Phonak Campus S Manual de usuario
Campus S
Battery change procedure
1. Turn Campus so that the belt clip is facing you.
Put your fingernail under the slot & lift up the
battery draw. A coin can also be used.
2. Slide Battery compartment away from you.
3. Invert Campus & tap into the palm of your hand,
this should release the battery. If it is stuck
please return to Phonak.
4. Insert the new Green battery. Please take note
of the arrow showing the orientation of
the battery.
01
5. Note location lugs on the battery draw.
6. Note location lugs on the Campus body.
7. Insert the lugs on the draw into the sockets on
the body first & then press down on the draw.
Final Check
On closing of the battery draw, all of the
segments in the display should illuminate.
The display will then shut down. Press the power
button & the Campus should be ready to use. If
you have any problems please contact Phonak.
Campus S
Battery change procedure
02
Otros manuales para Campus S
1
Tabla de contenidos
Otros manuales de Receptor de Phonak
Phonak
Phonak iSense Classic Manual de usuario
Phonak
Phonak Roger NeckLoop 02 Manual de usuario
Phonak
Phonak Roger Mylink Manual de usuario
Phonak
Phonak ActiveVent Guía de instalación
Phonak
Phonak roger guide-u Manual de usuario
Phonak
Phonak WallPilot Manual de usuario
Phonak
Phonak Dynamic SoundField DigiMaster X Manual de usuario
Phonak
Phonak Roger Earpiece C Manual de usuario
Phonak
Phonak MyLink+ Manual de usuario
Phonak
Phonak DigiMaster X Manual de usuario
