Promise E610f Manual de usuario

VTRAK

E-Class

E610f, E610s, E310f, and E310s

QUICK START GUIDE

Kurzanleitung

Guide de démarrage rapide

Guida Introduttiva

Guía de inicio rápido

Руководство по быстрому началу

работы

クイックスタートガイド

快速安裝手冊

快速安装手册

빠른 시작 안내서

Version 2.1

VTrak E-Class Quick Start Guide

Contents

English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Deutsch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .45

Français . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .90

Italiano . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .134

Español . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .177

Pусский язык . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .220

日本語 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .263

繁體中文 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .304

简体中文 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .347

한국어 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .389

Step 1: Unpacking the VTrak

VTrak E-Class Task List

Step 1: Unpacking the VTrak (below)

Step 2: Mounting VTrak in a Rack

• E610f/s (page 7)

• E310f/s (page 9)

Step 3: Installing Disk Drives (page 12)

Step 4: Making Management and Data Connections

• Fibre Channel (page 16)

• Serial Attached SCSI (page 21)

Step 5: Setting Up Serial Cable Connections (page 27)

Step 6: Connecting the Power (page 28)

Step 7: Setting the IP Address (page 29)

Step 8: Creating Disk Arrays with WebPAM PROe (page 35)

For complete information about your VTrak E610f/s or E310f/s subsystem, see

the

VTrak E-Class Product Manual

on the CD.

Step 1: Unpacking the VTrak

The VTrak box contains the following items:

•VTrakUnit

• Quick Start Guide

• Front bezel and key

(E310f and E310s only)

• Left and right center-mount

brackets

• Left and right mounting rails

• RJ11-to-DB9 serial data cable

• Screws for disk drives

(E610f/s: 70, including 6 spares)

(E310f/s: 50, including 2 spares)

• 1.5m (4.9 ft) Power cords (2)

• CD with SNMP files,

Product

Manual

and

Quick Start Guide

Warning

The electronic components within the VTrak disk array are

sensitive to damage from Electro-Static Discharge (ESD).

Observe appropriate precautions at all times when handling the

VTrak or its subassemblies.

VTrak E-Class Quick Start Guide

Figure 1. VTrak E610f/s front view

Figure 2. VTrak E310f/s front view with bezel removed

A defective drive may be replaced without interruption of data availability to the

host computer. If so configured, a hot spare drive will automatically replace a

failed drive, securing the fault-tolerant integrity of the logical drive. The self-

contained hardware-based RAID logical drive provides maximum performance in

a compact external chassis.

Important

Use the following categories of network cables with VTrak:

• Cat 6, preferred

• Cat 5E, minimum

Drive Carrier LEDs

Drive Carriers Power and Status LEDs

Drive Carrier LEDs

Drive Carriers Power and Status LEDs

Step 1: Unpacking the VTrak

Figure 3. VTrak E610f rear view

Figure 4. VTrak E610s rear view

Mgmt UPS

115200

8 N 1

FC 1 FC 2

Gb/s

Mgmt UPS

115200

8 N 1

FC 1 FC 2

Gb/s

RAID Controller 1

Power Supply 1 Power Supply 2Cooling Unit 1

with Battery Cooling Unit 2

with Battery

RAID Controller 2

Mgmt UPS

115200

8 N 1

Mgmt UPS

115200

8 N 1

RAID Controller 1

Power Supply 1 Power Supply 2Cooling Unit 1

with Battery Cooling Unit 2

with Battery

RAID Controller 2

VTrak E-Class Quick Start Guide

Figure 5. VTrak E310f rear view

Figure 6. VTrak E310s rear view

Mgmt UPS

115200

8 N 1

FC 1 FC 2

Gb/s

Mgmt UPS

115200

8 N 1

FC 1 FC 2

Gb/s

RAID Controller 1

Power Supply 1 Power Supply 2Cooling Unit 1

with Battery Cooling Unit 2

with Battery

RAID Controller 2

Mgmt UPS

115200

8 N 1

Mgmt UPS

115200

8 N 1

RAID Controller 1

Power Supply 1 Power Supply 2Cooling Unit 1

with Battery Cooling Unit 2

with Battery

RAID Controller 2

Step 2: Mounting VTrak in a Rack

E610f/s

The E610f/s subsystem installs to the rack using the supplied mounting rails. You

can also use your existing rails.

Figure 1. VTrak E610f/s mounted in a rack with the supplied rails

To install the E610f/s subsystem into a rack with the supplied mounting rails:

1. Check the fit of the mounting rails in your rack system. See Figure 2.

2. Adjust the length of the mounting rails as needed.

Cautions

• At least two persons are required to safely lift, place, and

attach the VTrak subsystem into a rack system.

• Do not lift or move the VTrak subsystem by the handles,

power supplies or the controller units. Hold the subsystem

itself.

• Do not install the VTrak subsystem into a rack without rails to

support the subsystem.

• Only a qualified electrician who is familiar with the installation

procedure should mount and install the VTrak subsystem.

• Be sure all switches are OFF before installing the VTrak

subsystem or exchanging components.

Vertical Rack Post VTrak E610f/s

Mounting rails (included)

mount outside the rack post

Handles mount

outside the rack post

VTrak E-Class Quick Start Guide

3. Attach the mounting rail assemblies to the outside of the rack posts, using

the attaching screws from your rack system.

Be sure the support is on the bottom facing inward.

4. Square the rail assemblies in the rack.

5. Tighten the adjustment screws and the attaching screws.

6. Place the VTrak subsystem onto the rails.

7. Secure the VTrak subsystem to the rack through each handle, using the

attaching screws from your rack system.

Figure 2. Rack mount assembly diagram

Inside of post

Rack front post

Rail attaching screw

(not included)

Rail adjustment screw

Flange

Rail attaching screw

(not included)

Inside of post

Rack back post

Front rail

Rail adjustment screw

Rear rail

Support

Step 2: Mounting VTrak in a Rack

E310f/s

The E-Class subsytems installs to the rack using the supplied mounting rails. You

can also use your existing rails.

Figure 3. VTrak E310f/s mounted in a rack with the supplied rails

To install the VTrak subsystem into a rack with the supplied mounting rails:

1. Check the fit of the mounting rails in your rack system. See Figure 5.

2. Slide the plates out of the mounting rails.

3. Attach one plate to each side of the VTrak subsystem.

Line-up the six holes in the plate with the corresponding holes in the

subsystem. Attach each plate with six screws (included). See Figure 4.

4. Slide one of the rails over the plate on one side of the enclosure.

Cautions

• At least two persons are required to safely lift, place, and

attach the VTrak subsystem into a rack system.

• Do not lift or move the VTrak subsystem by the handles,

power supplies or the controller units. Hold the subsystem

itself.

• Do not install the VTrak subsystem into a rack without rails to

support the subsystem.

• Only a qualified electrician who is familiar with the installation

procedure should mount and install the VTrak subsystem.

• Be sure all switches are OFF before installing the VTrak

subsystem or exchanging components.

Vertical Rack Post VTrak E310f/s

Mounting rails (included)

mount outside the rack post

Handles mount

outside the rack post

VTrak E-Class Quick Start Guide

The rail is designed to slide freely over the plate.

5. Attach a flange to each end of the rail, with the rail on the opposite side of the

flange from the two-hole bracket.

6. Install the rail adjustment screws (included) through the flange into the rail.

There are four screws for each flange. See Figure 5.

7. Place the subsystem with mounting rails into your rack system.

8. Attach the mounting rail assemblies to the outside of the rack posts, using

the attaching screws from your rack system.

9. Square the rail assemblies in the rack.

10. Tighten the adjustment screws and the attaching screws.

11. Place the VTrak subsystem onto the rails.

12. Secure the VTrak subsystem to the rack through each handle, using the

attaching screws from your rack system.

Figure 4. Sliding flange installation

Sliding plate

VTrak E310f/s

Screws (6 each side)

Rear (connector end)

of the subsystem

Otros manuales para E610f

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Almacenamiento de Promise

Promise

Promise Vess A8020 Manual de usuario

Promise

Promise Apollo Manual de usuario

Promise

Promise VessJBOD 1000 Series Manual de usuario

Promise

Promise VTrak N1616 Manual de usuario

Promise

Promise SmartStor NAS Manual de usuario

Promise

Promise Pegasus2 R2+ Manual de usuario

Promise

Promise Vess A7000 Series Manual de usuario

Promise

Promise Vess A2600 Manual de usuario

Promise

Promise Pegasus M4 Manual de usuario

Promise

Promise E610f Manual de usuario

Promise

Promise VTrak J830s Manual de usuario

Promise

Promise Pegasus J2 Manual de usuario

Promise

Promise VSky A1100 Manual de usuario

Promise

Promise SmartStor DS4600 Manual de usuario

Promise

Promise Pegasus2 R6 Manual de usuario

Promise

Promise VTRAK M610i Manual de usuario

Promise

Promise Vess A Series Manual de usuario

Promise

Promise Smartstor NS4600 Manual de usuario

Promise

Promise VTRAK J300S Manual de usuario

Promise

Promise VSkyCube c10X Instrucciones de instalación

Promise

Promise ULTRATRAK RM4000 Manual de usuario

Promise

Promise Vess A3340s Manual de usuario

Promise

Promise SmartStor DS4600 Manual de usuario

Promise

Promise Apollo Cloud 2 Duo Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario