Porsche A2DIY-CR12 Manual de usuario

Courtesy of: DiscountCarStereo.com

Serving the internet community since 1995

Created January 16, 2016

Revised April 3, 2023

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

•This installation guide is provided as a GENERAL installation guide, some vehicles vary and may

require additional steps. We do not accept responsibility for third party labor charges or

modifications. Exercise due-diligence when installing this product.

•We do not accept any responsibility for vehicle damage or personal injury resulting from the

installation of this product.

•Careless installation and operation can result in equipment damage

Requirement:

Porsche CR-1 and CR-2 radios

Introduction:

If looking to add Bluetooth® features to Porsche CR-1 or CR-2 radios you should

consider the A2DIY-CR12 kit. This revised easy to install kit is essential to adding

Bluetooth® features to older Porsche vehicles while keeping everything stock. This

“triple play” module supports aptX "CD-like’ high quality audio for streaming music

and sounds great for (1) mobile conversations, (2) streaming Pandora, Sirius radio,

Apple music, audiobook, podcast and (3) AUX input. Use included media remote

control to adjust Smartphone: volume, track up/down/pause and more and can be

mounted to steering wheel or dashboard. In addition, an optional “Smart charger’

kit is available to keep devices charged while on the road. Thanks to the A2DIY-CR12

kit, Porsche owners can update to Bluetooth® without changing original radio.

Warning: Porsche CR-1 and CR-2 radios are coded and will not operate without

the code. Do not proceed with step 7 if radio code is unavailable otherwise radio

will not operate upon reconnection.

See frequently asked question at the end of this guide for more details.

Installation:

The radio must be removed to gain access to wiring.

CR-1 and CR-2 radios do not require special removal tools, to remove:

1. Pry off plastic trim ring around the radio. (This exposes mounting points)

2. Locate flat plate with latch on either side of radio. These plates drop

down and lock the radio into frame. (See Fig. 1)

Fig. 1

3. Use small flat head screwdriver or similar to raise plate (both sides) and

simultaneously pull radio out from the dash. Grasping cassette opening

provides some leverage or remove glovebox to push radio from rear.

4. If present, disconnect CD changer 13-pin plug from radio otherwise;

5. Connect 13-pin plug from module (See Fig. 2)to radio 13-pin socket (See

Fig. 3/4)

Fig. 2

Fig. 3

13-pin socket

Fig. 4

6. Connect supplied 3.5mm audio cable (See Fig. 5) to module “AUX” jack

(See Fig. 6). Route audio cable other end to dash area or wherever Aux

device will reside (within 3 ft.)

Fig. 5

Audio cable

Fig. 6

Module

7. Secure visor microphone (See Fig. 7) to visor or headliner using included

visor clip (See Fig. 8)

Fig. 7

Microphone

Fig. 8

Visor clip

8. Route microphone cable down pillar, under steering column and into

radio cavity.

9. Connect microphone plug to “MIC” input jack (See Fig. 4)

Be cautious not to damage or cut microphone cable.

Proceed to “Pairing” section on page 5

Optional charging kit:

This fast charge USB type-C kit can be added to any vehicle. It supports BC1.2, QC2.0,

QC3.0, PE1.1, PE2.0, FCP, SFCP fast charge protocols (Apple, Samsung, Huawei etc.)

Note: iPhone "Fast charge" kicks in when battery capacity is between 0-79%, and

return to regular charge mode when it reaches 80%.

Should you decide to add to car, we suggest one of 3 connecting options:

A. Flush to dash/panel requires drilling a ¾” hole

B. Flush with Support bracket (Mount USB terminal wherever your installation

demands without drilling)

A. Flush to Dash or Panel (drilling required)

1. Drill a ¾” hole in the dash or panel using a step drill bit or equivalent

(See Fig. 11)

Fig. 11

Step drill bit

2. Insert supplied 3ft. USB male terminal (See Fig. 12) through hole created

in step 1 and connect to install harness USB port (See Fig. 13)

Fig. 12

Flush mount head

Fig. 13

3. Snap USB head (See Fig. 14) in place and flush with mounting surface

(See Fig. 15)

Fig. 14

USB head

Fig. 15

Flush mounted

4. Tuck and secure any extra wire from moving parts and test operation

B. Bracket Mount (No drilling)

1. Locate a flat surface at location of choice within 3.2 ft. of module and

mount USB support bracket (See Fig. 16) to surface using adhesive/tape

or screws (included).

Fig. 16

USB mounting bracket

2. Insert male terminal through hole in bracket (See Fig. 17) and connect to

module USB port (See Fig. 13)

Fig. 17

3. Snap USB head (See Fig. 17) to bracket until flush (See Fig. 18)

Fig. 18

4. Connect BLACK wire to ground (radio chassis, radio ground wire etc.),

and RED or YELLOW to accessory or battery supply. Your choice!

Accessory connection: charging is possible with ignition/engine “ON”.

Battery connection: charging is possible at all times.

Tuck away any extra wires and verify BLUE LED is lit.

Bluetooth media button:

Pairing:

Enable Bluetooth on your device (e.g., Smartphone/Tablet etc.)

Press and hold pause/play until Blue LED flashes

Scan smartphone for available devices and select BT009 from list. (Blue LED turns

off).

Installation:

Attach the button to steering wheel (includes holder) or attach to dashboard using

included double-sided tape –your choice.

Because the media button pairs with your Smart device, it can also be used at

home, in the park or wherever you decide to play your tunes.

Operation:

Once paired with smart device (e.g., Phone, Tablet, etc.), users may perform the

following functions on iOS with Bluetooth 3.0 and later or Android 4.0 or later.

Media button does not operate Porsche radio.

Charging:

Media button built-in rechargeable 200mAH battery may last up to 10 days.

Connect included USB cable to charge charging port at the back.

Red LED indicates charging; A full charge is reached after 2 hours at which time

LED turns off.

Pairing Bluetooth module:

Pairing varies among devices but basic steps are the same. This process is done

upon initial install and will not have to be repeated.

1. Turn ignition and radio “ON”

Blue LED through module peephole will flash (pairing mode)

2. On A2DP device: go to

Bluetooth Settings

, Tap Scan/search

3. Wait for Bluetooth device name (See Fig. 19) to appear and tap it.

Once paired confirmation tone is heard on car speakers

Fig 19

Bluetooth operation:

1. Turn ignition and radio “ON”

2. Press “CD” button on radio

3. Launch smartphone music streaming application

4. Set smartphone media volume to 90% and raise radio volume knob to set

playback level. If distorted, lower audio device volume.

5. Use media remote to change tracks, volume adjustment, pause, play on

smart device (e.g., smartphone) these do not apply to factory radio

6. Place test call

7. Press media button Pause/Play to answer/end call

8. Press media button Pause/Play to switch between AUX and streaming

9. If correct operation is confirmed go ahead and reinstall radio.

Notes:

1. On incoming calls, ring tone plays through car speakers

2. AUX has playback priority.

3. *Media button does not control AUX device nor factory radio functions.

Use AUX device built-in buttons for music selection and controls.

Warning: Playlist, Track selection, display name/number are *NOT*

possible from radio. Use audio device built-in controls or optional

wireless remote to access and control audio files and applications.

Frequent ask questions & troubleshooting:

1. What is the difference between the BLU-CR12 and A2DIY-CR12?

The A2DiY-CR12 supports both music streaming and Hand-free calling. The

BLU-CR12 supports music streaming but does not support hands-free calls.

2. Does the A2DIY-CR12 work on all Porsche radios?

Works on Porsche CR-1 and CR-2 radios only

3. Will radio display call number or song name?

NO. These features are not possible on these radios.

4. Is it possible to control smartphone from radio buttons?

NO; Use smartphone built-in controls, remote control or smartphone

voice commands. Use radio volume button to set playback level.

5. My vehicle has a CD changer. Do I need to disconnect it?

YES; this module takes the place of the CD changer.

6. How do I listen to AUX device?

Press CD button on radio, connect aux device to 3.5mm plug, press

Play/pause on remote control. To return to streaming; press

Play/Pause again.

7. Will radio mute when call is made and/or received?

YES; but only if radio is in “CD/Bluetooth mode. If in AM/FM mode; radio will

not mute. To hear caller on car speaker; radio must be in “CD/Bluetooth”

mode.

8. My second phone does not pair or find Bluetooth module. What gives?

Ensure no other phone is paired. Allow module to enter “discovery” mode at

which point it will be ready for pairing.

Disclaimer

• This product has no affiliation with Porsche or Apple

• When possible, professional installation is recommended

Email support@discountcarstereo.com

subject to change without notice. Other products and companies referred to herein are trademarks

or registered trademarks of their respective companies or mark holders.

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Porsche

Porsche

Porsche Mobile Charger Manual de usuario

Porsche

Porsche WAP0800010LWCP Instrucciones de instalación

Porsche

Porsche Mobile Charger Connect Manual de usuario

Porsche

Porsche 9Y0.915.686.A Manual de usuario

Porsche

Porsche Mobile Charger Connect Manual de usuario

Porsche

Porsche Mobile Charger Connect Manual de usuario

Porsche

Porsche Mobile Charger Manual de usuario

Porsche

Porsche 997.044.901.77 Manual de usuario

Porsche

Porsche Cooler Bag Manual de usuario

Porsche

Porsche Mobile Charger Nota de publicación

Porsche

Porsche Home Energy Manager Manual de usuario

Porsche

Porsche USB-CDR30 Manual de usuario

Porsche

Porsche Mobile Charger Connect Nota de publicación

Porsche

Porsche Mobile Charger Connect Nota de publicación

Porsche

Porsche CDR 210 Manual de usuario

Porsche

Porsche Home Energy Manager Manual de usuario

Porsche

Porsche Connect Manual de usuario

Porsche

Porsche 01-B Guía del usuario

Porsche

Porsche Porsche Junior Seat i-Size Guía del usuario

Porsche

Porsche Mobile Charger Plus Manual de usuario

Porsche

Porsche 1D6 Manual

Porsche

Porsche Wall Charger Connect Hoja de especificaciones

Porsche

Porsche 7PP.971.675.AA Manual de usuario

Porsche

Porsche 992.044.885 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario