Pullman PV500 Manual de usuario
PV500 BACKPACK
1200W MOTOR
PV500
IDEAL FOR:
Offices
Schools
Restaurants
Gymnasiums
2
Always switch off the cleaner and remove the plug from the electricity
power supply before cleaning your appliance, when not in use. The cleaner
must only be connected to an AC power supply at the voltage shown on the
rating label. This cleaner should only be used for its intended purpose as
described in this instruction manual.
Never operate the vacuum cleaner without filters.
SAFETY PRECAUTIONS AND WARNING:
IMPORTANT
WHEN USING YOUR VACUUM CLEANER, BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED,
INCLUDING THE FOLLOWING;
1. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
2. Children should be supervised to ensure that
they do not play with the appliance.
3. To prevent electrical shock, do not immerse
the top cover of the appliance, power cord or
power plug into water or other liquids.
4. To prevent electric shock, do not use the
vacuum cleaner outdoors.
5. Always check the power cord before use, the
power cord and the plug should be in a good
condition and must not be damaged. If the
power supply cord is damaged or defective,
it must be replaced by the manufacturer, its
service agent or similarly qualified persons in
order to avoid a hazard.
6. Do not unplug by pulling on the power cord.
To unplug, grasp the plug not the power cord.
Use only Australian and New Zealand electrical
safety approved extension cords.
7. Do not pull or carry the appliance by the
power cable, use the power cable as a handle
or pull the power cable around sharp edges or
corners.
8. Ensure the appliance is switched off before
unplugging.
9. Do not handle or operate the appliance
with wet hands and follow electrical safety
precautions at all times.
10. Extreme caution should be exercised when
using the appliance on stairs.
11. Do not attempt to change the attachments
while the appliance is plugged in to Mains
power supply. Switch off and remove plug from
Mains power supply. Use only manufacturer’s
recommended accessories.
12. Do not operate the vacuum cleaner too close
to heaters, radiators and other hot surfaces.
13. Do not use the appliance to pick up flammable
items or combustible liquids (i.e. gasoline, hot
ashes cigarettes, matches, explosive materials
or anything burning) or use in areas where such
substances and items may be present.
14. Do not use the appliance to pick up toxic
materials (i.e. chlorine bleach, ammonia).
15. Ensure the appliance is disconnected from the
Mains power supply before connecting the
hose to the unit.
16. Before vacuuming, remove any large or sharp
objects from the floor or cleaning surface in
order to prevent damage to the filter.
17. If the air inlet, floor head or the telescopic tube
is blocked, switch off the cleaner straight away
and remove from the Mains power. First clear
the blocked object before attempting to start
the cleaner vacuum again.
3PULLMAN BACKPACK PV500
BEFORE YOU BEGIN
THIS MACHINE IS EQUIPPED WITH A CORD AND PLUG. IN THE EVENT THAT EITHER OF THESE PARTS
GET DAMAGED, IT MUST BE REPAIRED BY A QUALIFIED TECHNICIAN.
18. Do not leave the appliance unattended when it
is connected to a Mains power supply.
19. Before carrying out any maintenance service
or cleaning the filters, always switch off the
vacuum cleaner and disconnect the plug from
power supply.
20. Keep ends of the hose, telescopic tube and
other openings away from your face and body.
21. Do not use the vacuum cleaner if it is
damaged or breaks down. Check the
electrical regularly for defects. If connection
cables, electrical hoses, electrical contacts
and electrical tubes are damaged, have them
replaced immediately.
22. Never clean any of the electrical parts,
especially the electrical connections with water
or liquid cleaners.
23. Never attempt to make any modifications
electrically to the vacuum cleaner.
24. Always store the appliance indoors in a cool
and dry place.
25. For indoors use only.
26. Damage caused by improper use or by not
observing the instructions in this manual will
void warranty.
1. Do not operate the vacuum cleaner too close to heaters, radiators,
cigarette butts etc.
2. Before you insert the plug into the Mains power supply, make sure your
hand is dry.
3. Before you start using the Backpack, please remove large or sharp objects from
the floor in order to prevent the paper filter being damaged.
4. When you remove the plug from the Mains power supply, please do
this at the plug itself and not by the electrical cable.
5. Do not use Backpack to pick up water or liquids.
4
KNOW YOUR PRODUCT
9.
10.
8.
1.
3.
7.
2.
4.
5.
6.
Technical Information
Model: PV500
220-240V~ 50Hz
Max Power: 1100W
Motor: 120 0W
Tank Size: 4L
Hose: 1.5M Flexible Hose
Cord Length: 15M
Net Weight: 5.6KG
Noise Level: 74dBA
1. 32mm Flexible Hose
2. Dust Bin Lid Latch
3. 2 x 32mm Chrome Rods
4. Gulper Floor Tool
5. Exhaust Filter Grille
6. Hose Inlet
7. Cord Hook
8. On/Off Switch
9. Cable Holder
10. Tools Belt
11. Brush Brush
12. Crevice Tool
13. Dust Bag
14. Cloth Filter Bag
15. Pre-Motor Sponge Filter
16. Exhaust Filter
11. 12. 13. 14. 15. 16.
5PULLMAN BACKPACK PV500
ASSEMBLY
Assembling the Hose and Floor Tools
ALWAYS SWITCH OFF YOUR BACKPACK AND REMOVE THE PLUG FROM THE MAINS POWER
SUPPLY BEFORE CLEANING YOUR APPLIANCE, ASSEMBLING, WHEN NOT IN USE OR ATTEMPTING
ANY MAINTENANCE TASK.
CONNECTING THE HOSE
1.
To fit the hose, insert into the hose inlet at the top
of the Backpack. Turn the hose end until it locks
into place.
2. To remove the hose, twist the hose end until it
loosens.
FITTING THE 2-PIECE ROD AND FLOOR TOOL
1. Connect the 2-piece rod together.
2. To fit the floor tool to the rod, gently insert the rod
into the top of the floor tool as shown.
NOTE: THE GULPER FLOOR TOOL IS IDEAL FOR CLEANING
ON CARPETS AND HARD FLOORS.
3. To fit the rod to the handle, gently insert the end
of the handle into the top of the rod.
6
CONNECTING THE CREVICE TOOL
1. Insert the end of the rod into the crevice tool. Ensure
that it is a snug fit.
NOTE: THE CREVICE TOOL IS PERFECT FOR REMOVING DUST
FROM HARD TO REACH PLACES SUCH AS FROM CORNERS
AND IN BETWEEN CUSHIONS.
FITTING THE DUSTING BRUSH
1. Insert the end of the rod into the dusting brush. Ensure
that it is a snug fit.
NOTE: THE DUSTING BRUSH IS IDEAL FOR CLEANING
SURFACES SUCH AS BLINDS, BOOKSHELVES AND DESKTOPS.
IMPORTANT:
Do not use your Backpack if the power cord is damaged,
or there are exposed internal wires. Do not use your
Backpack if the motor housing is damaged.
CAUTION:
The motor housing contains electrical connections. The
motor housing is not a serviceable part. Please return the
product to your nearest Godfreys store if the the motor is
faulty or if the cords are damaged.
ASSEMBLY (CONTINUED)
7PULLMAN BACKPACK PV500
ACCESSORIES
Crevice Tool
Eliminate dust from hard-to-reach places like radiators,
crevices, corners, baseboards or between cushions with
this easy-to-use tool.
Dusting Brush
Ideal for cleaning blinds, bookshelves and lampshades.
THE GULPER FLOOR TOOL IS IDEAL FOR
CLEANING ON CARPETS AND HARD FLOORS.
CARPET HARD FLOORS
8
FITTING YOUR BACKPACK
Your Backpack comes with straps fastened for ease of packing. Before fitting the Backpack onto your
back, first loosen the various harness straps.
1. Ensure your arms are through the harness. Buckle the hip belt ensuring the Backpack is resting on
your hip bone. Tighten by pulling the hip belt side straps.
2. Tighten the shoulder straps by adjusting and pulling down on the ends of the two straps.
3. Buckle the Sternum Strap across your chest and adjust as needed.
Sternum Strap
Shoulder Strap
Shoulder Strap
Hip Belt
IMPORTANT
THE UNIT IS ERGONOMICALLY CORRECT WHEN THE WEIGHT IS DISTRIBUTED OVER
THE WAIST AND NOT ON THE SHOULDERS.
INSTRUCTIONS FOR USE
9PULLMAN BACKPACK PV500
OPERATING YOUR BACKPACK
1. Fit the unit onto your back.
2. To switch on the cleaner press the On/Off button.
SUCTION RELIEF VALVE
1. If the floor tool becomes difficult to move during
vacuuming, adjust the Air Relief Valve to reduce the
suction pressure.
USING THE ACCESSORIES HOOK
1. In between jobs, accessories can be stored on the
waist strap for convenient access by sliding the
accessories into the elastic openings.
OFF
ON
10
MAINTENANCE
ATTENTION: DISCONNECT FROM MAINS POWER SUPPLY BEFORE DOING
ANY MAINTENANCE WORK. ALWAYS OPERATE THE CLEANER WITH THE
CLOTH FILTER BAG AND PAPER DUST BAG CORRECTLY INSTALLED. THIS WILL
PREVENT ANY DAMAGE TO THE CLEANER AND HELP MAXIMISE CLEANING
PERFORMANCE.
REPLACING THE DUST BAG
1. Unfasten the Dust Bin Lid Latches, as shown, to release
the dust lid bin.
4. Fasten the Dust Bin Lid Latches.
2. Remove the dust bin lid to access the dust bag.
3. To replace the dust bag, simply lift the dust bag out of
the Backpack, as shown, and replace with a new dust
bag.
Tabla de contenidos
Otros manuales de Aspiradora de Pullman
Pullman
Pullman WD20LSSO Manual de usuario
Pullman
Pullman WD30BV1 Manual de usuario
Pullman
Pullman S20 Manual de usuario
Pullman
Pullman CB80 Manual de usuario
Pullman
Pullman PV 14 Manual de usuario
Pullman
Pullman A-031b Manual de usuario
Pullman
Pullman COMMANDER 900 Manual de usuario
Pullman
Pullman Steam Works SC388L Manual de usuario
Pullman
Pullman PC4.0 Manual de usuario
Pullman
Pullman LITHIUM 950 Manual de usuario
