5. Cleaning and decontamination:
Cleaning method: Do not use abrasives or solvents on the
meter, to clean it with only dry cloth.
6. Operating Environment:
1) Environment of use: Indoor use, 5-40 C°. max. 80%R.H.
2) Storage condition: -5C°-50C°
IV. WARNING!!!
1. Read the instruction before use to ensure that the meter is
used safely and is kept in good condition.
2. Do not exceed the limit indicated in the specications for
each range of measurement.
3. Do not touch the unused terminals when other terminal is
connected to measurement circuit.
4. Keep ngers behind the probe barriers while measuring.
5. Do not perform resistance measurement on energized
circuit.
6. Before attempting to plug or unplug the probe onto this
multimeter, be sure the probe leads have been discon -
nected from measuring circuit.
7. Before use of hFE socket, be sure the probe leads have been
disconnected from other measuring circuit.
Battery:
Model Open-Circuit Discharge Loss of-charge Discharge Terminal
Voltage Resistance method Time Voltage
6LF22 9V-10.7V 620SZ 2h/d 24(h) 5.44
Fuse: Model: 0.2A/250 V VDE: Size: 5 x 20mm
Thanks for buying our products. Please go through the
instruction manual before starting to use the meter.
I. INTENDED USE
This Measurement Category II multi-meter can be used to
perform measurement on circuits directly connected to the
low voltage installation, for example, household appliances,
portable tools and similar equipment.
II. INTRODUCTION:
1. SWITCH: Our DMM adopt rotational switch which situated
at the middle of the front case. It is used for the selection
of FUNCTION RANGE AND POWER ON-OFF. In order to save
energy, please turn the switch to “OFF” position when not
in use.
2. DISPLAY: 3 1/2, 12mm height LCD display
3. “COM” jack: Common jack
4. “VΩmA” jack: Voltage, resistance not more 200mA current
and battery input test jack.
5. “2A” jack: For the current input of more than 200mA.
III. MAINTENANCE:
1. Always check the screw, LCD and enclosure, if there is any
crack, broken or loose, the meter is not in a safe condition,
DO STOP using it.
2. Repair should be carried out by qualied person only.
3. Remove batteries if it is not be used for a long period
of time.
4. Close case and tighten screws completely if the case is
opened for replacement of battery or fuse.
ENG ENG
