Pro-Ject Audio Systems Phono Box Manual de usuario

PRO-JECT

AUDIO

SYSTEMS

INSTRUCTIONS

FOR

USE

Pro-Ject Phono Box

Dear

music lover,

thank you

for

purchasing a PRO-JECT

AUDIO

phone amplifier.

order

to achieve maximum performance and reliability you should study these instructions

for

use carefully.

\!1

Warning

hazard

for

the

user,

the unit

possible

misuse.

Important notice.

Setting

the

cartridge

mode

The phone amplifier must be used in either

(moving magnet)

(moving coil) mode according to the

construction principle

the pickup cartridge to be used. Since most cartridges

use

the

(moving magnet)

principle the phone amplifier

factory set to operate in this mode. To find

out

which type

your

cartridge

please consult the literature accompanying your cartridge. The literature

for

cartridges should also specify

the correct

impedance

and capacity into which the cartridge is designed to work.

doubt

please consult

your dealer.

A switch

the back

the phone amplifier

sets

the correct level

amplification

for

the cartridge.

\!1

Before setting MM I

mode

the unit must

disconnected

from

the power supply

and

amplifier.

Connecting

the

record

player

Conned

the tonearm signal lead to the

the phone amplifier. The earthing wire may be connected to the

screw terminal

you encounter hum problems when using the record player.

Take care to

conned

the left and right channels correctly. The right channel

usually marked red, the left

channel black

white. The earthing wire

the tonearm lead should be connected

the earth terminal.

/'CE;!

Left

Right

~~~~·

MMI

Left

f~:l

[]I

RoHS

•

··.·

( i

>Uin ...

•(

\ )

~/Out

Pro-Ject Audio Systems, Vienna, Austria

0-<....e

~~~----~~--~~~~~~~----~--~~~~/

SN:

Connection

the

amplifier

Connect

the

Out

the

phone

amplifier

to a line

input

(such

AUX, CD, Tuner, Tape

Video)

your

amplifier.

Take care to

conned

the left and right channels correctly. The right channel

usually marked red, the left

channel black

white.

Make

all connections whilst the phono amplifier

disconnected from the power supply.

Do not

conned

the phono amplifiers output

to a

phono input (sometimes labelled

gram,

disc

RIAA)

the amplifier.

Mains

power

connection

The phone amplifier

supplied with a power supply suitable

for

your country•s mains supply. Check the label

before connecting

ensure compliance with the mains rating in your house.

Conned

the

low

voltage plug

from the

power

supply to the Power

18V-

socket

the phone amplifier before connecting the

power

supply

to the mains.

Audio T

rode

GmbH

Pro-Jed

Phone

Box

Revision

2011

.12.1

Technical specifications Pro-Ject Phono

Box

Input impedance,

MC:

Gain,

MC:

Output

voltage typically,

MC:

Max. output:

Noise floor,

MC:

THD,

MC:

47kohms/120pF

OOohms/120pF

40dB

60dB

300mV

1kHz-

3mV (MM Input)

0,3mV

(MC input)

9,5V

(1kHz)

86dB

(94dB

-A

weighted)

68dB (75dB

-A

weighted)

0,01

0,05%

RIM-equalisation curve accuracy:

20Hz

20kHz

max.

0,5dB

Input: 1

pair

RCNphono

sockets

Line-level output: 1

pair

RCNphono

sockets

Outboard

power supply:

18V

/500mA

DC, suitable

for

your country's mains supply

Power consumption:

18V/80mA

Dimensions W x H x D

with sockets):

103

104

(115)mm

Weight: 5

70g

without power supply

Potential incorrect use

and

fault conditions

signal on one

both channels:

connection between player and

phone

amplifier ore amplifier. This could be due to a faulty plug,

broken wire

solder joint

simply loose plug/socket connection.

Strong hum:

earth connection from cartridge

arm

arm cable

phone amplifier,

earth loop.

Output

too

quiet

too loud,

distorted:

mode incorrectly

set-

input overloading

insufficiently amplified.

Service

Should you encounter a problem which you are not able to alleviate

identify despite the above information,

please contact your dealer

for

further advice.

Only

when the problem cannot

resolved there should the

unit

sent to the responsible distributor in your country.

Warranty

The

manufacturer

accepts

responsibility

for

damage

caused

not adhering to these instructions

for use. Modification or change to

any

port

the product

unauthorized persons

release

the

manufacturer from

any

liability

over

and

above

the lawful rights

the customer.

PRO-JECT

a Registered Trademark

Lichtenegger.

This guide was produced

by:

Audio Trade

GmbH

2011.

The information

was

correct at the time

going to

press.

The manufacturer reserves the right to make

changes to the technical specification without prior

notice

deemed necessary to uphold the ongoing

process

technical development.

©Audio

Trade

GmbH·

Pro-Ject

Phone

Box

Revision

2011.12.1 3

Otros manuales de Amplificador de Pro-Ject Audio Systems

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box DS2 Mono Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xpression II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box Design Pre Box RS2 Digital Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Head Box S Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box RS Mono Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box Design Pre Box DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems A/D Phono Box S Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems DS2 Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box Mono Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box RS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Stereo Box S Phono Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject MaiA DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Stereo Box Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems BOX-DESIGN Vinyl NRS Box S3 Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject Audio Systems Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Head Box SE II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box USB Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box SE II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box SE Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box Manual de usuario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario