Install SESTO SENSO 2 in EAGLE or Windows 7/8/10/11 computer
SESTO SENSO 2 can be installed in the EAGLE or an external computer running Windows 7, 8, 10 or 11 operating
system. In the SESTO SENSO 2 package you can find a 12V power cable with cigarette plug and a PC connection
cable for USB port.
Connect SESTO SENSO 2 power cable to a power sour-
ce (SESTO SENSO 2 power port is Ø5.5 ø2.5mm with
center positive) and then connect the USB-C cable to the
USB port of your EAGLE or standard computer. You will
see the PWR LED on (this means SESTO SENSO 2 is
powered) and, after a few seconds the Wi-Fi LED will also
be become lit - This means that the SESTO SENSO 2 is
online and the WiFi connection is ready to be used.
Once connected the SESTO SENSO 2 should be auto-
matically detected and Windows should automatically
install the new driver. To verify this this, please go to Con-
trol Panel and then choose Device Manager. You should
see the SESTO SENSO 2 listed under “Ports (COM &
LPT)” and described as “Silicon Labs CP210x” (in order to
check, you can disconnect and then reconnect the SE-
STO SENSO 2 USB cable and see how Windows lists it).
If you can’t find it, Windows is not able to automatically
install the SESTO SENSO 2 driver. In order to do this,
please follow this procedure:
1) go to "Device Manager”
2) locate "CP2102N USB to UART Bridge Controller" un-
der "Other devices"
!
PLEASE NOTE
In order to correctly work, SESTO SENSO 2 requires an external 12V power supply and by connecting it to the
USB port of a computer is not enough. Always connect an AC power unit or a 12V battery to the SESTO SENSO
2 12V power port before connecting the USB cable to the computer.
