Pulsar PSC12010 Manual de usuario

PSC12010

PSC 12V/1A/55MM power supply

v.2.0

Edition: 12 from 22.05.2023

Supercedes edition: 11 from 20.11.2020

Features:

power output 1 A/12 V DC*

universal supply voltage range ~100 - 240 V

high efficiency 86%

standby power <0,1 W

efficiency class: VI

IP 67 enclosure

protections:

short-circuit protection SCP

surge protection (AC input)

overload protection OLP

warranty –2 years from production date

1. Technical description.

1.1.General description.

The PSU is intended for ~230 V mains supply to CCTV cameras that require stabilised voltage of 12 V DC.

The unit is protected against a short circuit and an overload and a surge.

1.2. Specifications.

Supply voltage

~100 - 240 V; 50/60 Hz

Current consumption

0,3 A

Supply power

12 W max.

Efficiency (average)

86%

Efficiency (10% load)

81%

Output voltage

12 V DC

Output current tAMB<30°C

1 A instantaneous current - refer to chart 1.

Output current tAMB=40°C

0,7 A - refer to chart 1.

Ripple voltage

100 mV p-p max.

Short-circuit protection SCP

electronic, automatic recovery

Overload protection OLP

105-150% of power supply, automatic recovery

IP protection class

IP67

Operating conditions

Temperature: 0oC - 40oC, relative humidity 20%...90%,

without condensation

Dimensions (LxWxH)

50 x 48 x 25 [mm]

Net/gross weight

0,09 / 0,125 [kg]

Protection class EN 62368-1

II (second)

Length of DC cable

0,5 m + plug DC5,5/2,1 female

Length of AC cable

0,3 m

Storage temperature

-20ºC...+60ºC

* In order to extend the life of the power supply, the load current of 0,7 A is recommended.

Chart 1.

Relation between output current and ambient

temperature (instantaneous load).

Fig.1. Mechanical view and dimensions of the PSU.

*Refer to chart 1

1.3. Accessories.

Available accessories for the power supplies are: fuse blocks and cable adapters. For details –visit www.pulsar.pl

2. Installation.

2.1. Requirements.

The power supply shall be mounted by a qualified installer, holding relevant permits and licenses (applicable and

required for a given country) with ~230 V mains supply. Unit should be mounted in confined spaces with normal relative

humidity (RH=90% maximum, without condensing) and temperature from 0°C to +40°C

The device should be installed in the metallic enclosure (cabinet, intended device). In order to meet the LVD and EMC

requirements, the rules concerning: supply, development and shielding ought to be followed - accordingly to the application.

2.2. Installation procedure.

1. Fit the power supply inside the box or other device.

2. Connect the DC cables to the load or to the terminal block.

3. Connect the power supply to the AC line.

4. After tests and operation control are performed, close installation box, case etc. and switch on the power.

3. Maintenance.

Any and all maintenance operations may be performed following the disconnection of the power supply from the power

network. The power supply does not require any specific maintenance procedures, however, in the case of significant level of

dust, it should be cleaned with compressed air.

WEEE LABEL

Waste electrical and electronic equipment must not be disposed of with normal household waste.

According to European Union WEEE Directive, waste electrical and electronic equipment should

be disposed of separately from normal household waste.

Pulsar sp. j.

Siedlec 150,

32-744 Łapczyca, Poland

Tel. (+48) 14-610-19-45

e-mail: [email protected]

http:// www.pulsar.pl

Otros manuales de Fuente de alimentación de Pulsar

Pulsar

Pulsar PSBOC1554828 Manual de usuario

Pulsar

Pulsar PSBOC352413 Manual de usuario

Pulsar

Pulsar HPSB 3524B Manual de usuario

Pulsar

Pulsar PSBS 3012C Manual de usuario

Pulsar

Pulsar POE0448 Manual de usuario

Pulsar

Pulsar PSC07510 Manual de usuario

Pulsar

Pulsar PSP24010 Manual de usuario

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manual de usuario

Pulsar

Pulsar AWZ 05122 Manual de usuario

Pulsar

Pulsar PSC07510 Manual de usuario

Pulsar

Pulsar MS 2012 Manual de usuario

Pulsar

Pulsar HPSBOC 2524B Manual de usuario

Pulsar

Pulsar Rack Power RSFUPS108 Manual de usuario

Pulsar

Pulsar PS-2002470 Manual de usuario

Pulsar

Pulsar PSCL12010 Manual de usuario

Pulsar

Pulsar ROUPS12VR Manual de usuario

Pulsar

Pulsar PSD12080 Manual de usuario

Pulsar

Pulsar HPSDC Series Manual de usuario

Pulsar

Pulsar PSB-12V10A Manual de usuario

Pulsar

Pulsar PSBS 1512A Manual de usuario

Pulsar

Pulsar HPSB 3512B Manual de usuario

Pulsar

Pulsar AWZ 110 Manual de usuario

Pulsar

Pulsar MSRK 13,8V/1A Manual de usuario

Pulsar

Pulsar PSBEN 3012D/LCD Manual de usuario

Manuales populares de Fuente de alimentación de otras marcas

Monacor

Monacor PS-12CCD Manual de usuario

VOLTIMA

VOLTIMA MagicBox 15 Manual de usuario

Agilent Technologies

Agilent Technologies 6032A Manual de usuario

Miller

Miller Auto Deltaweld 452 Manual de usuario

BCP

BCP PUOUBK Hoja de instrucciones

HC 2210 Manual de usuario

Puls

Puls CT5.241 Manual de usuario

OCZ

OCZ ZX1250W Manual de usuario

iseg

iseg ECH 238 Manual de usuario

Power

Power XXL A Series Manual de usuario

Agilent Technologies

Agilent Technologies 6631B Manual de usuario

Renogy

Renogy PHOENIX 300 Manual de usuario

HP 6200B Manual de servicio

Epson

Epson Stylus Scan 2500 Manual de funcionamiento

Puls

Puls MiniLine ML50.100 Manual de usuario

Puls

Puls AS-Interface SLA4.100 Manual de usuario

Kenwood

Kenwood PS-60 Manual de usuario

Elmdene

Elmdene G1380xN-y-s Series Manual de usuario