Pioneer SPH-10BT Manual de uso y cuidado

System Firmware Update Instructions for Pioneer Smartphone Receiver

(SPH-10BT)

This firmware update (version 08.27) applies only to Pioneer SPH-10BT Smartphone Receivers sold in

the United States and Canada.Installation on any other product could cause irreversible damage.

IMPORTANT

Please download and print these firmware update instructions before downloading and installing the

firmware update. It is important that you complete all steps correctly and in the order described below.

Note: If you have any questions, please contact Pioneer Customer Service toll free at 1-800-421-1404,

Monday through Friday, 7:30 AM - 11:30 AM and 12:30 PM - 4:00 PM (Pacific Time), excluding holidays, or

by email through parts.pioneerelectronics.com/contactus.

In order to perform this update, the following items are needed:

• Pioneer SPH-10BT Smartphone receiver.

• A USB storage device meeting the following requirements.

-2 GB or larger in capacity, formatted to FAT32

-Blank (should not contain any files)

CAUTION: DO NOT turn your unit off or eject the USB storage device while the firmware is being

updated. Any interruption to the firmware update process could cause irreversible damage to the

unit.

WARNING:Install this update only when the vehicle is safely parked in an open, well-ventilated area,

such as an outdoor parking lot, where you can safely keep the engine running to maintain power to the

battery. NEVER RUN YOUR VEHICLE’S ENGINE IN AN ENCLOSED SPACE, WHICH CAN QUICKLY

FILL UP WITH TOXIC CARBON MONOXIDE GAS, LEADING TO SERIOUS INJURY OR DEATH.

Checking the firmware version

Check whether the firmware of your unit needs to be updated by checking the version number of the

firmware.

The update version to download and install will depend on the existing firmware version on your

unit.

Your unit's current firmware version Update version

08.XX 08.27

Procedure:

1. Start the vehicle engine (in an open, well-ventilated area).

2. If AV Source is On, Press and hold SOURCE(MUSIC)/OFF to set the unit Source OFF.

And If Pioneer Smart Sync is connected, disconnect.

3. Press and hold Application launch to display the “Initial ”menu. then press to confirm.

4. Press > repeatedly to select “UPDATE”, then press Application launch to confirm.

5. Select the “S/W VER” to confirm the system info.

6. After the “S/W VER” screen appears, check the firmware version.

7. Verify that the firmware on your unit is not already firmware version 08.27.

Downloading the firmware update files from Pioneer's website

1. Download the firmware update files by clicking on the following link and finding your product:

pioneerelectronics.com/firmware

2. Locate the downloaded .zip file, extract the downloadable file and copy it onto the USB device.

The Downloaded ZIP file will produce the following file when decompressed: (See the table below)

Model Name Update necessary if: File name Update Version

SPH-10BT Current version is 08.26 or lower 19DEH_A0827.scd 08.27

Updating the firmware on your Unit

IMPORTANT

• DO NOT perform this firmware update if the model number of your Pioneer product is anything other

than one of the above models.

• Ensure that the update file is located within the root (top) folder of your USB storage device. There

should be no other files within the USB storage device.

• While your unit is being updated, DO NOT turn off the system’s power and DO NOT touch the unit’s

touchscreen as this may result in severe damage to your unit.

• DO NOT remove the USB storage device during the firmware update process.

• Performing the firmware update will restore all settings to their default values.

• Disconnect any external mobile devices connected to your unit before starting the update process.

Procedure:

1. Connect a blank (formatted) USB storage device to your computer, and then locate and copy the

“.scd” file onto the USB storage device.

2. Start the vehicle engine.

3. Connect the USB storage device to the USB input on your unit.

4. If AV Source is On, Press and hold SOURCE(MUSIC)/OFF to set the unit Source OFF.

And If Pioneer Smart Sync is connected, disconnect.

5. Press and hold Application launch to display the Initial menu.

6. Press > repeatedly to select “UPDATE“, then press Application launch to confirm.

7. Select the “START” item for updating the unit to the latest software.

8. The “CHK FILE” screen appears.

-> If it shows “ERROR” on the display, Try the following

“FILE ERR->CHK USB” Confirm the software is correct, then restart Version up or change a new USB

memory.

9. After starting, there will be a progress status while updating.

-> If it shows “ERROR” on the display, Try the following

“ERROR->RETRY” Disconnect / connect the USB storage device. And press Application launch to

retry Version up.

10. Wait for until the Version Up complete. (For about 5 minutes)

-> The following screen will show if the Version Up ends successfully.

11. The product will reboot after the update is finished. Do not touch anything even when the screen is

blacked out. After it has finished rebooting, the screen will return to Source OFF .

12. Press and hold SOURCE(MUSIC)/OFF to set the unit Source OFF.

13. Press and hold Application launch to display the Initial menu.

14.Press > repeatedly to select “RESET“, then press Application launch to confirm.

15. Select the “YES” item for system reset.

16. Do not touch anything even when the screen is blacked out. After it has finished rebooting, the screen

will return to Source OFF .

17. The firmware update is now complete. Your Pioneer SMARTPHONE Receiver is now ready for use.

Check if the firmware has been updated

Perform the same procedure for “Displaying the firmware version” to check if the firmware has been

updated.

Procedure:

1. Start the vehicle engine (in an open, well-ventilated area).

2. If AV Source is On, Press and hold SOURCE(MUSIC)/OFF to set the unit Source OFF.

And If Pioneer Smart Sync is connected, disconnect.

3. Press and hold Application launch to display the “Initial” menu. then press to confirm.

4. Press > repeatedly to select “UPDATE”, then press Application launch to confirm.

5. Select the “S/W VER” to confirm the system info.

6. After the “S/W VER ” screen appears, check the firmware version.

7. Verify that the firmware on your unit is 08.27, as applicable.

Contact Information

If you have any questions, please contact Pioneer Customer Service toll free at 1-800-421-1404, Monday

through Friday, 7:30 AM - 11:30 AM and 12:30 PM - 4:00 PM (Pacific Time), excluding holidays,

or online through https//parts.pioneerelectronics.com/contactus.

------------------------------------------------------------

Otros manuales para SPH-10BT

Tabla de contenidos

Otros manuales de Receptor de Pioneer

Pioneer

Pioneer Elite VSX-44 Manual de usuario

Pioneer

Pioneer VSX-917V Manual de usuario

Pioneer

Pioneer VSX-521-K Manual de usuario

Pioneer

Pioneer VSX-516 Manual de usuario

Pioneer

Pioneer SPH-T20BT Manual de usuario

Pioneer

Pioneer MVH-S420DAB Manual de usuario

Pioneer

Pioneer qx-8000 Manual de usuario

Pioneer

Pioneer VSX-9130TXH-K - 140 Watts A/V Receiver Manual de usuario

Pioneer

Pioneer SC-1523-K Manual de usuario

Pioneer

Pioneer XV-S100DV Manual de usuario

Pioneer

Pioneer SPH-EVO93DAB Manual de usuario

Pioneer

Pioneer VSX-74TXVi Manual de usuario

Pioneer

Pioneer VSX-D638-G Manual de usuario

Pioneer

Pioneer SD-532HD5 Manual de usuario

Pioneer

Pioneer AVH-X8700BT Manual de usuario

Pioneer

Pioneer VSX-1122-K Manual de usuario

Pioneer

Pioneer VSX-530-K Manual de usuario

Pioneer

Pioneer VSX-822-K Manual de usuario

Pioneer

Pioneer VSX-D709S Manual de usuario

Pioneer

Pioneer VSX-D2011-G Manual de usuario

Pioneer

Pioneer SX-S30 Manual de usuario

Pioneer

Pioneer VSX-415-S/-K Manual de usuario

Pioneer

Pioneer Elite SC-25 Manual de usuario

Pioneer

Pioneer XV-DV303 Instrucciones de uso

Manuales populares de Receptor de otras marcas

Garmin

Garmin GA 23 Manual de usuario

Aiphone

Aiphone PS-12F Manual de usuario

IMES

IMES TCS-01CA-PMI Manual de usuario

BWI Eagle

BWI Eagle AIR-EAGLE SR Manual

AMIMON

AMIMON AMN12310 WHDI Manual de usuario

Dual

Dual DMCPA79BT Instrucciones de funcionamiento

Sound Associates

Sound Associates SA652P Manual de usuario

Sherwood

Sherwood NewCastle R-772 Manual de usuario

Audio

Audio A10-RX Series Manual de usuario

AllSee

AllSee PushShare PSRV1.1 Manual de usuario

DEMAG

DEMAG DRC-DR D2 Manual de usuario

Teleco

Teleco TVRCL868A02 Manual de usuario

Bosch

Bosch RF3222E Manual de usuario

Kramer

Kramer 631R Manual de usuario

Xpress

Xpress xmc10 Manual de usuario

JVC

JVC KD-MR1BTS Manual de usuario

Omega Engineering

Omega Engineering UWTC-REC3 Manual de usuario

e-survey

e-survey E300 Pro Manual de usuario