Components Identification 4
First use: how to choose the correct power source 5
First use: switch on and activation of wireless network 6
First use: Setting remote control with iPhone or iPad 10
First use: Setting remote control from a Windows computer 14
First use: Setting remote control from a Mac computer 16
First use: Setting remote control from an Android device 20
First use: backup your SSD drive before installing your software 24
First use: install your software 29
First use: turn off EAGLE 30
First use: installing EAGLE on the telescope 31
First use: powering other instruments connected to the EAGLE 34
First use: remotely control devices with EAGLE Manager 36
- connect or disconnect every power out port of EAGLE 38
- set power out voltage of the 3 power out ports with adjustable voltage 39
- connect or disconnect devices attached to the 4 USB 2.0 ports 40
- check for power in voltage and battery lifetime 40
- set WiFi connectivity 41
-remotely turn on/off the entire telescope 43
- change the password of the WiFi network created by EAGLE 44
- DARK mode 45
Advanced use: EAGLE ASCOM drivers 46
Advanced use: program connection and power to devices 47
Advanced use: remotely turn on EAGLE with wired connection 48
Advanced use: configure EAGLE to automatically start when power is restored 52
Controlling the telescope remotely with Cartes du Ciel 54
Autoguiding with PHD2 Guiding 61
Drift Alignment using PHD Guiding 66
