Malfunctions analysis & troubleshooting
1. The product shall be installed and serviced by a qualified person.
2. This product is non-waterproof. Please avoid the sun and rain.
3. Good heat dissipation will prolong the working life of the controller, please ensure good ventilation.
4. Ensure all wire connections and polarities are correct and secure before applying power to avoid any
damages to the LED lights.
5. If a fault occurs please return the product to your supplier. Do not attempt to fix this product by yourself.
Safety information
● Long press ◀ and ▶ key for 2s, restore factory default parameter, display"RES".
● Factory default parameter: DMX decode mode, DMX first address is 1, rerverse-phase control,
10% minimum brightness, dimmer mode number is 1, dynamic mode number is 1, disable automatic
blank screen.
Malfunctions
Causes Troubleshooting
1. No power.
2. Wrong connection or insecure.
1. Check the power.
2. Check the connection.
No light
1. Set corrrect decode address.
Wrong brightness 1. DMX decode address error.
Dynamic mode list
Name
P-1
P-2
No.
0%,50%,100% light change in sequence
light fadein and fadeout
● Short press M key, when display P-1~P-2,
enter stand-alone dynamic mode.
● Press ◀ or ▶ key to change dynamic mode
number(P-1~P-2). Stand-alone dynamic mode
● Each mode can adjust speed and brightness.
Long press M key for 2s, prepare for setup mode speed, brightness.
Short press M key to switch two item.
Press ◀ or ▶ key to setup value of each item.
Mode speed: 1-10 level speed(S-1, S-9, S-F).
Mode brightness: 1-10 level brightness(b-1, b-9, b-F).
Long press M key for 2s, or timeout 10s, quit setting.
● Enter stand-alone dynamic mode only when DMX signal
is disconnected or lost.
Speed
(8 level)
Brightness
(10 level,100％)
(P-1~P-2)
Stand-alone dynamic mode
Restore factory default parameter
● Long press M and ◀ key for 2s, prepare for setup system parameter: control method, minimum brightness
curve, automatic blank screen.
short press M key to switch three item.
● Control method: short press ◀ or ▶ key to switch forward-phase("C-F") or reverse-phase("C-R").
Operation
System parameter setting
● Minimum brightness: short press ◀ or ▶ key to set minimum brightness,
from 1% to 40%("b01" to"b40").You need set suitable minimum brightness to avoid flick.
● Automatic blank screen: short press ◀ or ▶ key to switch enable ("bon") or disable("boF")
automatic blank screen.
● Long press M key for 2s or timeout 10s, quit system parameter setting.
● Short press M key, when display 001~999, enter DMX mode.
● Press ◀ or ▶ key to change DMX decode address(001~999),
long press for fast adjustment.
● If there is a DMX signal input, will enter DMX mode automatically.
DMX mode
● Short press M key, when display L-1~L-8, enter stand-alone dimmer mode.
● Press ◀ or ▶ key to change dimmer mode number(L-1~L-8).
● Each dimmer mode can adjust brightness independently.
Long press M key for 2s, prepare for adjust brightness.
Press ◀ or ▶ key to adjust brightness value(100-1FF).
Long press M key for 2s, or timeout 10s, quit setting.
● Enter stand-alone dimmer mode only when DMX signal
is disconnected or lost.
DMX mode
(001~999)
Stand-alone dimmer mode
(L-1~L-8)
Stand-alone dimmer mode
