POWERCOLOR A300M-E1394 Manual de usuario

A300M-E1394
MAINBOARD
MANUAL
DOC No. : M03704
Rev. : A0
Date : 9, 2003
Part No. : 25-11720-00

Handling Precautions
Warning:
1. Static electricity may cause damage to the integrated circuits on
the motherboard. Before handling any motherboard outside of
its protective packaging, ensure that there is no static electric
||||||charge in your body.
2. There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or an equivalent type
||||||recommended by the manufacturer.
3. Discard used batteries according to the manufacturer’s
instructions.
4. Never run the processor without the heatsink properly and rmly
attached. PERMANENT DAMAGE WILL RESULT!
Observe the following basic precautions when handling the
motherboard or other computer components:
nWear a static wrist strap, which is connected to a
natural earth ground.
nTouch a grounded or anti-static surface or a metal
xture such as a water pipe.
nAvoid contact of the components on add-on cards,
motherboards, and modules with the
golden ngers connectors plugged into the
expansion slot. It is best to handle system components
by their mounting brackets.
The above methods prevent static build-up and cause it to
Trademark
All trademarks mentioned in this manual are registered
properly of the respective owners.
Handling Precautions
This manual may not, in whole or in part, be photocopied,
reproduced, transcribed, translated, or transmitted in
whatever form without the written consent of the manufac-
turer, except for copies retained by the purchaser for
Notice

Table of Contents
Chapter 1 Overview
Package Checklist .................................. 1-2
The A300M-E1394 Mainboard........................ 1-3
Main Features ...................................... 1-4
Chapter 2 Installation Procedures
1). Set System Jumpers ............................. 2-2
Clear CMOS................................... 2-2
2). Install Memory Modules ......................... 2-3
3). Install the CPU ................................ 2-4
Connect ATX Power............................ 2-5
4). Install Expansion Cards ........................ 2-6
5). Connect Devices ................................ 2-7
Floppy Diskette Drive Connector.............. 2-7
IDE Device Connectors........................ 2-8
Fan Connectors............................... 2-8
Power Connectors............................. 2-9
SPDIF Connector.............................. 2-9
Front Panel Block Connector..................
2-10
Serial IRQ Connector.........................
2-11
CD Audio-In Connectors.......................
2-11
1394 Connectors..............................
2-12
PS/2 Keyboard and Mouse Connector............
2-13
RJ45 LAN Connector...........................
2-13
Serial Port Connectors.......................
2-14
CRT Connector................................

ii
A300M-E1394 Mainboard Manual
Chapter 3 BIOS Setup
CMOS Setup Utility ................................. 3-1
Standard CMOS Setup ................................ 3-2
Advanced BIOS Features ............................. 3-4
Advanced Chipset Features .......................... 3-7
Integrated Peripherals ............................. 3-7
Power Management Setup .............................
3-12
PnP/PCI Congurations ..............................
3-14
PC Health Status ...................................
3-15
Load Optimized Defaults ............................
3-16
Supervisor/User Password ...........................
........................................
|||||||||||||

1 - 1
Overview
Overview
Chapter 1
This microATX-sized mainboard is based on the ATI® RADEON
9100 IGP chipset (9100 IGP + IXP 150), which support the high
performance of Intel® CPUs. Its superb graphics come from
the integration of a DX8.1-level Radeon 9100 GPU core in the
North bridge and is designed for the latest 478-pin Pentium®
4 processors.
Two onboard DDR memory sockets allow DDR266/333/400 dual channel
SDRAM for up to 2 GB of memory capacity. Support for ATA-100
protocol and its high-speed interface further ensures that
data transfer speeds are improved, especially for the long se-
quential transfers required by audio/visual applications. The
board features onboard SPDIF output and LAN functions. It is
completely software compatible with your operating system. For
more details, please read the help le in the included CD.
The board comes with an extensive range of I/O features such
as 2 serial ports, 1 CRT port, 1 parallel port, 1 LAN, 1 PS/2
mouse and 1 PS/2 keyboard connector, 6 USB 2.0 ports, 2 optional
1394 ports, 1 media connector (front audio, Line-in, Line-out
and Mic-in). In addition, the board is equipped with 2 IDE
connectors. Ample expansion is available through 3 PCI and 1AGP
8X slots, allowing for enjoyment of the P4 CPU’s benets in
internet applicatons and video/3D graphics performance.

1 - 2
A300M-E1394 Mainboard Manual
1 - 3
Overview
Package Checklist
If you discover any item below was damaged or lost, please
contact your vendor.
NOTE: The driver CD, which contains patch les, onboard video/audio
chip drivers, related online help and other useful information, can be
found in your mainboard package.
Please install it immediately after your Windows operating system
installation is complete. Place driver CD in the drive and an operating
menu will appear on your monitor. Please select Auto Installation.
It will automatically detect which software tools (patch les, drivers)
the mainboard needs. Press OK to go through the whole installation
procedure in a very straight forward and easy way. It will also provide
you with a custom installation feature to select the patch les and
software drivers you want for the onboard chip’s use.

1 - 2
A300M-E1394 Mainboard Manual
1 - 3
Overview
The A300M-E1394 Mainboard

1 - 4
A300M-E1394 Mainboard Manual
1 - 5
Overview
Main Features
n CPU
Intelョ Celeron -
2.0 to 2.8 GHz and up* (FSB 400)
Intelョ Pentium 4 -
1.6 to 2.6 GHz and up* (FSB 400)
2.26 to 3.06GHz and up* (FSB 533)
2.4 to 3.2 GHz and up* (FSB 800)
(* not tested yet)
n Chipset
North Bridge: ATIョ Radeon 9100 IGP
South Bridge: ATIョ IXP 150
n Memory
2 memory sockets:
Support dual channel DDR266/333/400
SDRAM memory size totally up to 2 GBs
n Expansion Slots
1 AGP Slot: support 4X/8X (1.5V)
3 PCI Slots: 2.2 32-bit (3.3V/5V PCI bus interface)
slots
n LAN
RTL8100C 10/100 Fast Ethernet/
8110S Gigabit Ethernet (dual layout)
n Audio Features
Realtek ALC655/658 (dual layout) controller; AC97
LINE_IN, LINE_OUT, MICROPHONE_IN Jack
Front audio pinheaders

1 - 4
A300M-E1394 Mainboard Manual
1 - 5
Overview
n I/O Ports
2 IDE connectors -
Ultra DMA 66/100 up to 4 devices
COM1 and COM2 (pinheader)
1 CRT port
1 Parallel port
1 PS/2 mouse and PS/2 keyboard
6 USB ports
n Mounting Holes
9 Holes
n Mainboard Size
9.2 x 9.6 (unit: inch)
n IEEE 1394 Ports (optional)
VT6307L
2 Ports
1 Bracket with cable

1 - 6
A300M-E1394 Mainboard Manual
This Page Left Blank for Notes
Tabla de contenidos
Otros manuales de Placa madre de POWERCOLOR
Manuales populares de Placa madre de otras marcas

Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte
Gigabyte GA-9IVDT Manual de usuario

Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario

Commell
Commell MS-C73 Manual de usuario

IBT Technologies
IBT Technologies MB860 Manual de usuario

Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario















