Philips HQC483 Manual

Directions for use

ENGLISH 4

POLSKI 15

РУССКИЙ 26

EESTI 38

LATVISKI 48

LIETUVIŠKAI 59

Styling booklet

ENGLISH 69

POLSKI 75

РУССКИЙ 82

EESTI 89

LATVISKI 95

LIETUVIŠKAI 101

HQC483

Introduction

◗Dear customer, you have made the right

choice! Your new Philips hair clipper adapts to

the contours of the head and enables

comfortable use.

◗To enjoy using the hair clipper for a long time,

we advise you to read the following

information.

Important

Read these instructions for use carefully before

using the appliance and save them for future

reference.

◗Check if the voltage indicated on the adapter

corresponds to the mains voltage in your

home before you connect the appliance.

◗This appliance is suitable for mains voltages

from 220 to 240 volts.

◗Only use the adapter supplied.

◗The adapter contains a transformer. Do not

cut off the adapter to replace it with another

plug, as this will cause a hazardous situation.

◗Do not use a damaged adapter.

◗If the adapter is damaged, always have it

replaced by one of the original type in order

to avoid a hazard.

C◗Keep the appliance and the adapter dry.

◗Keep the appliance out of the reach of

children.

ENGLISH4

C◗Use, charge and store the appliance at a

temperature between 15cand 35c.

◗This appliance is only intended for clipping

human hair. Do not use it for any other

purpose.

Charging

Charge the appliance for at least 12 hours before

you start using it for the first time.

A fully charged appliance has a cordless operating

time of up to 35 minutes.

Do not charge the appliance for more than 24

hours.

1Make sure the appliance is switched off

while charging.

C2Insert the appliance plug into the

appliance.

3Insert the adapter plug into the wall

socket.

C◗The pilot light will go on to indicate that the

appliance is charging.

Optimising the lifetime of the battery

- Discharge the battery completely twice a year

by letting the motor run until it stops.

ENGLISH 5

- Remove the adapter plug from the wall socket

when the battery is fully charged.

- If the appliance has not been used for a long

time, it must be recharged for at least 12 hours.

Corded clipping

Do not run the appliance from the mains when

the battery is fully charged.

◗To use the hair clipper connected to the

mains:

Switch the hair clipper off, connect it to the mains

and wait a few seconds before switching it on.

If the battery is completely empty, wait a few

minutes before switching the appliance on.

Preparing for use

Clipping with comb attachment

C1Before you start clipping, make sure the

head of the person whose hair you are

cutting is at the same level as your chest.

2To get the best results, use the hair clipper

only on dry hair. Do not use it on freshly

washed hair.

3First comb the hair into the direction of

hair growth.

ENGLISH6

C4Always move the clipper against the

direction of hair growth, otherwise it will

not cut the hair properly.

5Move the clipper through the hair slowly.

Using the appliance

Clipping with comb attachment

C1Slide the comb attachment onto the rails

on the appliance until you hear a click.

2Make sure that the arms of the comb

attachment have been properly slid onto

the rails on both sides.

C3Choose the appropriate hair length

setting.

Press the adjustment button on the back of the

appliance and slide the comb attachment to the

desired position.

The clipper has 7 different hair length settings:

-3mm

-6mm

-9mm

- 12 mm

- 15 mm

- 18 mm

- 21 mm

Start at the setting for maximum hair length (21

mm) to familiarise yourself with the clipper.

ENGLISH 7

4Make sure that the flat part of the comb

attachment is always fully in contact with

the scalp to obtain an even cutting result.

5Pass the clipper slowly over the crown

from different directions to achieve an

even cutting result.

6Make overlapping passes over the head to

ensure that the clipper catches all the hairs

that need to be cut.

7Comb the hair in the direction of hair

growth from time to time so that the

clipper can catch the hair more easily.

8To achieve a good result with curly, sparse

or long hair, you can use a comb to guide

the hair towards the clipper.

9We advise you to regularly remove clipped

hair from the comb while clipping.

Graduation

The Philishave hair clipper not only allows you to

cut the hair evenly at the same length all over the

head, it also enables you to achieve a smooth

transition from longer hair on top of the head to

shorter hair on the back and sides of the head.

1Start clipping at the setting for maximum

hair length (i.e. position 21 mm).

ENGLISH8

2Then choose a shorter setting and cut the

hair on all parts of the head except the

top, where you want the hair to be longer.

3You can repeat this procedure until the

hair on every part of the head has the

desired length.

Precise contouring without comb

attachment

You can use the clipper without comb attachment

to contour the neckline and the area around the

ears.

Be careful when you are clipping without comb

attachment, for the clipper will remove every hair

it touches.

1Remove the comb attachment by pulling it

off the clipper.

2Before contouring the hairline round the

ears, comb the hair ends over the ear.

3Bend the person's ear to get it out of the

way.

C4Tilt the clipper in such a way that only one

edge of the cutting element touches the

hair ends.

C5Only cut the hair ends.The hairline should

be close to the ear.

ENGLISH 9

C6To contour the nape hairline and the

sideburns, turn the clipper and make

downward strokes.

7Move slowly and smoothly.

C8Just follow the natural hairline.

Cutting over styling comb or fingers

This technique can be used to obtain hair lengths

over 21 mm. Bear in mind that this technique is

difficult to master and should only be applied by

experienced users.

1Remove the comb attachment.

C2Comb a small section of hair upwards. Lift

the hair with a styling comb or hold it

between your fingers until only the length

that needs to be cut sticks out.

C3Cut the hair protruding from the comb or

fingers.

4Continue this procedure and comb

frequently to remove cut hair and to check

for unevenly cut sections.

ENGLISH10

Cleaning

Clean the appliance every time you have used it.

Do not use abrasives, scourers or liquids such as

alcohol, petrol or acetone to clean the appliance.

1Make sure the appliance is switched off

and disconnected from the mains before

you start cleaning it.

C2Remove the comb attachment.

C3Push the middle part of the cutting unit

upwards with your thumb until it opens

and then pull it off the appliance.

Be careful that the cutting unit does not fall to the

floor.

C4Clean the cutting unit and the inside of the

appliance with the brush supplied.

C5Place the lug of the cutting unit into the

slot and push the unit back onto the

appliance.

6Make sure you push the cutting unit back

until you hear a click.

ENGLISH 11

Replacement

A worn or damaged cutting unit should only be

replaced with an original Philips cutting unit.

C1Push the middle part of the cutting unit

upwards with your thumb until it opens

and then pull it off the appliance.

C2Place the lug of the cutting unit into the

slot and push the cutting unit back until

you hear a click.

Environment

The built-in rechargeable battery contains

substances which may pollute the environment.

Remove the rechargeable battery when you

discard the appliance.

Do not throw the battery away with the normal

household waste but hand it in at an official

collection point.

You can also take the appliance to a Philips

service centre, which will remove the battery for

you and will dispose of it in an environmentally

safe way.

1Disconnect the appliance from the mains

and let the appliance run until the motor

stops.

ENGLISH12

Otros manuales para HQC483

Tabla de contenidos

Idiomas:

Otros manuales de Recortadora de Philips

Philips

Philips HC3400/15 Manual de usuario

Philips

Philips NT2650 Manual de usuario

Philips

Philips Norelco Multigroom 3000 Manual de instrucciones

Philips

Philips NT5175 Manual de usuario

Philips

Philips BT3206 Manual de usuario

Philips

Philips NT3160/10 Manual de usuario

Philips

Philips MG3720/15 Manual de usuario

Philips

Philips Philishave NT100 Manual de usuario

Philips

Philips OneBlade QP2520 Manual de usuario

Philips

Philips Bikini Perfect HP6362/00 Manual de usuario

Philips

Philips MG7770 Manual de usuario

Philips

Philips TT2030 Manual de usuario

Philips

Philips Norelco QT4021 Manual de usuario

Philips

Philips QT4005 Manual de usuario

Philips

Philips MG3721 Manual de usuario

Philips

Philips SBT720 Manual de usuario

Philips

Philips NT1152/10 Manual de usuario

Philips

Philips Norelco MG3750 Manual de usuario

Philips

Philips NORELCO NT1605 Manual de usuario

Philips

Philips BT5203/15 Manual de usuario

Philips

Philips Bikini Perfect HP6390 Manual de usuario

Philips

Philips BG1025 Manual de usuario

Philips

Philips Bikini Perfect HP 6371 Manual de usuario

Philips

Philips Norelco T-7500 Manual de usuario

Manuales populares de Recortadora de otras marcas

MTD

MTD HT 51 E Manual de usuario

McCulloch

McCulloch T22 LS Manual de usuario

COCKRAFT

COCKRAFT PRO HL36-S Manual de usuario

Grizzly

Grizzly CT 1800 Li Manual de usuario

Peco

Peco Z Trimmer ZT-3000 Manual de usuario

Solo

Solo 116 Manual de usuario

Stiga

Stiga ST 1200 Manual de usuario

Echo

Echo GT-225 - 10-09 Manual de usuario

RedMax

RedMax BT17 Manual de usuario

GreenWorks

GreenWorks STA806 Manual de usuario

Parkside

Parkside PHSL 900 A3 Manual de usuario

Gardeo

Gardeo PRO GPTHT2560 Manual de usuario

Park

Park DT-810870 Manual de usuario

Worx

Worx WG209 Manual de usuario

Gardenline

Gardenline 43671/HTKS26 Manual de usuario

Makita

Makita 3710 Manual de usuario

Champion

Champion 100683 Manual de usuario

Stihl

Stihl FS 311 Manual de usuario