Primare A30.5 Manual de usuario

Primare A30.5 Amplifier User Guide

§0 Preface 19/2/01, 11:30 am1

>Preface

Primare Systems AB

Idavägen 17D

SE-352 46 Växjö

Sweden

The information in this guide is believed to be correct as of the date of

publication. However, our policy is one of continuous development and so the

information is subject to change without notice, and does not represent a

commitment on the part of Primare Systems AB.

Primare is a trademark of Primare Systems AB. All other product names are

trademarks or registered trademarks of their respective owners.

Warning: To prevent fire or shock hazard, do not expose this unit to rain or

moisture.

Dangerous voltages inside. Do not open the cabinet. There are no user

serviceable parts inside. Repairs should be carried out by qualified service

personnel only.

The A30.5 is extremely heavy. Do not attempt to lift it unaided.

Do not cover, or partially cover, the cooling vents. Place the unit on a hard, flat

surface to ensure air circulation on all sides. Do not place the unit on carpet or

other very soft materials since this might block the bottom vents.

FCC Warning: This equipment generates and can radiate radio frequency

energy and if not installed and used correctly in accordance with our

instructions may cause interference to radio communications or radio and

television reception. It has been type-tested and complies with the limits set out

in Subpart J, Part 15 of FCC rules for a Class B computing device. These limits

are intended to provide reasonable protection against such interference in

home installations.

EEC: This product has been designed and type-tested to comply with the limits

set out in EN55013 and EN55020.

This guide was produced by Human-Computer Interface Ltd,

http://www.interface.co.uk

§0 Preface 19/2/01, 11:30 am2

iii

Contents

Introduction

WELCOME TO THE A30.5 AMPLIFIER........... (1

USING THE A30.5 WITH OTHER PRIMARE

PRODUCTS................................................................ (1

TECHNICAL SPECIFICATION............................. (2

Connecting the A30.5 Amplifier

BACK PANEL CONNECTIONS........................... (3

POWER CONNECTION........................................ (4

OUTPUTS................................................................... (4

INPUTS....................................................................... (4

REMOTE LINK.......................................................... (4

Index

§0 Preface 19/2/01, 11:30 am3

>Preface

§0 Preface 19/2/01, 11:30 am4

Introduction

Welcome to the Primare A30.5 Amplifier! This chapter introduces you to its key

features, and explains how you can take advantage of its impressive power

handling and superb sound in your system.

WELCOME TO THE A30.5 AMPLIFIER

The A30.5 is a modular power amplifier designed as the ideal output stage in

a home theatre system.

Modular design

The A30.5 is designed as five independent blocks, each with a separate

transformer and power supply, for the ultimate in stability and channel

separation.

Generous power handling

Each section of the A30.5 delivers 120 Watts into 8Ω, giving sufficient power

reserves for home cinema or the reproduction of recorded music. An over-

dimensioned heat sink gives excellent thermal dissipation.

Superb quality

The A30.5 delivers its power at an outstanding quality level, making it as

suitable for reproducing high quality recorded music as for home cinema.

Remote power on/off

For convenience the A30.5 can be powered on and off via a remote link

cable, avoiding the need to switch it on or off separately from the preamplifier

in the system.

USING THE A30.5 WITH OTHER PRIMARE

PRODUCTS

Although the A30.5 is flexible enough to act as the output stage in virtually

any system, it is ideal for use with other products in the Primare range, such as

the Primare P30 Processor. The A30.5 can be used as a building block in

conjunction with the Primare A30.2 and A30.3 to create modular systems with

any desired number of matched output stages, and one or more A30 Series

amplifiers can be powered on or off remotely from a P30 using the remote link

connections.

§1 Introduction 19/2/01, 11:30 am1

>Introduction

TECHNICAL SPECIFICATION

Outputpowerper channel 120W into 8Ω, 200W into 4Ω

Outputimpedance <0.03Ω

Lineinputs 1Vfor 120W into 8Ω

Inputimpedance 10kΩ

Frequencyresponse <10Hz– 80kHz, -3dB

THD <0.08%(1kHz10V in 8Ω)

Signal-to-noise <100dB

DCoffset <5mV

PowerconsumptionStandby0W

Dimensions(WxDxH) 430x 385 x 175mm

Weight 28kg

§1 Introduction 19/2/01, 11:30 am2

Connecting the A30.5 Amplifier

This chapter explains how to connect the A30.5 to the other components in your

system, using the connections on the back panel.

BACK PANEL CONNECTIONS

]C Remote link sockets.

]D Remote link switch.

]A Phono input.

]B Loudspeaker outputs.

]E Mains power input and fuse.

REMOTE SWREMOTE 12V DC ONOFF

CHANNEL 1

INPUT

SPEAKER

+ –

CHANNEL 2

INPUT

SPEAKER

+ –

CHANNEL 3

INPUT

SPEAKER

+ –

CHANNEL 4

INPUT

SPEAKER

+ –

CHANNEL 5

INPUT

SPEAKER

+ –

]A ]B ]C ]E]D

§2 Connecting 19/2/01, 11:30 am3

>ConnectingtheA30.3Amplifier

POWER CONNECTION

Warning: Before connecting power check that the required supply voltage,

indicated on the back panel, corresponds to your local AC supply. If a

different voltage is stated on the type plate do not connect the amplifier to the

mains power, and seek advice from your dealer.

Connect the mains power using the enclosed mains cable.

Note: Always disconnect the amplifier from the mains power before

connecting or disconnecting any of the cables.

Switching on

The mains switch is on the base plate at the front, to the left under the front

plate. After the switch is activated, the indicator on the front panel lights up

green.

OUTPUTS

Loudspeaker outputs

Connect the loudspeakers for each channel to the corresponding terminals.

The terminals can accept speaker cables terminated with 4mm banana plugs,

spade terminals, or bare wires. To connect bare wires unscrew the terminal,

pass the bare wire through the hole in the terminal bolt, and clamp the wire in

place by screwing the terminal back down.

INPUTS

Connect the A30.5 to each channel of the preamplifier or processor using the

corresponding phono inputs, using high quality phono leads.

REMOTE LINK

To power the A30.5 on and off remotely from a Primare P30 Processor

connect the REMOTE output from the P30 Processor to one of the REMOTE

LINK sockets on the A30.5, using a twin core cable terminated in 3.5mm jack

plugs. The second REMOTE LINK socket can be used to daisy-chain the

remote output to further A30 series amplifiers.

Note: Ensure that the P30 is switched off before connecting it to the A30.5

with a remote link cable.

To use the remote link, switch the REMOTE SW switch to the ON position.

§2 Connecting 19/2/01, 11:30 am4

Index

back panel connections ............................ 3

connections ............................................. 3

inputs...................................................... 4

outputs.................................................... 4

loudspeakers ...................................... 4

P30 Processor, use with ............................ 4

phono inputs ........................................... 4

remote link .............................................. 4

REMOTE switch ....................................... 4

switching on ............................................ 4

technical specification .............................. 2

§3 Index 19/2/01, 11:30 am5

>Index

§3 Index 19/2/01, 11:30 am6

Tabla de contenidos

Otros manuales de Amplificador de Primare

Primare

Primare PRE35 Manual de usuario

Primare

Primare SPA23 Manual de usuario

Primare

Primare A20 Manual de usuario

Primare

Primare SPA22 Manual de usuario

Primare

Primare SPA20 Manual de usuario

Primare

Primare I21 Manual de usuario

Primare

Primare A30.7 Manual de usuario

Primare

Primare A30.2 Manual de usuario

Primare

Primare 122 Manual de usuario

Primare

Primare PRE35 Manual de usuario

Primare

Primare Prisma i35 Manual de usuario

Primare

Primare Prisma i35 Manual de usuario

Primare

Primare A30.1 MK2 Manual de usuario

Primare

Primare SP32 Manual de usuario

Primare

Primare SPA20 Manual de usuario

Primare

Primare SPA22 Manual de usuario

Primare

Primare A32 Manual de usuario

Primare

Primare PRE30 Manual de usuario

Primare

Primare I21 Manual de usuario

Primare

Primare SP33 Manual de usuario

Primare

Primare A33.2 Manual de usuario

Primare

Primare R15 Manual de usuario

Primare

Primare A30.2 Manual de usuario

Primare

Primare A34.2 Manual de usuario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario