5
Model : XXXXX
Type : XXXXXXXX
Serial number : XXXXXXXXXX / 3
Rated voltage : XXXXXXXX
Rated power input : XXX W
With Airco : XXX W
Manufactured by: Hapro International B.V.
PO Box 73
4420 AC Kapelle, Netherlands
XXXXX_XX
UV type 3 (Total Erythema output limited at 0,3W/m3)
30 x maxlight 160W-R CE III
160-R-(21-28)/(2,2-3)
22 x maxlight XL180W-R CE III
180-R-(21-28)/(2-2,6)
22 x maxlight HP 500W S or maxlight HP 500W D
Main Filter: SPS (Art. nr. 15691) Ballast: 320W
Lamp information
The lamps listed below are those that are installed as standard equipment at the factory. These standard lamps have been selected for
optimal tanning results and to match the UV classication of your tanning unit. We recommend that when you replace a lamp you only
use lamps of the type currently installed in your tanning unit and which are listed in the table below and on the identication plate. If you
choose to install a dierent type of lamp, you must only use lamps that are marked with an equivalent code which indicates that the UV
component falls within the equivalence range listed on the identication plate.
Note: The total erythema is limited to 0.3 W/m² for all UV types within the EU.
Note: The equivalent code is only applicable to low-pressure uorescent lamps.
Example:
On the example identication plate the equivalent codes for the installed canopy and bench lamps are
circled.
The equivalent code for the canopy is 160-R-(21-28)/(2.2-3)
160 = the wattage of the lamp
R = the reector type
(21-28) = the equivalence range for the total eective erythema
(2.2-3) = the equivalence range for the NMSC ratio
If you intend to install a new lamp, the wattage and reector type must always match the equivalent code
on the identication plate. The eective erythema and NMSC ratio must also match the specied range.
You may only use a lamp other than the recommended type if all of these criteria are met. You must also be
aware that:
a. The tanning unit is likely to be less eective in terms of tanning performance.
b. The circuit protection for your tanning unit must be adapted because the electrical current
consumption will have changed.
c. The UV classication no longer matches the original classication shown on the identication plate.
d. We will not necessarily honour warranty claims arising from the use of lamps other than those we
recommend, because the technical operation of your tanning unit might be aected.
Lamps Art nr equivalent code UV type (EU countries) UV type (non-EU countries)
maxlight L 100W-R CE III 12806 100-R-(22-29)/(2,7-3,7) 3 3
maxlight 80W-R CE III 12792 80-R-(20-26)/(2,2-3) 3 3
maxlight 100W-R CE 0,3 16997 100-R-(18-24)/(2-2,6) 2 3
maxlight 100W-R CE III 12797 100-R-(17-22)/(2,1-2,9) 3 3
maxlight 100W-R High Intensive 12801 100-R-(38-50)/(5,1-6,9) May not be used 5
maxlight L 100W-R High Intensive 12808 100-R-(46-61)/(5,8-7,8) May not be used 5
maxlight 80W-R High Intensive 13603 80-R-(49-65)/(6,7-9,1) May not be used 5
Power facial tanner Filter 1 Filter 2 UV type (EU countries) UV type (non-EU countries)
300W SPS Diamant 3 3
