3. RECOMMENDATION
- Ensure that the product is securely attached, preventing the MTD2.4 from falling during
vehicle movement.
ATTENTION: Attachment failure may cause accidents.
- The MTD must be installed in a region of the vehicle where it is protected from
scratches and shocks;
- Do not handle or transport the MTD through its power cable;
- Never pierce the case;
- The magnet on the base of the GPS wire antenna must be installed in a grounded
metallic point of the vehicle. The receiving base should be facing upwards.
- The GPS wire must be installed on the outside of the vehicle to ensure perfect
synchronization with the satellites.
- Synchronizing satellites signals may take some time, especially if it is the first time the
MTD has been turned on in a new location.
- The wire cable should be secured and not in contact with any sharp surface;
- Do not paint the GPS antenna with (metallic) paint, as this causes interference and
consequent malfunction of the product;
