty
instructions, in the last page (English
section) of this manual.
4.STEPS BEFORE USE
User's manual
Dehumidifier
with compressor
Installation tips
2) Place the unit in an area
where the temperature
levels will not fall bellow 5ºC
(41ºF) There is a possibility
the coils will collect frost at
temperatures that are under
5ºC (41ºF), which may result
in low performance.
1) Do not block or restrict the
airlfow around the unit. Make
sure the air inlet exhaust grills
are not obstructed. Allow
20cm of clearance around the
unit and 40cm above.
7
EN
For installation and transport, the following instructions must be followed:
The air inlet and the air outlet must not be covered while the
dehumidifier is in operation.
Before any movement, the dehumidifier must be turned off.
For transportation, the dehumidifier should be secured on a flat base to prevent
accidents.
Empty the water collection tank. The dehumidifier must always be moved vertically.
If the dehumidifier is in a horizontal position for more than 10 minutes, you should
allow it to stand upright for at least 30 minutes before operation. This allows the oil to
drain back to the compressor.
5. PRODUCT FEATURES
EN
8
ELECTRICAL CONNECTIONS.
Dehumidifier is designed to operate in a 230V ~ 50Hz electrical installation. Make sure
that electrical outlets are connected to the ground and that all safety precautions have
been taken.
OPERATING CONDITIONS
This dehumidifier can operate within an ambient temperature range of 3 to + 35 ° C
and a relative humidity of 35% to 90%. It is suitable for application on construction
sites, residential buildings, museums, archives, garages and warehouses.
COMPRESSOR PROTECTION
The first time the dehumidifier starts, the compressor starts immediately. After the first
shutdown of the unit, the compressor will require at least 3 minutes of cessation due to
its self-protecting system to avoid frequent recalls.
AUTO RESTART
The system has auto memory. When all the mode setting has been finished, if
there is sudden power cut during operation, or the power jack slips out, the system may
store the current status before the power is cut and enter the operation mode before
power cut automatically after power is supplied.
MODEL PD 130L
OPERATING TEMPERATURE +5 °C / +35°C
HUMIDITY LEVELS 20% - 90%
DEFROSTING SYSTEM Hot gas
VOLTAGE 240 V~50 Hz
CONSUMPTION 30°C – 80%1.79 kW
FREON R410a/800g
DAILY
PERFORMAN
CE (L/24H)
20ºC – 60% 68
27ºC – 80% 92
30ºC – 80% 130
DIMENSIONS W x D x H [mm] 672 x 533 x 988
WEIGHT 72kg
TIMER
ELECTRONIC BOARD
6.GETTING TO KNOW YOUR DEHUMIDIFIER
Air Outlet
Handle
Air intake
grill
Control panel
Casters
This unit has preinstalled
casters, positioned on
the bottom four corners
of the unit.
Drain hose
outlet
9EN
Please make sure to
remove the protective
zelatine from the top
part of the screen
7.CONTROL PANEL • INDICATORS
Button Function
Press this button while on electric, screen light on, machine automatically goes to
continuous mode,display screen shows environmental humidity, compressor on after
the fan run for 3 seconds; press this button again, compressor stops, display screen
shows “- -”, machine goes into standby mode, the fan will run for another minute and
stop.
Press this button while machine is on electric, until button light goes on, press “MINUS”
“ADD” to set the time to start the machine, when the countdown is over, the fan and
compressor turn on. Press this button while machine is running, until the button light
goes on, press “MINUS” “ADD” to set the time to stop the machine, when the
countdown is over, the fan and compressor will shut off. Press this button for 3
seconds to show current temperature. After 10 seconds, the display will return to show
current humidity.
The humidity can be increased by increments of 5%RH during normal mode. Hold
this button for 1 second to increase the humidity continuously.
(1
The humidity can be decreased by increments of 5%RH during normal mode.
Hold this button for 1 second to decrease the humidity continuously.
Tabla de contenidos
Idiomas:
Otros manuales de Deshumidificador de Puredry
Puredry
Puredry PDD 200M Manual de usuario
Puredry
Puredry Mini-D Manual de usuario
Puredry
Puredry PD 210L Manual de usuario
Puredry
Puredry PDDW 12100 Famous Manual de usuario
Puredry
Puredry DESIGN SERIES PD 130LA Manual de usuario
Puredry
Puredry PD 2419 Sophia Manual de usuario
Puredry
Puredry PD 625 Manual de usuario
Puredry
Puredry PD 170L Manual de usuario
Puredry
Puredry PDDW 10100 Famous Manual de usuario
Puredry
Puredry PDD 10L Famous Manual de usuario
