Powerware 9170+ Manual de usuario

Powerware®9170

User’s Guide

3kVA–18kVA,50and60Hz

www.powerware.com

02/20/2001

Requesting a Declaration of Conformity

Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:

Harmonized Standards: EN 50091-1-1 and EN 50091-2

EU Directives: 73/23/EEC, Council Directive on equipment designed for use within certain voltage limits

93/68/EEC, Amending Directive 73/23/EEC

89/336/EEC, Council Directive relating to electromagnetic compatibility

92/31/EEC, Amending Directive 89/336/EEC relating to EMC

The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC

Declaration of Conformity, contact:

Director of Engineering

Invensys Secure Power

P.O. Box 280

Necedah, WI 54646

USA

Phone: (608) 565-7200

Fax: (608) 565-5416 Class A EMC Statements

FCC Part 15

NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

ICES-003

This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing Equipment

Regulations ICES-003.

Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.

EN 50091-2

Some configurations are classified under EN 50091-2 as “Class-A UPS for Unrestricted Sales Distribution.” For these

configurations, the following applies:

WARNING This is a Class A-UPS Product. In a domestic environment, this product may cause radio interference, in

which case, the user may be required to take additional measures.

VCCI Notice for Class A Equipment

Powerware is a registered trademark of Powerware Corporation.

CheckUPS II is a registered trademark and BestLink and BestDock are trademarks of Best Power.

Windows is a registered trademark of Microsoft Corporation.

in any way without the express written approval of Powerware.

Powerware®9170 User’s Guide

www.powerware.com

TABLE OF CONTENTS

1 Introduction 1....................................................

SafetyWarnings 2.............................................................

PhysicalFeatures 3............................................................

2 Installation Setup 7...............................................

Equipment Clearances 7.........................................................

Location Requirements 8........................................................

UPS Unpacking and Setup 8......................................................

Three- and Six-Slot Cabinets 8..................................................

Nine- and Twelve-Slot Cabinets 9................................................

Caster Cart Installation 10........................................................

Stabilizer Bracket Installation 11....................................................

Rack-Mount Installation 12........................................................

Floor Anchor Kit Installation 14.....................................................

Moving the Cabinets 15..........................................................

3 Battery Cabinet Installation 17.......................................

4 Electrical Installation 23............................................

Input Current Ratings 26..........................................................

BypassSwitches 27.............................................................

UPS Installation with an ExternalBypassSwitch 30....................................

Wiring Diagrams 35.............................................................

UPS Input Wiring Connections 35...................................................

UPS Output Wiring Connections(Non-Isolated Installations) 36..............................

System Wiring Diagrams 38.......................................................

5 Isolated Output Wiring Diagrams 43...................................

Neutral-to-Ground Bonding for Isolated Output 44.......................................

System Wiring Diagrams 46.......................................................

6 UPS Startup 49....................................................

Power and BatteryModule Installation 50.............................................

Startup for Plug-Receptacle Units 51.................................................

Startup for Hardwired Units 53.....................................................

Table of Contents

ii Powerware®9170 User’s Guide

www.powerware.com

InitialStartup Parameters 56......................................................

Balancing Receptacle Loads 58.....................................................

7 Operation 59.....................................................

Removing Input Power 61.........................................................

Turning the UPS On 61...........................................................

Front PanelDisplay 62...........................................................

Using the Front Panel Display 63....................................................

Parameters 64.................................................................

Changing Parameter Settings 65....................................................

Reading the Powerware 9170 SystemLogs 65..........................................

Inverter Log 65..............................................................

AlarmLog 66...............................................................

Menu Map 67.................................................................

8 Communication 69.................................................

CheckUPSIISoftware 69.........................................................

RS-232 Communication 69........................................................

Optional Interface Kits 70.........................................................

Relay Card 70.................................................................

BestLinkTelecom Modem Controller 70...............................................

OptionalInternalBestLinkSNMP/WEBAdapter 70.......................................

BestDockCommunication Slots 70..................................................

Dedicated Input Signals 71........................................................

DB-9 PortPin Functions 71........................................................

9 Maintenance 73...................................................

Routine Maintenance 73.........................................................

Storage Temperature 74.........................................................

ExternalBypass Switch (Make-Before-BreakOnly) Operation 74.............................

BatteryReplacement 74..........................................................

Power Module Replacement 75....................................................

10 Specifications 77..................................................

11 Troubleshooting 81................................................

Alarms 83....................................................................

Alarm Reason Codes 86..........................................................

Service and Support 87..........................................................

Powerware®9170 User’s Guide

www.powerware.com

CHAPTER 1

INTRODUCTION

The Powerware 9170 uninterruptible power system (UPS) is a modular

UPS that contains battery modules and power control modules (referred

to as power modules). These modules plug into a rack cabinet structure

containing additional control, communication, and display functions

that enable integrated control of all power modules. The UPS is housed

in a single cabinet, with extra battery capacity housed in auxiliary

battery cabinets.

The pluggable power modules canbe removed and replaced

(hot-swapped) without powering the UPS down if the UPS has sufficient

redundant capacity. Battery modules may also be hot-swapped for

maintenance. Power control circuitry inthe cabinet senses problems in

power modules, and automatically transfers control and load to the

remaining power modules.

All power modules share the load requirements equally.For example,

three power modules are capable of supplying a total of 9 kVA. If a load

requires only 4.5 kVA, each power module supplies 1.5 kVA to the

output. If one power module is removedor for some reason fails, eachof

the two remaining power modules would supply half of the load, or

2.25 kVA. In other words, redundancy exists when the load can be

supplied by less than all of the installed power modules.

The UPS can be configured with up to seven power modules; its output

is limited such that an excess number of power modules allow the

failure of one or more modules without causing the UPS to lose any

functionality.

To permit UPS removal from the power path, while maintaining power

to the loads, an external bypass switch is required. This switch is

optional but recommended for system serviceability.

Introduction

2Powerware®9170 User’s Guide

www.powerware.com

Safety Warnings

Read the following precautions before you install the UPS.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS. Thismanual containsimportant instructionsthat you

should follow during installation and maintenance of the UPS and batteries.Please

read allinstructionsbefore operating the equipment and save this manualfor future

reference.

CAUTION

Universal power modules(modelASY-0528) have white labelson the front and

produce a single output voltage: 208, 220,230, or 240 Vac. Split-phase power

modules(model ASY-0567)have blue labelson the front and produce two output

voltages: 100/100 for 200,110/110 for 220, 120/120 for 240, 120/120 for 208,or

127/127 for 220 Vac. DO NOT mix the two types of power modulesin the same

Powerware 9170 cabinet.

Battery modulesto be used in the Powerware 9170 system are modelASY-0529.

Each batterymodule weighs 30 lb (14 kg).Use care in lifting and moving battery

modules.

All input and output wiring must be copper and adequate to carrying currentsas

listed in Table 13 on page 78.

Torque allbolts holding input and output power conductorsto values specified in

Table 2 on page 27.

The user is required to provide power input and output disconnect devices for the

UPS. These must be within sight of the UPS and easily accessible.For a

plug-receptacle unit,the plug serves asthe power input disconnect device,which

mustalso be readilyaccessible.

Introduction

Powerware®9170 User’s Guide

www.powerware.com

Physical Features

The Powerware 9170 UPS is available in four cabinet sizes. Figure 1

through Figure 6 show the 3-slot and 9-slot configurations and identify

basic Powerware 9170 system features. Six-slot and 12-slot cabinets are

also available; external battery cabinets are available in 6-, 9-, and

12-slot sizes.

Front Panel

Display

Front Cover

Bezel

Figure 1. Three-Slot Cabinet (Front View)

BestDock

Ports

Power Outlets

(optional)

Input Power

Cable (optional)

Figure 2. Three-Slot Cabinet (Rear View)

Introduction

4Powerware®9170 User’s Guide

www.powerware.com

Front Panel

Display

Front Cover

Bezels

Cabinet Base

Figure 3. Nine-Slot Cabinet (Front View)

Introduction

Powerware®9170 User’s Guide

www.powerware.com

BestDock Ports

Power Outlets

(optional)

Input Power

Cable (optional)

Figure 4. Nine-Slot Cabinet (Rear View)

Handle/Latch

Release

Insertion/Extraction

Cams

Handle

Thumbscrew

Figure 5. Power Module (ASY-0528 and ASY-0567)

Secondary Stop

Release

Latch Release

Figure 6. Battery Module (ASY-0529)

Introduction

6Powerware®9170 User’s Guide

www.powerware.com

Otros manuales para 9170+

Tabla de contenidos

Otros manuales de Unión Postal Universal de Powerware

Powerware

Powerware PW5110 Manual de usuario

Powerware

Powerware 9330 Manual de usuario

Powerware

Powerware 9155 Manual de usuario

Powerware

Powerware 9120 Manual de usuario

Powerware

Powerware Prestige 6000 Guía de configuración

Powerware

Powerware 5125 Tower Manual de usuario

Powerware

Powerware 5119 Manual de usuario

Powerware

Powerware 5125 P33 Manual de usuario

Powerware

Powerware 5125 9910 P18 Manual de usuario

Powerware

Powerware 9330 Manual de usuario

Powerware

Powerware Prestige series 9 Manual de usuario

Powerware

Powerware 5119 RM Manual de usuario

Powerware

Powerware 9390 Manual de usuario

Powerware

Powerware 9315 Manual de usuario

Powerware

Powerware 9395 Manual de usuario

Powerware

Powerware 9170+ Manual de usuario

Powerware

Powerware 9305 Manual de funcionamiento

Powerware

Powerware Ferrups FE/QFE 500VA Manual de usuario

Powerware

Powerware BPIV 30 kVA Manual de usuario

Powerware

Powerware 300 VA Manual de usuario

Powerware

Powerware 9315 Manual de usuario

Powerware

Powerware 5125 Manual de usuario

Powerware

Powerware 9355 Manual de usuario

Powerware

Powerware 3105 Manual de usuario

Manuales populares de Unión Postal Universal de otras marcas

Pylontech

Pylontech Victron & Pylontech US5000 Manual de usuario

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manual de usuario

Mecer

Mecer ME-1000-WTU Manual de usuario

Mustek

Mustek PowerMust 530(B) Plus Manual de instalación y operación

Emerson

Emerson Liebert NXL series Manual de usuario

MAKELSAN

MAKELSAN BOXER SERIES Manual de usuario

Block

Block PC-0524-400-0 Manual de usuario

CyberPower

CyberPower CP585LCD Manual de usuario

Eaton

Eaton 3S Instrucciones de montaje

CyberPower

CyberPower Office Tower Series UPS 1000 Manual de usuario

CyberPower

CyberPower BM100 Manual de usuario

Best Power

Best Power 610 Manual de usuario

Best Power

Best Power Unity/I UT3K Manual de usuario

Mustek

Mustek PowerMust 400 Offline Manual de usuario

Xantrex

Xantrex Trace 512 UR-UPS Manual de usuario

Forza

Forza SL-1501UL Manual de usuario

LEGRAND

LEGRAND keor 310081 Manual de usuario

ABB

ABB Conceptpower DPA 500 Manual de usuario