AC VOLTAGE MEASUREMENT
I . Connect the red test lead to .V.O. mA, jack and the black
test tead to the "COM, jack.
2. Set the rotary switch aidesired ACV position.
3. Conneci lest leads across the source o, load being
measured.
4. Read voltage value on the LCD display.
RESISTANCE MEASUREMENT
1. Connect lhe red test lead to "V. O. mA" jack and black
test tead to the "COM" jack. (The potarity oi reOieaO is
positive "+".)
2. Set the rotary switch at desired 'O" range position.
3. Connect test leads across lhe resistor-to'oe'rieasurec
and read LCD display.
4. lf the resistance being measured is connected to a
circuit, turn off power and discharge all capaiitois Oetore
apptying test probes.
DIODE TEST
1. Connect the red test lead to "V.O.mA" jack and the black
test tead to the .COM" jack (The potjrity of reC LaO is
Positive "+".).
2. Set the rotary switch at "ll-'position.
3. Connect the red tesl lead to the anode of the diode to be
tested and the black test lead to the cathode oitn" AnO".
Tie approx. fonivard voltage drop of the Oioje-"ifl O"
displayed. lf the connection is reversed, onfi f,gri" "f ,
will be shown.
TRAI,ISISTOR TEST
1. Set the rotary switch at "hFE" position.
2. Determine whether the transisior under testing is NpN or
pNp and tocate the emitter, base and ;ile;;; ieads.
lnsert the leads into proper holes ot tne nFg socfet on
the front panel.
3. Read the approximate hFE value at the test condition of
base curent 10pA and Vce 3V.
